Uncontrolled Copy

4 3 2 1

L1 (A)
(OPTIONAL
LOCATION)

GEN. H1 X1
L2 (B)
*OPTIONAL & IF USED*
(1) 3PH or (3) 1PH POTENTIAL TRANSFORMER(s)
CT's SHOWN IN THIS LOCATION CT7
[WYE CONNECTION]
FOR 6-LEAD WYE CONN. ONLY.
**ALTERNATE LOCATION** L3 (C)
CT's CAN BE ON LINES T1-T2-T3
H3 H2 H1
REVERSE (E1 & E3) FOR C-B-A
PRIMARY
B (OPTIONAL)
(H1)
H0
(H2) (H1)
H0
(H2) (H1)
H0
(H2) NEUTRAL B
TERMINAL E3
STRIP PARALLELING CT SHOWN
(SEE NOTE 2) SENSING
FOR A-B-C PHASE GND INPUT E2 (X1) (X2) (X1) (X2) (X1) (X2)
SECONDARY
SEQUENCE (IF USED) X0 X0 X0 NEUTRAL
E1
CT1
CT7 H1-2 / 1B2 VAR/PF AND X3 X2 X1 NEUTRAL MUST
* CT1 PARALLELING
X1 X1 BE GROUNDED
CT1 H1 H1 H1-1 / 1B1 CT INPUT WITH 3PH PT
H1-4 / AU+ AUX IN +
CT2 F1 (+) F2 (-)
CT2 H1-5 / AU- AUX IN - FUSE
* FIELD
X1 CIRCUIT H1-12 / NO BLOCK to L3 to L2 to L1
CT2 H1 EXCITER AL1
BREAKER (OPTIONAL)
FIELD
(OPTIONAL) H1-13 / COM AL2
CT3 *OPTIONAL*
F- EXCITER
* CT3 (2) 1PH PT's
X1 F+ FIELD [OPEN DELTA CONN.]
CT3 H1 D C
B A
4 PMG POWER GND
FIELD RESISTOR
CT4 INPUT
(OPTIONAL)
CT4 3 5A to E3 to E2 to E1
* X1

}
CT4 H1 VAR/PF H1-10 / QPF
REGULATOR ENABLE 52B
POWER SWITCH H1-11 / DG DEPENDENT ON POLARITY SETTINGS.
CT5 IF INSTALLED DEFAULT POLARITY IS ENABLED WHEN
PARALLEL H1-9 / DRP NORMALLY OPEN.
* CT5 (OPTIONAL) S2
X1 ENABLE
CT5 H1 H1-11 / DG
H1-7 / UP UP
REMOTE S1
CT6
VOLTAGE H1-11 / DG
* CT6 ADJUST
X1 H1-8 / DN DOWN
CT6
A H1 PMG A
T4 T5 T6 DIGITAL REGULATOR
DVR2400 / DVR2500
T0
NOTES: GENERATOR NEUTRAL

1- TERMINAL LOCATION ON DIAGRAM DOES NOT RELECT DRAWING REVISION REVISION BY REV DATE/ © DATE DRAWN BY
®
PHYSICAL LOCATION OF COMPONENTS. F CLJ 06-21-2019 TM
ECO APPROVED BY DATE DATE Regal Beloit America, Inc.
2- CT's (1 THRU 7) ARE OPTIONAL & QUANTITIES MAY VARY FOR EACH MODEL. ECO-0169214 MJS 06-21-2019 09-01-2015
REMOVE SHORTING LINKS ON TERMINAL STRIP WHEN CT's ARE UTILIZED. ECO DESCRIPTION
PRIMARY DIMENSIONS ARE INCH APPROVED BY DESCRIPTION
SWITCHED DG AND DN POSITION
COPYRIGHT (PER REVISION DATE) REGAL BELOIT AMERICA, INC. ALL RIGHTS RESERVED.
mm DIMENSIONS IN [BRACKETS]
DATE
SA
CONN DIAGRAM-EXTERNAL
3- (3) CT OPTION FOR DVR IS AVAILABLE VIA H2 CONNECTION. PROPRIETARY AND CONFIDENTIAL INFORMATION - THIS DOCUMENT IS THE PROPERTY OF ARE FOR REFERENCE ONLY MV/HV -DVR2400/2500 -MV/HV PT(s) -UP TO 7 CT'S
09-01-2015
REFER TO MANUAL FOR CONNECTION DIAGRAM. (DVR2500 ONLY) REGAL BELOIT AMERICA, INC. ("OWNER") AND CONTAINS OWNER'S PROPRIETARY
INFORMATION. ANY PERSON, CORPORATION OR OTHER FIRM RECEIVING IT IS DEEMED, REFERENCE MATERIAL PROCESS/FINISH
BY RECEIVING IT, TO AGREE THAT IT, AND/OR ANY PART OF IT, SHALL NOT BE DISCLOSED 532545-1001, '4213-1000
4- REFER TO REGULATOR INSTALLATION, OPERATION AND TO ANY PERSON, CORPORATION OR OTHER ENTITY, DUPLICATED, AND/OR USED, EXCEPT
AS EXPRESSLY APPROVED IN WRITING IN ADVANCE BY OWNER. THIS DOCUMENT SHALL THIRD ANGLE SIZE DRAWING NUMBER SHEET
MAINTENANCE MANUAL FOR SYSTEM INTERFACE WIRING. BE RETURNED TO OWNER UPON REQUEST. IT MAY BE SUBJECT TO CERTAIN
RESTRICTIONS UNDER APPLICABLE EXPORT CONTROL LAWS AND REGULATIONS.
PROJECTION B 534213-1001 1 OF 1
4 3 2 1