Rotary Screw Compressor Units: Service Parts List
Rotary Screw Compressor Units: Service Parts List
Rotary Screw Compressor Units: Service Parts List
The Unit Data Plate listing model/serial number etc., is normally located to the left of the microproces-
sor, attached to the frame below the compressor motor.
NOTE: PLEASE PROVIDE FRICK ORDER NUMBER, UNIT MODEL NUMBER, AND UNIT SERIAL NUMBER
WHEN REQUESTING A QUOTATION, PLACING AN ORDER, OR REQUESTING TECHNICAL ASSISTANCE.
FAILURE TO INCLUDE THIS INFORMATION MAY DELAY PROCESSING OF YOUR REQUEST.
TABLE OF CONTENTS
Figure 1. General Arrangement, Typical. ..................................... 4
Figure 2. Screw Compressor, Typical .......................................... 6
Figure 3. Vertical Oil Separator, Typical. ...................................... 8
Figure 4. Oil Filter, Vertical or Horizontal, Standard. ................. 10
Figure 5. Oil Filter, Horizontal, Typical. ...................................... 11
Figure 6. Piping and Instrumentation, Typical. .......................... 12
Figure 7. Prelube Oil Pump Piping, Typical. .............................. 14
Figure 8. Oil Cooler Piping, Typical. .......................................... 18
Figure 9. Full-Lube/Full-Cycling Oil Pump Piping, Typical. ......... 20
Figure 10. Liquid Injection Piping, Typical. ................................. 24
Figure 11. 14" Multivalve, Frick. ................................................ 28
Figure 12. 14" Multivalve, Hansen/Frick. ................................... 30
Figure 13. 12 X 14" Multivalve, Frick. ........................................ 32
Figure 14. 8" Discharge Stop/Check Valve, Frick. ..................... 34
Figure 15. 8" Discharge Stop/Check Valve, Gram. .................... 36
Figure 16. Drive Coupling, Standard. ........................................ 38
Figure 17. Drive Coupling, Optional. ......................................... 39
Figure 18. Drive Coupling, with Clamping Hubs. ....................... 40
Figure 19. Transducer Manifold Assembly. ................................ 42
Figure 20. Economizer. ............................................................. 43
Figure 21. Microprocessor Control Center (Single Box). ........... 44
Figure 22. Quantum Control Center. ......................................... 46
Figure 23. 355 Compressor Ports ............................................. 48
FRICK FLANGE GASKETS ...................................................... 49
FRICK BLUE PAINT .................................................................. 49
FRICK COMPRESSOR OILS ................................................... 49
MISCELLANEOUS TUBING AND CONNECTORS ................... 50
NUMERICAL PARTS LIST ........................................................ 51
Note:
This list is based on one unit. When stocking for more than one unit, the quantity should be adjusted to
meet your individual requirements.
* For 240V/60Hz, use Valve 951A0056H41, and Coil 951A0056H42. Seal Kit 951A0056H34 is universal.
S70-210 SPL RWB II VERTICAL ROTARY SCREW COMPRESSOR UNIT
Page 4 SERVICE PARTS LIST
11
4, 7, 8
10
9 RWBVERTSEP
—2 947A0003H05 Sightglass 3
10"
NOTE DIFFERENCES
IN HEAD DESIGNS
VERSION A*
VERSION B*
* Do not replace 50 GPM elements with 35 GPM elements. Frick part numbers are stamped on each filter element.
S70-210 SPL RWB II VERTICAL ROTARY SCREW COMPRESSOR UNIT
Page 12 SERVICE PARTS LIST
* Part Numbers for Pump, Motor, Coupling and Bypass Valve were not available at time of printing.
RWB II VERTICAL ROTARY SCREW COMPRESSOR UNIT S70-210 SPL
SERVICE PARTS LIST Page 17
Figure 8a. Oil Cooler Piping, with Oil Temperature Regulating Valves.
Figure 8b. Oil Cooler Piping, with Water Temperature Regulating Valve.
* Part Numbers for Pump, Motor, Coupling and Bypass Valve were not available at time of printing.
RWB II VERTICAL ROTARY SCREW COMPRESSOR UNIT S70-210 SPL
SERVICE PARTS LIST Page 23
*Solenoid Valve, Strainer and Pressure Regulator are determined by which TX Valve is used. For proper ordering of Liquid Injection
components, refer to Thermal Expansion Valve nameplate for size and model designations.
S70-210 SPL RWB II VERTICAL ROTARY SCREW COMPRESSOR UNIT
Page 26 SERVICE PARTS LIST
*Solenoid Valve, Strainer and Pressure Regulator are determined by which TX Valve is used. For proper ordering of Liquid Injection
components, refer to Thermal Expansion Valve nameplate for size and model designations.
RWB II VERTICAL ROTARY SCREW COMPRESSOR UNIT S70-210 SPL
SERVICE PARTS LIST Page 27
25
6
9
8
26
15
7
27, 28
24
23
5
14
10
1
16
2
27, 28
26
7
25
6
9
8
10
16
3
21
11
22
12
20
13, 29
17,18,19
4
14— 581C0065G01 8" Discharge Stop/Check Valve, High Stage Application, R-717 Ref. C
581C0065G02 8" Discharge Stop/Check Valve, High Stage Application, R-22 Ref. C
581C0141G01 8" Discharge Stop/Check Valve, Booster Application, R-717 Ref. A
581C0141G02 8" Discharge Stop/Check Valve, Booster Application, R-22 Ref. A
—1 581C0110G05 Body, Valve, 8" 1
—2 581D0047C01 Bonnet, Check Valve 1
—3 581D0032C01 Bonnet, Stop Valve 1
—4 581C0042H01 Stem, Stop Valve 1
—5 581B0100H01 Shaft, Sliding Button 1
—6 581C0043C01 Button, High Stage Application 2
581C0139C01 Button, Booster Application (Check Valve only) 1
—7 580A0109H01 Spring 2
—8 580A0192H01 Pin, Button 16
—9 580A0108H01 Ring, Retaining 2
—10 980A0014H80 O-ring, Bonnet 2
—11 581A0012H01 Seal, Backseat 1
—12 959A0055H07 Ring, Packing, Split 2
—13 581B0045H01 Nut, Packing 1
—14 581A0027H02 Ring, Packing, Split 1
—15 581B0080H01 Guide Bushing, Sliding Button 1
980A0012B43 O-ring, Booster Application 1
—16 111Q0110603 Capscrew, Hex Head 16
—17 581B0001H05 Handwheel 1
—18 581A0011H03 Washer, Spring 1
—19 581A0010H04 Capscrew, Hex Head 1
—20 581C0001H05 Seal Cap 1
—21 580A0275H04 Gasket, Seal Cap 1
—22 959A0056H07 Ring, Packing, Center 1
—23 580A0219H04 Spacer, Check Valve 1
—24 111Q0019539 Spring, Return, High Stage Application 1
—25 581A0040H03 Button, Seal 2
—26 581A0014H01 Plate, Retaining 2
—27 901A0043E03 Capscrew, Hex Head 10
—28 111Q0940012 Lockwasher 10
—29 580A0183H07 Washer, Packing 1
10" Arrangement, not shown:
956A0016H08 Valve, Discharge, Check, Gulf/Stockham, 10" WIL* 1
581E0010G01 Valve, Discharge, Stop, Angle, 10" WIL, Ammonia 1
581E0010G02 Valve, Discharge, Stop, Angle, 10" WIL, Halocarbon 1
111Q0110535 Capscrew, Hex Head, 3/8 x 1" 6
111Q0940012 Washer, Lock, 3/8" 6
111Q0940052 Washer, 1/2" (Ammonia) 1
580A0275H05 Gasket, Seal Cap (Halocarbon) 1
581A0001H04 Bearing, Ball 16
581A0011H03 Washer, Spring, 1/2 x 1" 2
581A0017H01 Plate, Retaining 1
581A0020H01 Seal, Backseat 1
581A0040H04 Seal, Button 1
581A0044H01 Ring, Retaining 1
581A0046H01 Ring, Bushing, End 2
581B0001H06 Wheel, Hand (or: Seal Cap 581C00580H01) 1
581B0003H06 Clip, Retaining 1
581B0009H01 Stem 1
581B0054H01 Nut, Packing 1
581C0028H01 Bracket, Lift 1
581C0072G01 Disk 1
581C0074G01 Bonnet 1
901A0045D03 Capscrew, Hex Head, 1/2 x 1" 1
901A0046D05 Capscrew, Hex Head, 5/8 x 2" 12
959A0076H01 Ring, Center Packing 1
980A0014K29 O-ring 2-452 1
* Also: 956A0015H06 Discharge Check Valve, Mission, 10" WIL. No parts breakdown available for these two check valves.
S70-210 SPL RWB II VERTICAL ROTARY SCREW COMPRESSOR UNIT
Page 36 SERVICE PARTS LIST
—6 Gasket, Top 1
—7 U-sleeve, PTFE 1
—8 O-ring 1
535D0344
1 2
ECONMIZER
4,5,6
2,3
26
41 39 40 13,14,15 1 24
38
21
25
22
20
7,8
27
9
34 28,29,30,31,32,33
35,36 18,19,37 16,17,23
24
10,11,12 RWB2-2