Q1. A solid cylindrical needle of diameter d, length L, and density ρn may "float" on a liquid

Chapter 2 • Pressure Distribution in a Fluid 2-1
Q1. A solid cylindrical needle of diameter d, length L, and density ρn may “float” on a liquid
surface. Neglect buoyancy and assume a contact angle of 0 degree. Calculate the maxi-mum
diameter needle able to float on the surface.
Solution: The needle “dents” the surface downward and the surface tension forces are
upward, as shown. If these tensions are nearly vertical, a vertical force balance gives:
p 8Y
å Fz = 0 = 2YL - rg d2 L, or: d max » Ans. (a)
4 prg
10 points
-2 points if there is a miscalculation
Q2. In Figure, the tank contains water and immiscible oil at 20C. What is h in centimeters if
the density of the oil and water is 898 kg/m3 998 kg/m3 respectively.
Solution: For water take the density = 998 kg/m3. Apply the hydrostatic relation from
the oil surface to the water surface, skipping the 8-cm part:
patm + (898)(g)(h + 0.12)

- (998)(g)(0.06 + 0.12) = patm ,
Solve for h » 0.08 m » 8.0 cm Ans.
10 points
Q3. Gate AB in Figure is 1.2 m long and 0.8 m into the paper. Neglecting atmospheric-pressure
effects, compute the force F on the gate and its center of pressure position X.
Solution: The centroidal depth of the gate is

hCG = 4.0+(1.0+0.6)sinθ = 5.028 m
hence FAB = g oil h CG A gate = (0.82 ´ 9790)(5.028)(1.2 ´ 0.8) = 38750 N Ans.
5 points
The line of action of F is slightly below the centroid by the amount

I xx sin q (1/12)(0.8)(1.2)3sin 40°
y CP =- =- = -0.0153 m
h CG A (5.028)(1.2 ´ 0.8)
Thus the position of the center of pressure is at X = 0.6 + 0.0153 » 0.615 m Ans.
5 points
Q4. Compute the horizontal and vertical components of the hydrostatic force on the
quartercircle panel at the bottom of the water tank in Fig. P2.85. Note that γwater is 9790 N/m3 .
4번의 경우, 문제 그림이 잘못 기재되어, 아래 중 한가지 풀이만 만족해도 정답처

리 요망
1.
Fig. P2.82
Solution: The horizontal force acts as if the dam were vertical and 20 m high:
FH = g h CG A vert
= (9790 N/m 3 )(10 m)(20 ´ 50 m 2 )
= 97.9 MN Ans.
5 points
This force acts 2/3 of the way down or 13.33 m from the surface, as in the figure. The
vertical force is the weight of the fluid above the dam:
p
FV = g (Vol)dam = (9790 N/m3 ) (20 m)2 (50 m) = 153.8 MN Ans.
4
This vertical component acts through the centroid of the water above the dam, or 4R/3p =
4(20 m)/3p = 8.49 m to the right of point A, as shown in the figure. The resultant hydrostatic
force is F = [(97.9 MN)2 + (153.8 MN)2]1/2 = 182.3 MN acting down at an angle of 32.5°
from the vertical. The line of action of F strikes the circular-arc dam AB at the center of
pressure CP, which is 10.74 m to the right and 3.13 m up from point A, as shown in the
figure. Ans.
5 points
2. -
Solution: The horizontal component is
FH = g h CG A vert = (9790)(6)(2 ´ 6) FH = g h CG A vert = (9790)(6)(2 ´ 6)

= 705000 N Ans. (a) = 705000 N Ans. (a)
5 points
The vertical component is the weight of the fluid above the quarter-circle panel:
FV = W(2 by 7 rectangle) - W(quarter-circle)

= (9790)(2 ´ 7 ´ 6) - (9790)(p /4)(2)2 (6)
= 822360 - 184537 = 638000 N Ans. (b)
5 points
Q5. The tank of liquid in the figure accelerates to the right with the fluid in rigid-body motion.
(a) Compute ax in m/s2 . (b) Why doesn’t the solution to part (a) depend upon fluid density? (c)
Compute gage pressure at point A if the fluid is glycerin at 20 C.
Solution: (a) The slope of the liquid gives us the acceleration:
ax 28 - 15 cm
tanq = = = 0.13, or: q = 7.4°
g 100 cm
thus ax = 0.13g = 0.13(9.81) = 1.28 m/s2 Ans. (a)
5 points
(b) Clearly, the solution to (a) is purely geometric and does not involve fluid density. Ans. (b)
5 points
(c) From Table A-3 for glycerin, r = 1260 kg/m3. There are many ways to compute pA. For
example, we can go straight down on the left side, using only gravity:
pA = r gDz = (1260 kg/m3 )(9.81 m/s2 )(0.28 m) = 3460 Pa (gage) Ans. (c)
Or we can start on the right side, go down 15 cm with g and across 100 cm with ax:
pA = rgDz + ra x Dx = (1260)(9.81)(0.15) + (1260)(1.28)(1.00)

= 1854 + 1607 = 3460 Pa Ans. (c)
5 points
Q6. The tank of water in Figure is 12 cm wide into the paper. If the tank is accelerated to the
right in rigid-body motion at 6 m/s2, compute (a) the water depth at AB, and (b) the water force
on panel AB.
Solution: From Eq. (2.55),

6.0
tan q = a x /g = = 0.612, or q » 31.45°
9.81
Then surface point B on the left rises an additional Dz = 12 tanq » 7.34 cm,
or: water depth AB = 9 + 7.34 » 16.3 cm Ans. (a)
5 points
The water pressure on AB varies linearly due to gravity only, thus the water force is
æ 0.163 ö
FAB = pCG A AB = (9790)ç m ÷ (0.163 m)(0.12 m) » 15.7 N Ans. (b)
è 2 ø
5 points

Q1. A solid cylindrical needle of diameter d, length L, and density ρn may "float" on a liquid

Uploaded by

Copyright:

Available Formats

Q1. A solid cylindrical needle of diameter d, length L, and density ρn may "float" on a liquid

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Q1. A solid cylindrical needle of diameter d, length L, and density ρn may "float" on a liquid

Uploaded by

Copyright:

Available Formats

Chapter 2 • Pressure Distribution in a Fluid 2-1

-2 points if there is a miscalculation

patm + (898)(g)(h + 0.12)

Solve for h » 0.08 m » 8.0 cm Ans.

-2 points if there is a miscalculation

Solution: The centroidal depth of the gate is

The line of action of F is slightly below the centroid by the amount

-2 points if there is a miscalculation

4번의 경우, 문제 그림이 잘못 기재되어, 아래 중 한가지 풀이만 만족해도 정답처

-2 points if there is a miscalculation

Solution: The horizontal component is

FH = g h CG A vert = (9790)(6)(2 ´ 6) FH = g h CG A vert = (9790)(6)(2 ´ 6)

FV = W(2 by 7 rectangle) - W(quarter-circle)

-2 points if there is a miscalculation

Solution: (a) The slope of the liquid gives us the acceleration:

pA = rgDz + ra x Dx = (1260)(9.81)(0.15) + (1260)(1.28)(1.00)

-2 points if there is a miscalculation

Solution: From Eq. (2.55),

or: water depth AB = 9 + 7.34 » 16.3 cm Ans. (a)

-2 points if there is a miscalculation

You might also like