Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Center Off-Set Voltage 2. Bar Meter Sensitivity Adjustment ADJUSTMENT (Refer To Figs. 5, 6) (Refer To Figs. 5, 6)

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

VII.

AMPLIFIER ADJUSTMENT
AKAI AMU-04

1. CENTER OFF-SET VOLTAGE 2. BAR METER SENSITIVITY ADJUSTMENT


ADJUSTMENT (Refer to Figs. 5, 6) (Refer to Figs. 5, 6)
Connect the Digital Voltmeter or DC Voltmeter to The Meter Switch should be set to “x1”.
the Speaker terminal. Adjust the VR1 (1 kB) on the Connect a load resistor (RL: 8 ohms) to the Speaker
Main Amp P.C Board, so that the Voltmeter reading terminal, and input 1 kHz through the AUX terminal.
is 0 ±10mV. Adjust the VR2 (2 kB) on the Main Amp P.C Board
until the voltage at both ends of the load resistor is
10.95 V (AC voltmeter) where the Power Meter
indicate 15 watts.

10
VIII. CLASSIFICATION OF VARIOUS P.C BOARDS
AKAI AMU-04

1. P.C BOARD TITLES AND IDENTIFICATION NUMBERS

P.C Board title P.C Board Number

Main Amp P.C Board AMU-4001 A

Push Switch P.C Board AMU-4001 B

LED P.C Board (B) AMU-4001C

Selector P.C Board AMU-4002

Tone Control P.C Board AMU-4003

Pin Jack P.C Board AMU-4005

Fuse P.C Board (U/T) AMU-4006

Fuse P.C Board (CSA, AAL) AMU-4058

Fuse P.C Board (JPN) AMU-4060

Fuse P.C Board (CEE, UK, SAA) AMU-4059

LED P.C Board (A) AMU-4007

Slide Volume P.C Board AMU-4008

Loudness P.C Board AMU-2003

Bar Meter P.C Board AMU-2006

Chart-1

11

You might also like