This pedal is a mini analog delay pedal that packs the warmth and tone of the original Carbon Copy Analog Delay into a smaller housing. It has controls for modulation on/off, number of repeats, mix of wet and dry signal, delay time, and accentuating the high frequencies. It is powered by a 9-volt adapter and has a 1M ohm input and 1k ohm output impedance.
This pedal is a mini analog delay pedal that packs the warmth and tone of the original Carbon Copy Analog Delay into a smaller housing. It has controls for modulation on/off, number of repeats, mix of wet and dry signal, delay time, and accentuating the high frequencies. It is powered by a 9-volt adapter and has a 1M ohm input and 1k ohm output impedance.
This pedal is a mini analog delay pedal that packs the warmth and tone of the original Carbon Copy Analog Delay into a smaller housing. It has controls for modulation on/off, number of repeats, mix of wet and dry signal, delay time, and accentuating the high frequencies. It is powered by a 9-volt adapter and has a 1M ohm input and 1k ohm output impedance.
This pedal is a mini analog delay pedal that packs the warmth and tone of the original Carbon Copy Analog Delay into a smaller housing. It has controls for modulation on/off, number of repeats, mix of wet and dry signal, delay time, and accentuating the high frequencies. It is powered by a 9-volt adapter and has a 1M ohm input and 1k ohm output impedance.
ease of use of the original Carbon Copy Analog Delay into an MXR mini housing with added sonic versatility so that you can make the most out of your pedalboard real estate.
jimdunlop.com/m299 External Controls
2 4
1 MOD switch toggles modulation on/off (orange LED indicates on)
2 REGEN knob sets number of repeats 3 MIX knob controls blend of wet and dry signals 4 DELAY knob sets time between repeats 5 FOOTSWITCH toggles effect on/bypass (blue LED indicates on) 6 BRIGHT switch accentuates delay signal's high end frequencies (blue LED indicates on)
M299 | Carbon Copy® Mini Analog Delay 2
Basic Operation
Power
The Carbon Copy® Mini Analog Delay is powered by the
Dunlop ECB003 9-volt adapter or the DC Brick™, Iso-Brick™, and Mini Iso-Brick™ power supplies. This pedal cannot be powered by a battery.
Directions
1 un a cable from your guitar to M299’s INPUT jack and another
R cable from M299’s OUTPUT jack to your amplifier. 2 tart with all knobs set to 12 o’clock. S 3 Turn effect on by depressing the footswitch. 4 Rotate REGEN knob clockwise to increase number of repeats or counterclockwise to decrease it. 5 otate MIX knob clockwise to increase ratio of wet to dry signal R or counterclockwise to decrease it. Fully clockwise results in half wet/half dry mix while fully counterclockwise results in 100% dry signal. 6 otate DELAY knob clockwise to increase delay time or R counterclockwise to decrease it. 7 se a jeweler’s flathead screwdriver to flip the BRIGHT switch U toward heel of pedal to accentuate delay signal’s high end frequencies (indicated by blue LED). 8 ush in MOD switch to add modulation to your delay signal. P Modulation width and speed can be adjusted internally (remove bottom plate) with a 3mm slotted screwdriver (see Diagram A).
