Irles - Rectangular Footing
Irles - Rectangular Footing
Irles - Rectangular Footing
INTRODUCTION
f fa %(x, y) dx dy = N . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (la)
f r o
y%(x, y) dx dy = Ney . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (lc)
N xNex yNey
................................. (2)
Xx, y) +T +
where A = ab; Ix = ab3/12; and Iy = ba3/12.
Eq. (2) fails when, for bigger eccentricities, a part of footing a r e a , d o e s n ' t
stand fully on the soil, as it can be d e t e c t e d from Fig. 2 (Teng 1962). Fig.
2 shows, in several footing regions, the d e t a c h e d corners (1, 2, 3, or 4) for
a given eccentricity (ex, ey), independently of N. F o r this reason, it can be
said that (1) is no longer linear and difficulties, which do not apply to
monoaxial bending, arise in its resolution. The general resolution of non-
linear system (1) has been solved up to now in the following ways:
~Prof., Dept. of Civ. Engrg., Univ. of Alicante, Ap. Correos 99, E-03080, Ali-
cante, Spain.
2Assoc. Prof., Dept. of Civ. Engrg., Univ. of Alicante, Ap. Correos 99, E-03080,
Alicante, Spain.
Note. Discussion open until July 1, 1994. To extend the closing date one month,
a written request must be filed with the ASCE Manager of Journals. The manuscript
for this technical note was submitted for review and possible publication on April
20, 1992. This technical note is part of the Journal of GeotechnicalEngineering, Vol.
120, No. 2, February, 1994. 9 ISSN 0733-9410/94/0002-0444/$1.00 + $.15
per page. Technical note No. 3916.
444
0"2
~:~-~:~:.::!::!:~!~i:i:~.:lN::i::i::!::!:;:::!:"-iS"!:":::-::::;Ao
~.``~!:~:~:!:i~: ~E;:!:~i:`~:i: i`:`;`~;i: !: : :~: : ~:-~::`:~e~-~.
~ ~-~.g~:~: :/-~:~: ~:~J
%
"I/
FIG. 1. Stresses under Rectangular Footing with Biaxial Bending
| I |
a/4 1-2-4
,+, J 1-3-4
~_
a/4 Y
3-4 ey
a/4
,,/4 t -2 -3 2-3-4
| I_,,/, _..L,/,_..l@
x ~ex
FIG. 2. Detached Corners for Resultant N, with Eccentricities (e~., ey), in Each
Footing Region
DERIVATION
Due to the fact that the problem is symmetric, it will be enough to consider
just one quadrant.
445
Three Corners Detached (2, 3, and 4)
With Fig. 3 notation, (1) results in
N = al3crl
6 ................................................. (3a)
N = ~ 1 - , ................................ (5a)
b/ N I
4
!
,, NI/ b
only 13 depending.
Being IX = 2 - ( 4 e y / b ) and B = 13/b, then
a = 4B - ex 84 -- (8 -- ]_)4
( ~ ) ab2cr3
N er + = ~ (613 - 12a13 + 8a + az133) . . . . . . . . . . . . . . . . (9b)
6A - (A + 4)v . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (14)
u = u(v) = v (3A - 2 - v 2)
_
B3B2
_ _ + ~B__~ ...................................... (20b)
q= Bl
2 8
3B 4 B2B2 B3B 1
r = B~ - 2 - ~ + 16 4 .............................. (20c)
pZ _ 4r p2
p, - m ........................................ (21a)
16 12
q' p3 (p2 -- 4r) q2
= 108 P 96 64 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (21b)
+ = _ . ........................................... (22i0
-q'
e = arcos-- . .......................................... (22b)
2+
for i = 1, 2, 3 . . . . . . . . . (23)
B3
......................... (24a)
4
4 ........................... (24b)
93
v, = s(xC - vg~ + v~;) - -4
- ........................... (24d)
449
recalling (12) for choosing the correct root, and (15) and (16) to calculate
and 13.
Now, from (9a) and from stresses plane, respectively
2Na13
0" 3 ............................ (25a)
ab(e~+ 13 - 2al3 + - ~ )
0-1 = 0-3
,
+ 13
,) ..................................... (25b)
o (1 1) .........................................
APPENDIX. REFERENCES
Hackman, M. (1977). "Bearing pressures on bridge footings." Cir. Engrg., (11),
37-39.
Hardin, B. O. (1984). "Pressure under eccentrically loaded footings." Civil engi-
neeringfor practicingand designengineers,Vol. 3, Pergamon Press, Inc., Elmsford,
N.Y.
Peck, R. B., Hanson, W. E., and Thornburn, T. H. (1974). Foundationengineering.
2nd Ed., John Wiley and Sons, New York, N.Y.
Teng, W. C. (1962). Foundation design. Prentice-Hall, Inc., Englewood Cliffs, N.J.
Vitone, D. M. A., and Valsangkar, A. J. (1986). "Rectangular foundations subjected
to biaxial bending." Civil engineeringfor practicing and design engineers, 5,799-
814.
450