R2V2PX310R

8-port sector antenna, 4x 694–960 and 4x 1710–2690 MHz, 65°

HPBW, 4x RET with manual override.
Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical tilt
with manual override on all arrays
All Internal RET actuators are connected in “Cascaded SRET” configuration

OBSOLETE
This product was discontinued on: December 31, 2018
Replaced By:
8P-4L4M-D4 8-port sector antenna, 4x 694–960 and 4x 1695–2 690 MHz, 65° HPBW, 4x RET

RRVV-65D-R4 8-port sector antenna, 4x 694–960 and 4x 1695–2 690 MHz, 65° HPBW, 4x RET

RRVV-65D-R4-MR 8-port sector antenna, 4x 694–960 and 4x 1695–2 690 MHz, 65° HPBW, 4x RET

RRVV-65D-R4-V2 8-port sector antenna, 4x 694–960 and 4x 1695–2 690 MHz, 65° HPBW, 4x RET, includes retractable tilt
rods

RRZ4-65D-R6 12-port sector antenna, 4x 694–960 and 8x 1427–2 690 MHz, 65° HPBW, 6x RET

RRZZ-65D-R4 8-port sector antenna, 4x 694–960 and 4x 1427–2 690 MHz, 65° HPBW, 4x RET

General Specifications
Antenna Type Sector

Band Multiband

Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket

Performance Note Outdoor usage

RF Connector Interface 7-16 DIN Female

RF Connector Location Bottom

RF Connector Quantity, high band 4

RF Connector Quantity, low band 4

RF Connector Quantity, total 8

Remote Electrical Tilt (RET) Information, General

RET Interface 8-pin DIN Female    |   8-pin DIN Male

RET Interface, quantity 2 female    |   2 male

Page 1 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 30, 2020
R2V2PX310R
Dimensions
Width 641 mm   |   25.236 in

Length 2490 mm   |   98.032 in

Depth 244 mm   |   9.606 in

Electrical Specifications
Operating Frequency Band 1710 – 2690 MHz    |   694 – 960 MHz

Remote Electrical Tilt (RET) Information, Electrical

Protocol 3GPP/AISG 2.0 (Single RET)

Power Consumption, idle state, maximum 2W

Power Consumption, normal conditions, maximum 13 W

Input Voltage 10–30 Vdc

Internal RET High band (2)    |   Low band (2)

Electrical Specifications
Frequency Band, MHz 694–790 790–890 890–960 1710–1920 1920–2170 2300–2690
Gain, dBi 15.9 16.4 16.7 16.1 17.3 17.7
Beamwidth, Horizontal, 64.4 62.1 59 61.4 58.3 58.4
degrees
Beamwidth, Vertical, degrees 10.2 8.9 8.1 8.4 7.4 5.9
Beam Tilt, degrees 0–10 0–10 0–10 0–10 0–10 0–10
USLS (First Lobe), dB 16 16 15 18 18 18
Front-to-Back Ratio at 180°, 32 33 32 31 32 35
dB
CPR at Boresight, dB 15 21 20 22 20 10
CPR at Sector, dB 10 13 12 13 10 4
Isolation, Cross Polarization, 25 25 25 25 25 25
dB
Isolation, Inter-band, dB 28 30 30 27 28 30
VSWR | Return loss, dB 1.43 | 15.0 1.43 | 15.0 1.43 | 15.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0

PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150
Input Power per Port, 300 300 300 250 250 250
maximum, watts

Electrical Specifications, BASTA

Frequency Band, MHz 694–790 790–890 890–960 1710–1920 1920–2170 2300–2690
Page 2 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 30, 2020
R2V2PX310R
Gain by all Beam Tilts, 15.5 16.1 16.3 15.9 16.9 17.7
average, dBi
Gain by all Beam Tilts ±0.5 ±0.3 ±0.3 ±0.6 ±0.5 ±0.6
Tolerance, dB
Gain by Beam Tilt, average, 0 ° | 15.5 0 ° | 16.1 0 ° | 16.4 0 ° | 15.9 0 ° | 17.0 0 ° | 17.7
dBi 5 ° | 15.5 5 ° | 16.0 5 ° | 16.3 5 ° | 15.9 5 ° | 16.9 5 ° | 17.7
10 ° | 15.5 10 ° | 16.1 10 ° | 16.3 10 ° | 16.0 10 ° | 16.7 10 ° | 17.6

Beamwidth, Horizontal ±2.3 ±2.3 ±2.4 ±2.8 ±2.6 ±4.8

Tolerance, degrees
Beamwidth, Vertical ±0.7 ±0.5 ±0.3 ±0.6 ±0.6 ±0.6
Tolerance, degrees
USLS, beampeak to 20° 16 16 15 18 19 19
above beampeak, dB
Front-to-Back Total Power at 26 27 25 29 30 30
180° ± 30°, dB
CPR at Boresight, dB 16 23 20 26 20 12
CPR at Sector, dB 10 13 10 14 11 4

Material Specifications
Radiator Material Brass    |   Low loss circuit board

Radome Material ASA, UV stabilized

Reflector Material Aluminum

Mechanical Specifications
Wind Loading at Velocity, frontal 2,008.0 N @ 150 km/h    |   45.4 lbf @ 150 km/h

Wind Loading at Velocity, lateral 103.1 lbf @ 150 km/h    |   460.0 N @ 150 km/h

Wind Speed, maximum 250 km/h   |   155.343 mph

Packaging and Weights

Width, packed 719 mm   |   28.307 in

Depth, packed 363 mm   |   14.291 in

Length, packed 2677 mm   |   105.394 in

Net Weight, without mounting kit 60 kg   |   132.277 lb

Weight, gross 90 kg   |   198.416 lb

Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Above maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system

Page 3 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 30, 2020
R2V2PX310R
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant/Exempted

Included Products
ATCB-B01-C50 — AISG RET Control Cable, 0.5 m
T-029-GL-E — Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" (60-115mm) OD round members for panel antennas. Includes 2 clamp sets.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 4 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 30, 2020