Heavy-duty roller bearings support high

shaft loads and provide long life.

Dual release ports allow easier bleeding of

brake release cavity.

Oil-filled cavity immerses all components

providing quiet operation and reduced wear.
BK
Holding Torque .......................... 10,000 lb-in
Release Pressure ............................. 400 psi
Maximum release pressure ........... 3,000 psi
Release volume ........................... 0.7 cu. in.
FEATURES

Max. Speed ..................................... 250 rpm

Max. Operating Temperature ............. 180°F
Weight ................................................ 37 lbs
Fluid Type .......................... Mineral based oil
SUPERIOR DESIGN FOR RELIABLE OPERATION
With safety becoming an increasingly important factor in the design and manufacture of equipment, it has become
necessary to add a brake to many critical machine functions. In response to that concern, White Hydraulics offers the
BK10 Series brake. Based on technology proven in White Hydraulics integrated motor/brakes, this spring-applied,
hydraulically released brake provides 10,000 lb-in of holding torque for static brake applications.

Other features contribute to the superior operation and durability of the brake. All internal components, including
roller bearings, brake disks, springs and seals were chosen for maximum durability. To further extend the life of the
unit and reduce noise, all internal components run in an oil bath. Two brake release ports are also provided to simplify
plumbing and bleeding of the brake release circuit during installation. All of these features combine to make the BK10
Series brake the top choice for any static brake application requiring 10,000 lb-in of holding torque.
SHAFT 31 1 ½” Tapered
Mounting
6.92 Flange
Max. Torque: 19900 lb-in
1.78
.314 .75
.313
.276 .20
1.250
.274
1.200
ALLOWABLE BEARING AND SHAFT LOADS .17

Bearing Curve: The bearing curve represents allowable 1.500

.15
bearing loads based on ISO 281 bearing capacity for an 1.498

L10 life of 2,000 hours at 100 RPM. Radial loads for

speeds other than 100 RPM may be calculated using the
1-1/8”-18 UNEF
1:8
multiplication factor table located on page 24.
Note: A slotted nut is standard on this shaft.

-25 0 25 50 75 100 125 150 175 200 225 mm.

9,000 4,000

8,000 1000 lbs 3,500

7,000
3,000
1000 lbs
6,000
2,500
5,000
Shaft 2,000
4,000
1,500
3,000
1,000
2,000 Bearing

1,000 500
DaN
lbs.

-1 0 1 2 3 4 5 6 7 8 9 in.

141
BK
TECHNICAL
K30 4-Hole 7/16” O-Ring
2.34

1.95
.412
.408
7/16”-20 fill hole, port plug installed

Ø 7.00
(4) Ø .52

3.999
3.997

1.00
.50 90°

Ø 7.88

(2) SAE J51 4b

7/16”-20 Release Ports
.45 Deep

ORDERING INFORMATION
SERIES OPTIONS
913
DISPLACEMENT HOUSING SHAFT MISCELLANEOUS

Code Displacement Code Housings Code Shafts Code Options

4-Hole Wheel Mount

000 No Displacement K30 31 1-1/2" Tapered AA Standard
Front Ports 7/16"
O-Ring

PAINT CAVITY ADD ONS

Code Options Code Options Code Options

A Dark Metallic Gray A None A None

C Black C Solid Hex Nut

Z No Paint

142