Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Darling Pretest

Download as pdf or txt
Download as pdf or txt
You are on page 1of 12

Darling MB pretest

 TE Team
 December, 2021
Equipment Driver and program
• Power cord • Teraterm
• Ethernet cable • CP210 driver
• HDMI device (Roku, appleTV, Mibox,etc)
• HDMI 4k cable
• 3.5mm aux cable
• Micro USB cable
• USB type C
Step 1.
Install Teraterm and CP210 in the test PC

Step 2.
Connect power cord, Ethernet cable, HDMI cable, 3.5mm cable and Micro USB cable.
Step 3.
Once the unit is turn On, perform speaker test touching speaker button and after touch the forth buttons
to check each speaker. Then touch home button to back to the initial menu. (Here you test the
functionality of home button)
Step 4.
Then open teraterm and select CP210 Standard port.
Step 5.
Go to setup, then Serial port.
Step 6.
Baud rate must be 115200 and Flow control hardware.
Step 7.
Press enter to can see the connection
Login: admin
Password: No password, just press enter.
Step 8. Line out connection
Use command diagnostic-run Use again with the cable disconnect to
audio_line_out_plug to detect if the verify if is not detected anymore.
3.5mm aux cable is connected.
Step 9. NVIDIA cooling
Use command d-r --debug mech_cooling_cm max_slope=0.017 to check the measurement of the NVIDIA
component.

NOTE: This measurement is with heatsink and thermal paste (WMX limit is 0.0170)
Step 10. HDMI connection
Use command diagnostic-run video_loop src=hdmi_in1 dst=lcd cmd=start to get signal from HDMI device.
Thank you!

You might also like