Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Berol 226 - PDS EN PDF

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

$N]R1REHO

6XUIDFH&KHPLVWU\

Berol 226
Berol 226 is an optimized surfactant blend intended for use in water based alkaline and acid
cleaners.

Specifications Parameter Limits Method


Colour Gardner max 7 AB-46-1201
Functional test min 40°C AB-46-1873
pH, 1% in water 5-8 AB-46-1206

Typical Data Chemical and Physical data Typical values


Active content 100%
Appearance, 20°C clear/slight opalescent liquid
Clear point -7°C
Density, 20°C 1010 kg/m³
Flash point >100°C
Pour point -10°C
Viscosity, 20°C 80 mPa s

Surface active characteristics Typical values


Foam height according to Ross-Miles, 50°C, 0.05% immediately: 130 mm after 5 min: 110 mm
Surface tension according to Du Noüy, 25°C, 0.1% DIN 27 mN/m
53914
Wetting power according to Draves, 25°C, 0.1% 15 sec

Solubility
The solubility of Berol 226 is as follows:
2-propanol soluble
Ethanol soluble
Low aromatic solvent insoluble
Propylene glycol soluble
Water soluble
White spirit insoluble
Xylene dispersible
Typical data are based on our own measurements or derived from the literature. They do not constitute part of
the delivery specifications.

Storage & If Berol 226 has been stored below its clear point, it should be homogenized before use, unless the entire quantity is
used.
Handling

BEROL® is a registered trademark in many countries.

Version: 1.3 Issued: 22 Nov 2010


All information concerning this product and/or all suggestions for handling and use contained herein are offered in good faith and are believed to be reliable.
Akzo Nobel Surface Chemistry AB, however, makes no warranty as to the accuracy and/or sufficiency of such information and/or suggestions, as to the
product's merchantability or fitness for any particular purpose, or that any suggested use will not infringe any patent. Nothing contained herein shall be
construed as granting or extending any license under any patent. Buyer must determine for himself, by preliminary tests or otherwise, the suitability of this
product for his purposes. This information contained herein supersedes all previously issued bulletins on the subject matter covered.
Akzo Nobel Surface Chemistry AB, S-444 85 Stenungsund, Sweden
http://www.akzonobel.com/sc

You might also like