Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Tube Woks B.K. Butler Tube Driver

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

WARRANTY AND OWNER REGISTRATION

910 TUBE DRIVER


Your TUBE DRIVER is warranted for a period of THREE
FULL YEARS against defects to the original, registered You’ve just purchased the vintage tube overdrive pedal
owner provided he/she has returned a completely filled- that started it all—TUBE DRIVER! Please take a mo-
out OWNER'S REGISTRATION CARD. ment to look over this brochure, and be sure to send in
the owner’s registration and your comments.
This warranty covers parts and labor only; shipping
charges remain the sole responsibility of the owner. Again from the leading innovator of the modern tube
Damage due to modification or abuse is excluded from overdrive, B.K. Butler, a major break-through in the
this warranty. Before returning any unit for service, a RE- classic 12AX7A tube sound. The ability of the Tube
TURNED MERCHANDISE AUTHORIZATION NUMBER Driver to be powered from a common 9-volt battery
(R.M.A.#) must be obtained. eliminator puts this pedal into your hands for under
$100.
Manufacturer is not responsible for consequential or in-
consequential damages resulting from any application or Your new Tube Driver pedal operates from the same
use of this product. Manufacturer and sales agents as- type of battery eliminator as most of your battery-
sume no liability or responsibility for safety or injury relat- operated effects (9-volt DC 200mA Min.), and it’s small
ing to the use of TUBE DRIVER, and user agrees to hold enough to fit in your pedal case.
manufacturer and designer harmless in this regard. This
is the full extent of the warranty; no other warranties im- The best thing about your Tube Driver is that instead of
plied or intended. bogus, cheap, solid state overdrive, you now have the
fat, warm, searing Real Tube sound.
For service and return authorization contact:
OPERATION
Plug in a battery eliminator (9-volt DC 200mA Min.)
and allow the tube to “warm up” for about 15 seconds.
Then plug your guitar into the “In” jack, and your amp
7811 E. Pierce Street to the “Out”. Set the Tube Driver, EQ and Level Out
Scottsdale, AZ 85257 controls to where your ears feel good, and you’re set.
Ph: 480-941-0705 Fax: 480-946-2412 (The red LED shows the Tube Driver is active.)

Downloaded from www.Manualslib.com manuals search engine


REAL TUBE OVERDRIVE™
Concept & Design: B.K. Butler

SPECIFICATIONS
VOLTAGE REQUIREMENT :9V DC, 200mA Min.
TUBE TYPE :12AX7A/ECC83 - Real
Tube
INPUT IMPEDANCE :1 MEG. OHMS
DRIVE SENSITIVITY :-65dBV (.04 mV)
S/N RATIO :65 dB (Typical)
HUM & NOISE :-75 dB (Typical)
OUTPUT IMPEDANCE :10 KOHMS (Typical)
OUTPUT LEVEL :0 dBV (.78 VRMS Typical)
SIZE (IN INCHES) :(HxWxL) 3.0 x 3.0 x 5.0
WEIGHT :2 LBS.

THE TUBE
The heart of your TUBE DRIVER is the favored pre- amp
tube in the music industry, the 12AX7A twin triode. The
life is 2-4 years under normal use. We do not recom-
mend any brand tube for replacement other than a genu-
ine "REAL TUBE”, as they are specially matched and
tested.

Downloaded from www.Manualslib.com manuals search engine

You might also like