WATER /AIR COOLED CHILLER PM

CHECKLIST

ArabiaHolding

ARAMCO TICKET NO. : EQPM’T NUMBER:

SERVICE DATE: SERVICE LOCATION:

----------
NOTE: 1) PLEASE INSPECT INTERNAL AND MOVING PARTS.

2) CLEAN AND REPAIR AS REQUIRED.

3) CHECK INCOMING VOLTAGE AND CHECK VOLTAGE AND

WIRING BETWEEN DISCONNECT SWITCH AND TERMINAL BLOCK
UNIT DATA
--------- ____________________________________________
COMP. MODEL # |COMP. # 1| COMP. # 2| COMP. # 3| COMP. # 4|
|---------|----------|----------|----------|
|_________|__________|__________|__________|
COND. FAN MOTOR
--------------- ____________________________________
|_________|__1__|__2__|__3__|__4__|__5__|__6__|__7__|__8__|

|VOLTAGE |_____|_____|_____|_____|_____|_____|_____|_____|
|AMPS. |_____|_____|_____|_____|_____|_____|_____|_____|
|H.P. |_____|_____|_____|_____|_____|_____|_____|_____|
|RPM/SPEED _____|_____|_____|_____|_____|_____|_____|_____|
|FRAME # |_____|_____|_____|_____|_____|_____|_____|_____|
|PHASE |_____|_____|_____|_____|_____|_____|_____|_____|
|MANUFAC. |_____ |_____|_____|_____|_____|_____|_____|_____|
|MODEL | | | | | | | | |

-----------------------------------------------------------
DISCONNECT/BREAKER P.M. (BY DUMD) WORK ORDER
--------------------------------------------
SECTION II
----------
DISCONNECT POWER SWITCH BREAKER -------------------------------
1. CHECK INTERNAL BREAKER. YES____ REMARKS___________

2. CHECK FOR RUST & PAINT IF REQUIRED. YES____ REMARKS___________

3. CHECK ARK OF DISCONNECT SWITCH. YES____ REMARKS___________

4. REPORT BAD CONDITION. YES____ REMARKS___________

COMPRESSOR

Arabian Fal Company Page 1

 1. CHECK ACTUAL VOLTAGE: L1________L2________L3________

2. CHECK COMP. CIRCUIT #1: DISC. PRESS____PSI, SUC. PRESS____PSI

3. CHECK COMP. CIRCUIT #2: DISC. PRESS____PSI, SUC. PRESS____PSI

4. COMP. ACTUAL AMP. COMP. # 1 : L1_______L2______L3______

COMP. # 2 : L1_______L2______L3______

COMP. # 3 : L1_______L2______L3______

COMP. # 4 : L1_______L2______L3______

5. TAKE ACID TEST: YES_____IF YES RESULT________ REMARKS___________

6. CHECK COMPRESSOR OIL LEVEL. YES____ ADD_______________

7. CHECK COMP. NOISE/VIBRATION. YES____ REMARKS___________

8. CHECK COMP. HOLDING BOLTS & MOUNTING. YES____ REMARKS___________

9. CHECK UNLOADER. YES____ REMARKS___________

10. CHECK COMP. TERMINAL BOX/JUNCTION BOX. YES____ REMARKS___________

11. CHECK COMP. CRANKCASE HEATER. YES____ REMARKS___________

----------
CONDENSER
---------
1. CHECK MOTOR COND. LUBRICATION. YES____ REMARKS___________

2. STRAIGHTEN COND. FINS (WITH SPL. TOOLS) YES____ REMARKS___________

3. CLEAN COIL WITH WATER _________STEAM_________ CHEMICAL__________

4. CHECK FAN BLADE GUARD BOLTS. YES____ REMARKS___________

5. HECK HOLDING BRACKET BOLTS. YES____ REMARKS___________

6. CHECK PULLEY FOR ALIGNMENT. YES____ REMARKS___________

7. GREASE/OIL BEARINGS. YES____ REMARKS___________

SECTION V
---------
ELECTRICAL CONTROL BOX
----------------------
1. CLEAN CONTROL BOX. YES____ REMARKS___________

2. TIGHTEN ALL LOOSE WIRE CONNECTIONS. YES____ REMARKS___________

Arabian Fal Company Page 2

3. REPLACE BURNT OUT WIRE(S). YES____ REMARKS___________

4. CHECK FOR JUMPER/TIMER. YES____ REMARKS___________

5. CHECK INDICATOR LAMPS. YES____ REMARKS___________

6. CHECK ALL CONTROL POINTS/CLEAN

IF REQUIRED. YES____ REMARKS___________

7. CHECK STEP CONTROLLER. YES____ REMARKS___________

8. SEAL ELECTRIC PANEL FRAME WITH

WEATHER STRIP (TO BE DUST SEALED). YES____ REMARKS___________

INSTRUMENTATION

1. CHECK OIL PRESSURE CONTROL. YES____ REMARKS___________

2. CHECK ANTI FREEZE CONTROL. YES____ REMARKS___________

3. CHECK LOW PRESSURE SWITCH. YES____ REMARKS___________

4. CHECK HIGH PRESSURE SWITCH. YES____ REMARKS___________

5. CHECK WATER FLOW SWITCH. YES____ REMARKS___________

6. CHECK EXP. VALVE/BULB LOCATION. YES____ REMARKS___________

7. CHECK FILTER DRIER (CORE). YES____ REMARKS___________

8. CHECK INLET AND OUTLET AIR (TEMP.) ACROSS THE COND. COIL.

YES: _____ TEMP. IN______F TEMP. OUT_____F

9. CHECK WATER INLET & OUTLET TEMP. ACROSS THE CHILLER.

YES: _____ TEMP. IN______F TEMP. OUT_____F

10. CHECK WATER PRESS. INLET & OUTLET.

PRESS. IN________PSIG PRESS. OUT________PSIG

SECTION VII
-----------
MISCELLANEOUS
-------------
1. SECURE ALL COVERS/SCREWS. YES____ REMARKS___________

2. CLEAN WATER STRAINER/SCREEN. YES____ REMARKS___________

3. STOP ALL WATER LEAKS. YES____ REMARKS___________

Arabian Fal Company Page 3

4. CHECK FOR GAS/OIL LEAK (IN UNIT). YES____ REMARKS___________

5. CHECK/REPLACE ALL PRESS. GUAGE/

THERMOMETER FOR CORRECT OPERATION. YES____ REMARKS___________

6. CHECK CHILLED WATER PIPE INSULATION. YES____ REMARKS___________

7. CHECK WATER TANK MAKE-UP SYSTEM

(LEVEL, LEAKS AND GUAGES). YES____ REMARKS___________

8. CHECK ALL VALVES FOR CORRECT OPERATION

AND LUBRICATE TO PROTECT VALVE SYSTEM. YES____ REMARKS___________

------------
HOUSEKEEPING
------------

1. CLEAN AND REMOVE ALL MESS THINGS

AROUND THE UNIT/AREA. YES____ REMARKS___________

2. ADVISE UNIT FOREMAN IF FURTHER WORK

S REQUIRED. YES____ REMARKS___________

JOB COMPLETED: YES________ NO________

REMARKS: ________________________________________________________________
_________________________________________________________________________
_________________________________________________________________________

CREW BADGE NO.________________________________________________________

----------------

Arabian Fal Company Page 4