Preguntas MTCRE
Preguntas MTCRE
Preguntas MTCRE
What is the proper name in OSPF terminology for a router that redistributes routes from
RIP to OSPF?
A. Designated router
B. External router
C. Area border router
D. Autonomous system boundary router
A. Broadcast
B. UDP
C. Multicast
D. TCP
E. ICMP
1. The 'check-gateway' option is enabled for one route. Select all statements
that are true
A. Gateway is checked every 10 seconds and after a single failure, the Gateway is
considered unreacheable
B. Gateway is checked every 10 seconds and after 2 failures, the
gateway is considered unreacheable
C. Check gateway option can be configured for Ping, ARP and RARP
(reverse ARP)
D. In case of failure of the gateway, routes pointing to that gateway will
become inactive
A. 5.5.5.5
B. 5.6.6.6
C. the required route is not in the routing table
D. both - half of the traffic will be routed through one gateway, half through the other
10. Mark all correct ECMP routes:
A. /ip route add dst-addr=0.0.0.0/0 gateway=10.10.10.1,10.10.10.1
B. /ip route add dst-addr=0.0.0.0/0 gateway=10.10.10.1,10.20.20.1
C. /ip route add dst-addr=0.0.0.0/0 gateway=10.10.10.1
D. /ip route add dst-addr=0.0.0.0/0 gateway=10.10.10.1,10.10.10.1,10.20.20.1
A. 192.168.0.3
B. 192.168.0.2
C. 192.168.0.4
D. 192.168.0.1
When sending out an ARP request, an IP host is expecting what kind of address for an
answer?
A. 802.11g
B. VLAN ID
C. MAC Address
D. IP address
13. For a user (one entry) in local PPP Secrets/PPP Profiles database, it is possible to:
14. Which of the following conditions have to be fulfilled for two routers on one
ethernet segment to become ospf neighbors?
17. When using routing option 'check-gateway=ping' what is the ICMP echo request
interval (in seconds)?
A. 10s
B. 20s
C. 30s
D. 60s
18. What conditions listed below are required to set up an EoIP Tunnel?
A. both routers must have different "MAC addresses"
B. works only between Mikrotik routers
C. both routers must be have the same "MAC address"
D. both routers must have different "Tunnel ID" values
E. both routers must have the same "Tunnel ID"
19. Consider the following diagram. Assuming that all the necessary configuration has
already been done on R2 (proxy-arp is disabled), to communicate from a device on
LAN1 to a device on LAN2, which of the following configurations on R1
would enable this?
Which Gateway will be used for a packet with destination address 10.1.5.126?
A. 25.1.1.1
B. 10.1.5.126
C. 10.1.1.1
D. 10.1.1.2
22. If 'check-gateway' option is enabled on one route it Will affect all routes with the
same gateway:
1. TRUE
2. FALSE
23. In OSPF network it is possible to use area-id=0.0.0.0 for non backbone area
1. TRUE
2. FALSE