O n line U P S

Galleon II 1KVA/1.5KVA/2KVA/3KVA
• True double-conversion online UPS
• Wide input voltage range (110-300 VAC, 55-150 VAC)
• Input power factor correction 0.99
• Output power factor 0.9

U P S
• 50Hz/60Hz frequency converter mode
• Programmable power management outlets
• Emergency power off function (EPO)
• ECO mode operation for energy saving
• Very high surge immunity up to 7KV, 13KA, 1300J
• Generator compatible

O N L I N E
• High overload capability and enhanced short circuit protection
• SNMP/USB/RS-232 multiple communications
• 3-stage smart charging design
• Maximum 8A extended parallel control available for long run model
• Selectable output voltage: 200-240VAC, 100-127VAC
Galleon II 2K/3K Galleon II 1K/1.5K
• Laser printer and ultrasound system load acceptable

Galleon II Online UPS Selection Guide

MODEL Galleon II 1K (L) Galleon II 1.5K (L) Galleon II 2K (L) Galleon II 3K (L)
PHASE Single phase with ground
CAPACITY 1000 VA / 900 W 1500 VA / 1350 W 2000 VA / 1800 W 3000 VA / 2700 W
INPUT
Nominal Voltage 100/110/115/120/127 VAC or 200/208/220/230/240 VAC
55 - 150 VAC ± 5 % or 110 - 300 VAC ± 5 % at 50% load
Voltage Range
80 - 150 VAC ± 5 % or 160 - 300 VAC ± 5 % at 100% load
Frequency Range 40 Hz ~ 70 Hz
Power Factor ≧ 0.99 @ Nominal Voltage (100% Load)
≦ 5% @100~130VAC or 205-245VAC
THDi
THDU < 1.6% @ input and full linear load condition with battery fully charged
OUTPUT
Output Voltage 100/110/115/120/127 VAC or 200/208/220/230/240 VAC
AC Voltage Regulation (Batt. Mode) ± 1%
Frequency Range (Synchronized Range) 47~53 Hz or 57~63 Hz
Frequency Range (Batt. Mode) 50 Hz ± 0.1 Hz or 60Hz ± 0.1 Hz
Current Crest Ratio 3:1
Harmonic Distortion ≦2 % THD (Linear Load) ; ≦ 4 % THD (Non-linear Load)
Transfer AC Mode to Batt. Mode Zero
Time Inverter to Bypass 4 ms (Typical)
Waveform (Batt. Mode) Pure Sinewave
EFFICIENCY
AC Mode 90% 91%
ECO Mode 97%
Battery Mode 89% 89% 89% 90%
BATTERY
Battery Type 12 V / 7 Ah 12 V / 9 Ah 12 V / 7 Ah 12 V / 9 Ah 12 V / 7 Ah
Numbers 3 3 6 6 8
Standard
Typical Recharge Time 4 hours recover to 90% capacity
Model
Charging Current (max.) 1.5 A 1.2 A
Charging Voltage 41.0 VDC ± 1% 82.1 VDC ±1% 109.6 VDC ± 1%
Battery Type Depending on the capacity of external batteries
Numbers 3 3 6 6 8
Long-run
Model 1A/2A/4A/6A/A
Charging Current (max.) 1A/2A/4A/6A/8A (Selectable)
(Selectable)
Charging Voltage 41.0 VDC ± 1% 82.1 VDC ±1% 109.6 VDC ± 1%
INDICATORS
LCD Display UPS status, Load level, Battery level, Input/Output voltage, Discharge timer, and Fault conditions
ALARM
Battery Mode Sounding every 5 seconds
Low Battery Sounding every 2 seconds
Overload Sounding every second
Fault Continuously sounding
PHYSICAL
Standard Dimension, D x W x H (mm) 397 x 145 x 220 421 x 190 x 318
Model Net Weight (kgs) 12 13.8 22.5 26.6 32.2
Long-run Dimension, D x W x H (mm) 397 x 145 x 220 421 x 190 x 318
Model Net Weight (kgs) 6.3 6.5 10.5 11.7 11.7
ENVIRONMENT
Humidity 20-95 % RH @ 0- 40°C (Non-condensing)
Noise Level Less than 50dB @1Meter
MANAGEMENT
Smart RS-232/USB Supports Windows® 2000/2003/XP/Vista/2008, Windows® 7/8/10, Linux and MAC
Optional SNMP Power management from SNMP manager and web browser
*Derate capacity to 80% of capacity in Frequency converter mode and to 80% when the output voltage is adjusted to 100VAC, 200VAC or 208VAC.
Product specifications are subject to change without further notice.

Advancing Power 16
 O n lin e U P S

Galleon II Rackmount/Rack Tower 1KVA/1.5KVA/2KVA/3KVA

• True double-conversion
• Output power factor 0.9
U P S

• ECO and advanced ECO mode for energy saving

• Output voltage regulation < 1% 
• Higher output crest radio 3:1
• 50Hz/60Hz frequency converter mode
O N L I N E

• Programmable power management outlets

• Emergency power off function (EPO)  
(Rack tower
Option) • Hot swappable battery design

Galleon II Rackmount/Rack Tower Online UPS Selection Guide

MODEL Galleon II RM 1K (L) Galleon II RM 1.5K (L) Galleon II RM 2K (L) Galleon II RM 3K (L)
PHASE Single phase with ground
CAPACITY* 1000 VA / 900 W 1500 VA / 1350 W 2000 VA / 1800 W 3000 VA / 2700 W
INPUT
Nominal Voltage 100*/110*/115*/120 /127 VAC or 200/208/220/230/240 VAC
55-150 VAC ± 5% or 110-300 VAC ± 5% @ 50% load
Voltage Range
80-150 VAC ± 5% or 160-300 VAC ± 5% @ 100% load
Frequency Range 40 Hz ~ 70 Hz
Power Factor ≧ 0.99 @ nominal voltage (100% load)
THDi ≦ 5% @ nominal input voltage
OUTPUT
Output Voltage 100*/110*/115*/120/127 VAC or 200/208/220/230/240 VAC
AC Voltage Regulation (Batt. Mode) ± 1%
Frequency Range (Synchronized Range) 57 ~ 63 Hz or 47 ~ 53 Hz
Frequency Range (Batt. Mode) 60Hz ± 0.1Hz or 50 Hz ± 0.1Hz
Current Crest Ratio 3:1 (max.)
Harmonic Distortion ≦2 % THD (Linear Load) ; ≦ 4 % THD (Non-linear Load)
Transfer AC Mode to Batt. Mode Zero
Time Inverter to Bypass 4 ms (Typical)
Waveform (Batt. Mode) Pure Sinewave
EFFICIENCY
AC Mode 90% 90% 91% 91%
ECO Mode 97% 97% 97% 97%
Battery Mode 88% 89% 89% 88% 89% 90%
BATTERY
Battery Type 12 V / 9 Ah 12 V / 7 Ah 12 V / 9 Ah 12 V / 7 Ah 12 V / 7 Ah 12 V / 9 Ah
Numbers 2 3 3 4 6 6
Standard
Typical Recharge Time 4 hours recover to 90% capacity
Model
Charging Current (max.) 1.5 A**
Charging Voltage 27.4 VDC ± 1% 41.1 VDC ± 1% 41.1 VDC ± 1% 54.8 VDC ±1% 82.1 VDC ±1% 82.1 VDC ±1%
Battery Type Depending on the capacity of external batteries
Long-run Numbers 2 3 3 4 6 6
Model Charging Current (max.) 1A/2A/4A/8A (Selectable via LCD setting)
Charging Voltage 27.4 VDC ± 1% 41.1 VDC ± 1% 41.1 VDC ± 1% 54.8 VDC ±1% 82.1 VDC ±1% 82.1 VDC ±1%
INDICATORS
LCD Display UPS status, Load level, Battery level, Input/Output voltage, Discharge timer, and Fault conditions
ALARM
Battery Mode Sounding every 5 seconds
Low Battery Sounding every 2 seconds
Overload Sounding every second
Fault Continuously sounding
PHYSICAL
Standard Dimension, D x W x H (mm) 410 x 438 x 88 410 x 438 x 88 510 x 438 x 88 630 x 438 x 88 630 x 438 x 88
Model Net Weight (kgs) 11.6 14.2 14.5 19.5 26.9 27.4
Long-run Dimension, D x W x H (mm) 410 x 438 x 88 410 x 438 x 88 410 x 438 x 88 510 x 438 x 88
Model Net Weight (kgs) 6.4 6.5 6.5 10.5
ENVIRONMENT
Humidity 20-90 % RH @ 0- 40°C (non-condensing)
Noise Level Less than 50dB @ 1 Meter
MANAGEMENT
Smart RS-232/USB Supports Windows® 2000/2003/XP/Vista/2008/7/8/10, Linux and MAC
Optional SNMP Power management from SNMP manager and web browser
*Derate capacity to 95% when the output voltage is adjusted to 115VAC, derate capacity to 90% when the output voltage is adjusted to 110VAC and derate capacity to 80% when the output
voltage is adjusted to 100VAC/200VAC/208VAC.
**If standard UPS is equipped with additional charger, the available setting options become 2A, 3A and 4A.
Product specifications are subject to change without further notice.

17 www.voltronicpower.com