Putty: Water Base Exterior Wall Putty

WATER BASE EXTERIOR WALL PUTTY
PUTTY eX 1
PRODUCT INFORMATION
PUTTY eX 1 by Kansai is a premium grade, high performance exterior putty that is

DESCRIPTION
designed to apply on rough or damaged ceilings and walls, to smooth out cross-
hatching on dry wall or fill deep scratches or holes.
Designed as a putty for use on new or previously painted exterior masonry surfaces
PURPOSE OF USE
such as brickwork, plaster, cement rendering, and asbestos cement.
COMPONENTS, COMPOSITION Cement (31-33%), Mineral powder (64-66%), Additives (0.4-0.6%), Resin (1.8-2.1%).
 Compliance to CONQUAS 21.

 No sanding required.
 Environmental friendly.
PERFORMANCE
 Hazardous-less.
 Good coverage.
Easy application.

 Coverage*: 1.0 – 1.2 m2/kg / 2 coats.
PHYSICAL PROPERTIES
 Thickness: 2 – 3 mm / 2 coats.
 Flash Point: Not applicable.
 Density: 0.96 kg/liter.
 Color: White.
FINISHING  Finish: Matt Finish.
 Pack Size: 40 kg.
QUALIFICATION CERTIFICATE
INTERNATIONAL CERTIFICATE Green Label Singapore
NATIONAL TECHNICAL REGULATION TCVN 7239:2014
INSTRUCTION FOR USE
New, unpainted surfaces
AAllow surfaces to cure and dry out at least 28 days. Large cracks must be repaired with cement. Make good all
minor defects with appropriate exterior grade fillers. Remove all loosely adhering residues by thorough
brushing.
SURFACE PREPARATION Repainting
Check for fungus and algae growth. If present, treat the surfaces with fungicidal wash by brushing on the
surface with bleach mix (1 part household bleach with 3 parts water). Allow the mixture to penetrate the
affected surface. Make good all defects with appropriate patching materials. When dry, remove all fungi, algae,
chalk, loosely adhering contaminants by using high-pressure water-jetting.
1/2
WATER BASE EXTERIOR WALL PUTTY
PUTTY eX 1
 Drying time
Surface dry: 1-2 hours, Hard dry: 24 hours, Recoat: 1-2 hours.
APPLICATION Drying time are dependent on the thickness apply, temperature, and humidity.
 Dilution: Clean household water.
 Cleaning Up: Clean household water.
EQUIPMENT GUIDE  Construction trowel.
DILUTION RATIO  Mix and stir homogeneously with 1 part of clean water with 2.5 parts of PUTTY eX 1.
New, unpainted surfaces and repainting:
1st 2nd
Recoat Recoat
PUTTY eX 1 PUTTY eX 1
1-2 hours 24 hours
RECOMMENDED PAINT SYSTEM
3rd 4th & 5th
SEALER S
Recoat Kansai Exterior Recoat
SEALER eX 1
1-2 hours Products 1-2 hours
SEALER eX 3
Limitations:
- Not suitable for use on newly plastered walls that are not fully cured. PUTTY eX 1 works best on surfaces with a
moisture content of below 15% and alkalinity below pH-9 or otherwise premature paint failure may occur.
- Do not apply on the surface at temperatures of 40°C or higher.
SAFETY AND HEALTH WARNING INFORMATION
 Ensure adequate lighting and ventilation during application and drying.

 This product does not contain added lead or mercury.
SAFETY AND HEALTH WARNING  When applying paints, it is advisable to wear eye protection.
INFORMATION  In case of contact with eyes, rinse immediately with plenty of water and seek medical assistance.
 Use soap and water to remove splashes from skin.
 Storage: Keep container closed and store in clean, dry conditions.
 Do not empty into drains or water courses.
 This product is not flammable. Keep out of reach of children.
 Safety Data Sheet (SDS) is available upon request.
* Practical coverage will vary according to the roughness and porosity of surface to be applied, the application method and condition, dry film thickness and the skill of
applicator.
The information in this technical data sheet is given to the best of our knowledge based on laboratory testing and practical experience and is provided as a general advice
only. No guarantee of results is implied since the conditions of use are beyond our control. It is the responsibility of the users to ensure the suitability and proper usage of the
product. We reserve the right to change the data without prior notice.
For further information, please kindly contact:

Kansai - Alphanam Paint Co., Ltd.
Address: Pho Noi A Industrial Zone, Trung Trac, Van Lam, Hung Yen, Vietnam
Hotline: 0933.44.7979
Tel: (+84.221) 3980 456 Fax: (+84.221) 3980 455
Revision : 01
12/2018
2/2

Putty: Water Base Exterior Wall Putty

Uploaded by

Copyright:

Available Formats

Putty: Water Base Exterior Wall Putty

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Putty: Water Base Exterior Wall Putty

Uploaded by

Copyright:

Available Formats

WATER BASE EXTERIOR WALL PUTTY

PUTTY eX 1 by Kansai is a premium grade, high performance exterior putty that is

 Compliance to CONQUAS 21.

INTERNATIONAL CERTIFICATE Green Label Singapore

NATIONAL TECHNICAL REGULATION TCVN 7239:2014

INSTRUCTION FOR USE

New, unpainted surfaces

SURFACE PREPARATION Repainting

EQUIPMENT GUIDE  Construction trowel.

New, unpainted surfaces and repainting:

3rd 4th & 5th

SAFETY AND HEALTH WARNING INFORMATION

 Ensure adequate lighting and ventilation during application and drying.

For further information, please kindly contact:

You might also like