Multiple Choice Questions For Electronics Engineering Part 1
Multiple Choice Questions For Electronics Engineering Part 1
Multiple Choice Questions For Electronics Engineering Part 1
1. amplifier power
2. amplifier signal
Answer: 4
Answer: 2,4
1. 0.886
2. 0.75
3. 0.51
4. 0.65
Answer: 2
Q. 4 AT-T connection has higher ratio of utilization that n a V – V connection only when
Answer: 4
1. 1 %
2. 5 %
3. 20 %
4. 50 %
Answer: 1
1. Rectifier
2. Voltage divider
3. Filter
4. Regulator
Answer: 4
4. Voltage quadrupler
Answer: 3
Answer: 1,3
1. 00 to 3F
2. 00 to FF
3. 0 to 3
2 of 4
4/15/22, 6:08 AM Multiple Choice Questions for Electronics Engineering Part 1- Examrace
4. 0 to F
Answer: 1
1. 4 bit
2. 8 bit
3. 16 bit
4. 32 bit
Answer: 2
1. Load resistor RL
3. Ac alpha
Answer: 4
Answer: 3
Answer: 4
Q. 14 To turn a UJT ON, the forward bias on emitter diode should be:
Answer: 1
1. The base resister method does not provide stabilization of operating point
3. Base resistor method provides better stabilization than collector feedback method
4. Voltage divider bias is widely used because it has stable operating point
Answer: 3
Answer: 2
Q. 17 In class-A amplifies conduction extends over 360 because the operating point.
Answer: 4
Answer: 1
4 of 4