Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
66 views

Service Design Lab Student's Manual 10

The document provides instructions for an electrical load calculation lab experiment. Students are tasked with calculating the total load for a building's 4th floor using an attached load calculation sheet. The objectives are to understand industrial load calculations. A report and discussion are required.

Uploaded by

Carry Gaming
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
66 views

Service Design Lab Student's Manual 10

The document provides instructions for an electrical load calculation lab experiment. Students are tasked with calculating the total load for a building's 4th floor using an attached load calculation sheet. The objectives are to understand industrial load calculations. A report and discussion are required.

Uploaded by

Carry Gaming
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Experiment 10 Lab Student’s Manual

American International University- Bangladesh


Department of Electrical and Electronic Engineering
EEE 4208: Electrical Service Design Lab

Title: Open Ended Lab

Introduction: After completing this experiment, student should be able to

 Understand industrial load calculations

Task: Find the total amount of load for D building 4 th Floor. For the calculation purpose see the attached file
with this lab manual.

Report: Fill up the Load Calculation Sheet.


Discussion:
Make discussion about the problems you have find during calculation.
Conclusion:
Summarize the experiment here and discuss whether the objectives were fulfilled or not within a short
paragraph.
References:
 Handbook of Electrical Design Details (Handbook) 2nd Edition by Neil Sclater (Author), John E.
Traister (Author)

Hints:
1
© Dept. of EEE, Faculty of Engineering, American International University-Bangladesh (AIUB)
Experiment 10 Lab Student’s Manual

ELECTRICAL LOAD CALCULATION: (OPTIONAL METHOD)

Purpose:

To illustrate the method for sizing an electrical service.

Contractor _______________________________ Address _

BNBC Section: 220:82

General light, power SF x 3 volt-amperes = volt-amperes


Two kitchen appliance circuits @ 1,500 volt-amperes = 3,000 volt-amperes
Laundry circuits = 1,500 volt-amperes
Electric range (NP rating) = _ volt-amperes
Wall mounted oven (NP rating) = _ volt-amperes
Water heater (NP rating) = _ volt-amperes
Dishwasher (NP rating) = _ volt-amperes
Disposal (NP rating) = _ volt-amperes
Dryer (NP rating) = _ volt-amperes
Other _ = _ volt-amperes

Subtotal volt-amperes

Subtotal volt-amperes
10,000 volt-amperes (First 10 kilo volt-amperes @ 100%) = 10,000 volt-amperes
Difference volt-amperes (Remaining volt-amperes x 40%) = _ _volt-amperes

Heating and Air-Conditioning (The Largest of the following shall be included):

1. Air conditioning and cooling (100% NP rating) = _volt-amperes

2. Heat pump without supplemental heating (100% NP rating) = _volt-amperes

3. Heat pump with supplemental electric heating (100% NP rating plus 65%) = _volt-amperes

4. Electrical space heating < 4 separate units (65% NP rating) = _volt-amperes

5. Electrical space heating ≥ 4 separate units (40% NP rating) = _volt-amperes

6. Electrical thermal storage and other (100% NP rating) = _volt-amperes

Total _ volt-amperes

Total volt-amperes  240 volts =


(amps size for service entrance conductors and panel)

2
© Dept. of EEE, Faculty of Engineering, American International University-Bangladesh (AIUB)

You might also like