Gizmos+ +refraction+ (Shivani) +
Gizmos+ +refraction+ (Shivani) +
Gizmos+ +refraction+ (Shivani) +
1. What would most likely happen if one of the runners began jogging in knee-deep water?
The runner would become slower compared to the one who is not.
Depending on where the person in water is, it would change direction to the person who is
slower because they cover less distance.
Gizmo Warm-up
Light can travel through many materials, or media. As with a
runner on pavement or sand, the speed of light can change
when it moves into a different medium. The Refraction
Gizmo allows you to observe what happens to a beam of
light as it travels from one medium to another.
1. Click Play ( ). Observe the ray of light as it passes from Medium 1 to Medium 2.
2. Click Reset ( ) and turn on View wave fronts. A wave front is an imaginary line that
connects the crests or troughs of a wave. The wavelength of a wave is the distance
between wave fronts.
Click Play. What happens to the wavelength of the wave as it passes into Medium 2?
2019
Get the Gizmo ready:
Activity A: Click Reset. Turn off View wave fronts.
Make sure View normal is selected.
Angle of
Make sure Index of refraction 1 is 1.0 and Angle
refraction
of incidence is 45°.
Set Index of refraction 2 to 2.0.
Introduction: The normal is an imaginary line perpendicular to the boundary between two
media. The angle of incidence is the angle between the light ray in medium 1 and the normal.
The angle of refraction is the angle between the ray in medium 2 and the normal.
2. Gather data: For each angle of incidence listed in the table below, use the Gizmo to find the
angle of refraction. Then, fill in the “Change of direction” column by subtracting the angle of
refraction from the angle of incidence.
One pattern I noticed is that the more the angle of incidence increases, the large change in
direction. Another is that the change in direction is usually bigger that the angle of refraction. As
well, the angle of refraction was closer to the normal and smaller versus the angle of incidence.
4. Explain: Do you think refraction would occur if the angle of incidence is 0°? Explain.
No, I don’t think refraction would occur if the angle of incidence is 0° (or if it does, the ray
would be considered as 0°). I believe this because the ray is going straight through the
normal so there wouldn’t be any change of speed considering the fact that it is just going
perpendicular to the normal line. It would just go straight.
2019
Activity A (continued from previous page)
5. Predict: The index of refraction indicates how fast light can travel through a medium. The
higher the index is for a medium, the slower light will travel through that medium. How do
you think increasing a medium’s index of refraction might affect the angle of refraction?
Increasing the medium’s index of refraction affects the angle of refraction because it will change
the direction of the light reflecting. The more index there is of the medium, the less the angle
would reflect, and the more it would stay closer to the normal line. This would slow down the
speed of the light traveling.
6. Gather data: Keep the Index of refraction 1 set to 1.0. Set the Angle of incidence to 60°.
For each Index of refraction 2 listed in the table below, use the Gizmo to find the angle of
refraction and the change in direction.
One pattern I noticed would be that as the index of refraction increases, the change in direction
also increases. I also noticed that as the index of refraction increases, the angle of refraction
decreases. As well, when the angle of incident hit the index of reflection, the speed of the light
was much more slower than before. Finally, I noticed that as the angle of refraction decreases,
the of change in direction increases.
8. Explain: Why does no refraction occur when the media have the same index of refraction?
This is because there is no longer any medium for the light on refract on. Having the Index of
Refraction set on 1 for the second medium means that both mediums are the same so there is
no longer any reason for the light to change speed or refract.
9. Explore: Set the Index of refraction 2 to 1.0. Set the Angle of incidence to 25°. Collect
data for each Index of refraction 1 listed in the table below.
10. Analyze: What did you notice about the change in direction in the first two trials?
2019
A couple of things I noticed is that they both are being refracted however the change in
direction is different. I also noticed that the angle of refraction was bigger than the angle of
With the third trial, instead of it being refracted, it is being reflected because the second
medium is less dense than the first medium making it do the opposite effect. As well, since the
angle of reflection was greater than 90°, it reflected back, creating the total internal reflection.
When the angle of refraction is greater than 90°, the beam of light will reflect off of the
surface instead of refracting through the surface. This is called total internal reflection.
2019