Carboguard 893 SG Part B MSDS
Carboguard 893 SG Part B MSDS
Carboguard 893 SG Part B MSDS
2. Hazard Identification
Symbol(s) of Product
Signal Word
Danger
Page 1 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
HAZARD STATEMENTS
3. Composition/Information On Ingredients
3.2 Mixtures
Hazardous Ingredients
CAS-No. Chemical Name %
14808-60-7 MICROCRYSTALLINE SILICA 50 - <75
108-38-3 META-XYLENE 2.5 - <10
68953-36-6 TOFA, REACTION PRODUCTS WITH TEPA 2.5 - <10
106-42-3 PARA-XYLENE 2.5 - <10
100-41-4 ETHYL BENZENE 2.5 - <10
64742-95-6 AROMATIC HYDROCARBON 2.5 - <10
67-63-0 ISOPROPANOL 2.5 - <10
64-17-5 ETHYL ALCOHOL 2.5 - <10
95-47-6 ORTHO-XYLENE 2.5 - <10
Page 2 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
67-63-0 GHS02-GHS07 H225-319-336 0
64-17-5 GHS02 H225 0
95-47-6 GHS02-GHS07 H312-315-332 0
Remarks: CASStatement
Additional Information: The text for GHS Hazard Statements shown above (if any) is given in Section 16.
4. First-aid Measures
4.1 Description of First Aid Measures
AFTER INHALATION: Give oxygen or artificial respiration if needed. Remove person to fresh air. If signs/symptoms
continue, get medical attention.
AFTER SKIN CONTACT: In case of contact, immediately flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. If skin irritation persists, call a physician.
AFTER EYE CONTACT: Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.
AFTER INGESTION: Do NOT induce vomiting. Never give anything by mouth to an unconscious person. If swallowed, call
a poison control centre or doctor immediately.
4.2 Most important symptoms and effects, both acute and delayed
Harmful if swallowed. Irritating to eyes and skin. Risk of serious damage to the lungs (by aspiration). Vapours may cause
drowsiness and dizziness.
4.3 Indication of any immediate medical attention and special treatment needed
No information available on clinical testing and medical monitoring. Specific toxicological information on substances, if
available, can be found in section 11.
When symptoms persist or in all cases of doubt seek medical advice.
5. Fire-fighting Measures
5.1 Extinguishing Media:
Carbon Dioxide, Dry Chemical, Foam, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: Flammable liquid. Vapours are heavier than air and may spread along
floors. Vapours may form explosive mixtures with air. Vapors may travel to areas away from work site before igniting/flashing
back to vapor source. Provide adequate ventilation. Prevent the creation of flammable or explosive concentrations of vapour
in air and avoid vapour concentration higher than the occupational exposure limits. Keep away from heat/sparks/open
flames/hot surfaces. - No smoking. Electrical installations / working materials must comply with the technological safety
standards. Wear shoes with conductive soles.
Do not allow material to contaminate ground water system. Prevent product from entering drains.
6.3 Methods and material for containment and cleaning up
Prevent further leakage or spillage if safe to do so. Contain spillage, soak up with non-combustible absorbent material, (e.g.
sand, earth, diatomaceous earth, vermiculite) and transfer to a container for disposal according to local / national regulations
(see section 13).
Page 3 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
Please refer to disposal requirements or country specific disposal requirements for this material. See Section 13 for further
information.
INSTRUCTIONS FOR SAFE HANDLING : Keep containers dry and tightly closed to avoid moisture absorption and
contamination. Prepare the working solution as given on the label(s) and/or the user instructions. Do not breathe vapours or
spray mist. Ensure all equipment is electrically grounded before beginning transfer operations. Do not use sparking tools.
Do not get in eyes, on skin, or on clothing. Use only with adequate ventilation/personal protection. Wash thoroughly after
handling.
PROTECTION AND HYGIENE MEASURES : Handle in accordance with good industrial hygiene and safety practice. Wash
hands before breaks and at the end of workday. When using, do not eat, drink or smoke.
Page 4 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
FURTHER INFORMATION: Refer to the regulatory exposure limits for the workforce enforced in each country.
Personal Protection
RESPIRATORY PROTECTION: In order to avoid inhalation of spray-mist and sanding dust, all spraying and sanding must
be done wearing adequate respirator. Use only with ventilation to keep levels below exposure guidelines reported in this
document. User should test and monitor exposure levels to ensure all personnel are below guidelines. If not sure, or not able
to monitor, use State or federally approved supplied air respirator. For silica containing coatings in a liquid state, and/or if no
exposure limits are established above, air-supplied respirators are generally not required.
EYE PROTECTION: Safety glasses with side-shields.
HAND PROTECTION: Gloves should be discarded and replaced if there is any indication of degradation or chemical
breakthrough. Impervious gloves. Request information on glove permeation properties from the glove supplier. Lightweight
protective clothing
OTHER PROTECTIVE EQUIPMENT: Ensure that eyewash stations and safety showers are close to the workstation location.
ENGINEERING CONTROLS: Avoid contact with skin, eyes and clothing. Ensure adequate ventilation, especially in confined
areas.
Odor Solvent
pH N/D
Melting point / freezing point (°C) N/D
Boiling point/range 149 F (65 C) - 500 F (260 C)
Flash Point 75F (24C)
Evaporation rate Slower than Ether
Page 5 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
Irritation: Unknown
Carcinogenicity: Category 1A
Mutagenicity: Unknown
If no information is available above under Acute Toxicity then the acute effects of this product have not been tested.
Data on individual components are tabulated below:
Chemical Name Oral LD50 Dermal LD50 Vapor LC50 Gas LC50 Dust/Mist
CAS-No.
LC50
14808-60-7 MICROCRYSTALLINE SILICA 22500 mg/kg Not Available Not Available 0.000 0.000
108-38-3 META-XYLENE Not Available Not Available Not Available 0.000 0.000
Page 6 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
106-42-3 PARA-XYLENE Not Available Not Available Not Available 0.000 0.000
95-47-6 ORTHO-XYLENE Not Available Not Available Not Available 0.000 0.000
Additional Information:
This product may contain Ethyl Benzene, which is listed by IARC as possibly carcinogenic to humans (Group 2B). This listing is
based on inadequate evidence of carcinogenicity in humans and sufficient evidence in experimental animals.
12.5 Results of PBT and vPvB The product does not meet the criteria for PBT/VPvB in accordance with Annex XIII.
assessment:
Page 7 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
13.1 WASTE TREATMENT METHODS: Do not burn, or use a cutting torch on, the empty drum. If recycling is not practicable,
dispose of in compliance with local regulations. Dispose of in accordance with local regulations. Empty containers should be
taken to an approved waste handling site for recycling or disposal.
This product contains the following chemical substances subject to the reporting requirements of TSCA 12(B) if exported from
the United States:
The following materials are non-hazardous, but are among the top five components in this product.
The following non-hazardous ingredients are present in the product at greater than 3%.
Page 8 / 9
Date Printed: 04/15/2020 Product: 1000B1NL
The information contained herein is, to the best of our knowledge and belief accurate. However,
since the conditions of handling and use are beyond our control, we make no guarantee of results,
and assume no liability for damages incurred by use of this material. It is the responsibility of
the user to comply with all applicable federal, state, and local laws and regulations.
Page 9 / 9