Energy Conservation and Auditing Question Paper 21 22
Energy Conservation and Auditing Question Paper 21 22
Energy Conservation and Auditing Question Paper 21 22
Roll No:
BTECH
(SEM-7) ENERGY CONSERVATION AND AUDITING 2021-22
Instruction: Attempt the questions as per the given instructions. Assume missing data suitably.
SECTION - A
Q1 Questions Marks
(h) What are the factors that affect the cooling rate in air conditioning ? 2
SECTION - B
Attempt Any Three of the following 3*10 = 30
Q2 Questions Marks
(a) Why energy conservation is important. Explain different scheme/initiatives started by government to 10
conserve energy.
(b) What do you understand by national and international Ans, experiences with demand side management ? 10
Explain in detail.
(c) Explain in detail objectives of energy audit; give various types of energy audits. Give detailed explanation of 10
each.
(d) Write in detail different methods of saving energy and increasing the efficiency of 10
Boiler/blowers/compressor/ pumps.
(e) Describe the working principle of Automatic Power Factor controller. Its importance. What are the effects of 10
poor power factor on energy efficiency ?
SECTION - C
Q3 Questions Marks
(a) Write short note on-Energy conservation act 2001 and its features. 10
(b) Explain the energy conservation in small scale and large scale industries. 10
Q4 Questions Marks
(b) What is the difference between DISCOMs, TRANSCO and GENCO ? How UDAY scheme is beneficial 10
discusses ?
Q5 Questions Marks
(b) Distinguish between energy conservation and energy audit based on activities. 10
Q6 Questions Marks
(a) Explain in detail how conservation of energy is done in the following process : 10
i. Space heating Energy audit
ii. air-conditioning
(b) What are the modes of transfer of heat ? Explain the different types of electric heating methods and method 10
to measure its performance.
Q7 Questions Marks
(a) How energy efficiency improvement is achieved in energy efficiency motor for following power loss area : 10
i. Iron
ii. Stator and Rotor I2R
iii. Friction and windage
(b) Demonstrate the energy conservation technique adopted in lighting system by using energy efficient 10
luminaries and using light controlled gears.