Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

JAR / EASA Part 66 Revision Questions

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

JAR / EASA part 66 revision questions

1. The cycle of a gas turbine engine is


a) completed in one revolution of engine.
b) completed in two revolution of the engine.
c) continuous

2. Engines having two independent moving systems are


a) compound engines
b) twin spool engines
c) complex engines

3. Compression ratio of compressor of gas turbine Engine is


a) outlet pressure to Inlet pressure.
b) measured across all rotor stages of compressor
c) mass of airflow to combustion.

4. Torque pressure indication to measure power output of an engine is


a) used in all Gas Turbine engines.
b) not used in Gas Turbine engines.
c) only used when engine output pressure is used for torque not for thrust.

5. Manifold pressure is measured in


a) direct absolute pressure in Bars
b) differential pressure in mill bars
c) direct absolute pressure in inch of Hg

6. Typically a torque pressure indication system is


a) differential pressure type
b) remote synchronous type
c) direct Oil Pressure sensing type

7. A tachometer used to measure Rev/Min in turbine engines


a) develops its own power for the system
b) 28V dc is required
c) 115V ac is required

8. Primary power for electronic engine control


a) 115V ac essential bus.
b) on side 115V ac bus bar supply.
c) Permanent Magnet Alternator

9. Leads to measure thermocouple temperature are


a) calibrated for circuit in used and cannot be shortened
b) affected by Magnetic and electrical interference
c) insulated by heat legging device to reduce errors in the indication end
10. A thermocouple sensing system test set requires
a) a serviceable battery
b) No power
c) 24V dc

Question 1
The correct answer is c The Brayton cycle is a continuous cycle -A major advantage over the
Otto Cycle (Piston
Engine)
Question 2
The coned answer is b The 2 spools are known as LP Spool and HP spool
Question 3
The correct answer is a Rolls Royce The Jet Engine Page 25 refers
Question 4
The correct answer is c Torque is used to measure power in turbo prop aircraft
Question 5
The correct answer is c EHJ Pallet Aircraft Instruments and Integrated Systems page 355
Question 6
The correct answer is c EHJ Pallet Aircraft Instruments and Integrated Systems page 357
Question 7
The correct answer is a It develops an alternating current proportional to the speed of the engine
Question 8
The correct answer is c Driven by The Engine's High Speed external Gearbox", it provides a
discrete power supply
for the engine
Question 9
The correct answer is a A&P Power plant Handbook EA-AC-65-12A page 494(4} refers
Question 10
The correct answer is a A&P Powerplant Handbook EA-AC-65-12A page 494 refers

You might also like