Operating Manual - PDS Configuration Tool
Operating Manual - PDS Configuration Tool
Operating Manual - PDS Configuration Tool
Operating Manual
HemoCue PDS Configuration Tool
Preface
This manual provides information on how to install and use the HemoCue PDS Configuration Tool.
Disclaimer
Do not: modify, translate, reverse engineer, decompile or create derivative works based on the
HemoCue PDS Configuration Tool.
Purpose
The PDS Configuration Tool is provided by HemoCue for configuration of IP address settings in
primary docking stations. The tool is downloadable in a zip file via the web.
System Requirements
Windows 10 (64-bit versions). Internet connection needed if the necessary version of .NET not
installed on the PC.
Installation
1. Make sure you are logged in as a local administrator on the computer where you intend to
install the software.
2. Extract the zip file to a known location.
3. Open the location where the zip file was extracted.
4. Extract the zip file containing the setup files to a known location.
5. Double-click the setup file.
6. Read the EULA and click “I Agree” to continue.
12. Select installation folder and whether to install the software for everyone or just you. Press
Next to continue.
13. The following screen is displayed:
8. Press OK to continue.
9. The new configuration is now stored and the docking station can be disconnected.
Troubleshooting
In rare cases timing issues with the USB driver have been observed. If any error messages are shown:
disconnect the docking station, restart the software and reconnect the docking station.
HemoCue AB | Kuvettgatan 1 | SE-262 71 Ängelholm | Sweden
901038 191212