Eg5014 0 1
Eg5014 0 1
Eg5014 0 1
Production Effective :
VIN Production Date
NA NA
NOTICE:
The MAF meter inspection procedure changes are for vehicles with DENSO made MAF meters.
Vehicles with HITACHI made MAF meters do not apply.
A112309
HINT:
The procedures above are the previous MAF meter inspection procedures. Please use the procedures
below, which are the new MAF meter inspection procedures.
A114321E01
(Vehicle Speed)
*1 *1 *1
Idling
Warming up
*1: 3 minutes or more
(b) Read value using intelligent tester II (LONG FT#1 and LONG FT#2).
HINT:
The "LONG FT#1" display is for inline engines. For V-type engines, "LONG FT#1 (NO. 1
BANK)" and "LONG FT#2 (NO. 2 BANK)" are displayed.
(1) Enter the following menus: Powertrain / Engine and ECT / Data List / Long FT#1 and Long
FT#2
(2) Read the values displayed on the tester.
Standard value:
Within -15 to +15 %
If the result is not within the standard value, perform inspection below.
HINT:
For V-type engines, if the value for either "LONG FT#1" or "LONG FT#2" is not within the
standard value, perform the inspection below.
(c) Read value using intelligent tester II (MAF).
NOTICE:
• Turn off the engine.
• Perform the inspection with the vehicle indoors and on a level surface.
• Perform the inspection of the MAF meter while it is installed to the air cleaner case
(installed to the vehicle).
• During the test, do not use the exhaust air duct to perform suction on the exhaust
pipe.
(1) Turn the ignition switch to ACC.
(2) Turn the ignition switch ON (do not start the engine).
(3) Turn the intelligent tester II ON.
(4) Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
(5) Wait 30 seconds, and read the MAF values on the intelligent tester.
Standard condition:
Less than the value shown under "Specified Condition"
A114321E01