Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Käänteinen - Reversible Rib Cap

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

Käänteinen - Reversible Rib Cap

This rib cap was inspired by Rocky movies. The main character has a black cap on when running. I too needed
to knit a cap, thin but warming and suitable for sensitive skin. This cap has a wide folding edge, which you can
set as you like. The simple crown decreases form a cross on one side. Right and wrong side are different and
both can be used as the outside. This cap is reversible and foldable, just the way you like to!

Size: One size fits from child to adult.


Diameter unstretched about 40 cm, stretches to well over 70cm.

Yarn: Sandnes Lanett (100 % merino, 50 g / 195 m) 100 g in graphite gray for finer
cap
La Alpaca (100% alpaca, 50 g, Nm 3/8) 100 g in orange for thicker cap

Needles: 2 mm for finer cap


2,5 mm for thicker cap

Tension: 31 sts and 42 rows to 10 cm square in stockinette stitch for finer cap
26 sts and 35 rows to 10 cm square in slightly stretched k 3, p 2 rib for thicker cap

• Samples are knit in magic loop with one 80 cm long circular needle. There are instructions
for two yarn qualities, a finer and a thicker one. First figure is for finer yarn, and latter is
for thicker yarn. If there’s only one figure in the instructions, it applies for both sizes.

• It’s important that you knit decreases in same way and at same places all the time for the
decrease pattern to form correctly. The center stitch of decreasing stays at the same column
of stitches all the time. You can use st markers to help.
• The ribbing in the cap knit in finer yarn will not go even at the end of round. There will be
a column of four consecutive knit sts at the changing of round spot. If you are particular
about your ribbing and still want to follow the pattern, please knit in the size for thicker
yarn, as the ribbing goes even in it.

Cast on 172 - 160 sts. Knit in round in k 3, p 2 rib for 22 cm.

Start decreasing: *K 40 - 37, make centered double decrease: sl 2 knitwise together, k


1, pass slipped sts over. Repeat from * three more times for a round.

Next row: Continue in pattern, knit sts at decreases as they come (knit the knit sts
and purl the purled ones).

Decrease every other row until there’s 16 – about 16 sts between two decrease points.
Then decrease on every row till you have 4 – 4 to 8 sts left. Keep the decreases at the
same place, as shown on the chart below. This way they don’t start swirling.

Exemplary chart on decreasing in Reversile Rib Cap

▲= centered double decrease

white square = st in pattern

grey square has no meaning


K 1, pass all sts over, pull the yarn doubled and cut it so that you can sew it in.
Sew in ends carefully and make them unnoticeable. Block and dry.
Fold the edge as you please and wear the cap with either side out.

This pattern is for personal, non-commercial use only. Not to be distributed commercially without a permission.
distantknitter.blogspot.com 2009

You might also like