E-ECU, Control Unit Engine Warning: Language Code Product Group No. Date Applies To
E-ECU, Control Unit Engine Warning: Language Code Product Group No. Date Applies To
E-ECU, Control Unit Engine Warning: Language Code Product Group No. Date Applies To
Version Date
GB EXC 366 25 3 11/08/2006
Applies to
EC135B LC Volvo, EC140B LC Volvo, EC140B LCM Volvo, EW140B Volvo
This Service Bulletin is to be considered as technical information only and is not subject to any reimbursement programs outside
normal warranty.
Cause
Unable to program E-ECU through VCADS Pro.
Action
1. Developed new E-ECU software which can be programed through VCADS Pro.
2. Added one communication line (J1587) in wire harness of crawler machines (EC135B & EC140B).
NOTE!
In wheeled machine (EW140B), additional communication line has been existing from the beginning in all machines. See below
for more detail instructions.
In EC140B model manufactured in Germany, E-ECU with new software had been applied exceptionally in some machines before
all old E-ECUs were used up because engines were not supplied to the production line as per the serial numbers. This is the
reason we have separate machine serial numbers in the above table.
Part number
Instruction
1. The part number of E-ECU has not been changed because this is a matter of software and electric circuit in the machine.
2. For the crawler machines (EC135B & EC140B) which were produced before the above serial numbers, fully pre-
programed E-ECU should be ordered because the communication line doesn't exist in the machine and then it cannot
be programed. When ordering fully pre-programed E-ECU, machine serial number and engine serial number should be
provided together.
3. But for the crawler machines after the above improvement, E-ECU equipped only with base software (we used to call it
“empty” E-ECU but it has actually base software in it to run dataset software) can be ordered and programed through
VCADS Pro.
4. For the wheeled machines (EW140B) which were produced before the above serial numbers, fully pre-programed E-ECU
should be ordered because the software is an old version which cannot be loaded by VCADS Pro and this is the reason
why we cannot program E-ECU even while wheeled machine has the communication line from day one. Also when
ordering fully pre-programed E-ECU, machine serial number and engine serial number should be provided together.
5. For the wheeled machines after the above improvement, E-ECU equipped only with base software (so called, “empty” E-
ECU) can be ordered and programed through VCADS Pro.
6. Programming procedures are explained from next page.
E-ECU reprogramming through the EMR dataset file download function in VCADS Pro instruction
NOTE!
Before going to the machine, please make sure that a battery of VCADS Pro computer is fully charged. We STRONGLY
recommend that you have the computer connected to a power source through out the uploading of the software. Loss of power
during uploading can result in E-ECU damage.
Figure 1
2. Select [File]-[Identify]
3. Choose [EC135B,EC140B,EW140B] and press [OK].
Figure 2
Figure 4
Figure 5
¡ User name :VCADS Pro User ID or other ID for TSC main site login.
¡ Password : Digipass generated or special TSC main site static password.
9. Choose [ EMR2 ]
Figure 7
Figure 8
Figure 10
Figure 11
Figure 13
Figure 14