Runout Tollerances
Runout Tollerances
Runout Tollerances
Runout tolerances, shaft and flange concentricity & axial eccentricity are according to IEC 60072
Measurement of Shaft to Flange Face Runout Tolerance
Standard N Optional R
Shaft Diameter (normal) (reduced)
Dial Gauge mm mm
up to 10 0.030 0.015
over 10 to 18 0.035 0.016
over 18 to 30 0.040 0.021
over 30 to 50 0.050 0.025
over 50 to 80 0.060 0.030
over 80 to 120 0.070 0.035
D
Concentricity and axial eccentricity tolerance of the flange face to the shaft axis (referred to the flange spigot)
10±1
10±1
Standard N Optional R
Flange Spigot
(normal) (reduced)
Diameter (b1)
mm mm
up to 22 0.050 0.025
over 22 to 40 0.060 0.030
over 40 to 100 0.080 0.040
over 100 to 230 0.100 0.050
over 230 to 450 0.125 0.063
over 450 to 800 0.160 0.080
over 800 to 1400 0.200 0.100
over 1400 to 2000 0.250 0.125
over 2000 to 2240 0.315 0.160
www.welkon.net