HS Procem CFA

CONSTRUCTION CHEMICALS
HS ProCem CFA
Scope Hardening accelerating admixture
ProCem CFA is ready to use, a liquid non-chloride hardening accelerator formulated to increase the
early strength of concrete without affecting the initial workability.
Conforms to: IS 9103-99 ; ASTM C 494/C494M- 11 Type C

Uses and
Advantages
For high early strength concrete : ProCem CFA is used to produce excellent results in normal and
hot weather conditions where very high early strengths are required .
Benefits
• Early stripping and re-use of forms
• Faster finishing operations on flatwork surfaces
• Earlier post-tensioning
• Effective with Type I/II/III cements
For Precast Concrete :
HS ProCem-CFA delivers excellent results for precast concrete when high early strengths are required
. Curing times are significantly reduced while concrete quality is improved .
Benefits
• Use as a replacement of steam curing to save energy costs .
• Increase early strengths and allow faster rotation of moulds to increase production per day .
• Use as a replacement to Type III cement
Cold Weather concreting
HS ProCem – CFA is an effective hardening accelerator where high early strength concrete is desired
and the use of Calcium Chloride is prohibited .
Benefits
• Insulation and heating costs for curing time can be reduced
• Earlier stripping and reuse of forms increases labor productivity
• Accelerated strength gain allows earlier structural use and speeds completion time .
HS ProCem-CFA does not contain Calcium Chloride or any other intentionally added chlorides and
will not initiate or promote the corrosion of reinforcing steel present in concrete. Placing concrete in
freezing conditions :
HS ProCem-CFA when used at recommended dosage rates , may reduce the need for cold weather
concreting practices as laid out in ACI 306 .
Good concreting practices should always be followed for best result at an optimal dosage rates .
To improve cohesion and workability of concrete mixes where poorly graded aggregates must be used
and bleeding, segregation or sand runs occur.
Product Composition Organic & Inorganic salt solution

Data Specific Gravity approx. 1.15 at 30oC
pH >7
Chloride NIL as per IS:456
Appearance Transparent to pale yellow liquid
Packing 200 Ltrs HDPE Barrel, 1000 Ltrs TOTE
Storage Life Upto twelve months as long as the sealed containers are kept in a cool dry
place (10 to 350C) and in original unopened contaniers.
Dosage Contact Berger Concrete Technologist for support and technical assistance
guidelines HS ProCem-CFA should be used @ 0.6 – 2.0 % by weight of cement to promote high early
strengths . Berger recommends that trial mix should always be carried out to determine the right
dosage.
Mixing & Mixing :

dispension Add correct amount of HS ProCem-CFA at the concrete plant or into ready mix truck at the job site .
The admixture may be added manually or by automated dispenser directly into the sand or into the
water line at the batch plant .When used in combination with other admixtures care must be taken to
dispense each admixture separately into the mix . Do not mix with dry cement .
Use with other admixtures :
HS ProCem –CFA performs well in combination with other admixtures such as non retarding
water reducers, high range water reducers and air entraining agents . Do not mix HS ProCem-CFA
with expansion agents or shrinkage compensating agents .
Dispensing :
HS ProCem-CFA is added directly to the mixing water , prior to it’s addition to the aggregates .
Increased air contents, generally have a detrimental effect on strengths . This can be adequately
catered for by using HS Pro superPlast or HS Pro hyper plast admixture . Please refer to our
Technical ServicesDepartment .
Safety Accidental splashes onto skin must be washed off with water and soap. In contact with eyes or mucous
guidelines membrane, rinse with clean warm water and seek medical attention without any further delay.
Do not dispose of into water or soil, but it is advisable to do it as per local regulations.
Non-toxic under the relevant local health & safety codes.
Refer SDS- Safety Data Sheet for detailed information

DISCLAIMER The information contained within this Data Sheet is based on information believed to be reliable at the time of its
preparation. The Company will not be liable for loss or damage howsoever caused including liability for negligence, which may
be suffered by the user of the data contained herein. It is the users' responsibility to conduct all necessary tests to confirm the
suitability of any product or system for their intended use. No guarantee of results is implied since conditions of use are
beyond our control.
BERGER PAINTS INDIA LIMITED

Berger House, 129 Park Street, Kolkata - 700017.
Phone : (033) 2229 9724 (5 lines)/2249 9754 (4 lines)
protectonhelpdesk@bergerindia.com | www.bergerpaints.com

HS Procem CFA

Uploaded by

Copyright:

Available Formats

HS Procem CFA

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

HS Procem CFA

Uploaded by

Copyright:

Available Formats

CONSTRUCTION CHEMICALS

Conforms to: IS 9103-99 ; ASTM C 494/C494M- 11 Type C

Product Composition Organic & Inorganic salt solution

Mixing & Mixing :

Refer SDS- Safety Data Sheet for detailed information

BERGER PAINTS INDIA LIMITED

You might also like