Ulv602 Utc
Ulv602 Utc
Ulv602 Utc
, LTD
ULV602 CMOS IC
FEATURES
* Supply Voltage: 2.7V ~ 6.0V
* Supply Current: 200µA/amplifier (Typical)
* Input Offset Voltage: 2mV (Max.)
* Rail-to-Rail Output
* Slew Rate: 2.3V/µs (Typ.)
ORDERING INFORMATION
Ordering Number
Package Packing
Lead Free Halogen Free
ULV602L-S08-R ULV602G-S08-R SOP-8 Tape Reel
MARKING
www.unisonic.com.tw 1 of 6
Copyright © 2024 Unisonic Technologies Co., Ltd QW-R105-125.A
ULV602 CMOS IC
PIN CONFIGURATION
PIN DESCRIPTION
PIN NO. PIN NAME DESCRIPTION
1 OUT 1 Output of 1 AMP
2 -IN 1 Inverting input of 1 AMP
3 +IN 1 Non-inverting input of 1 AMP
4 V- Negative Power Supply
5 +IN 2 Non-inverting input of 2 AMP
6 -IN 2 Non-inverting input of 2 AMP
7 OUT 2 Output of 2 AMP
8 V+ Positive Power Supply
BLOCK DIAGRAM
OUT 1 1 8 V+
-IN 1 2
- 7 OUT B
-IN 2
-
6
+
+IN 1 3
+
V- 4 5 +IN 2
ELECTRICAL CHARACTERISTICS
(TA =25°C, V+ =+2.7 ~ +5.5V, RL=100kΩ, VCM = V+/2, unless otherwise specified)
PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNIT
Supply Current/Amplifier IQ IO=0 200 325 µA
Power Supply Rejection Ratio PSRR V+ = 2.7V ~ 5.5V 76 120 dB
Input Offset Voltage VOS -2 ±0.7 +2 mV
Input Offset Voltage Drift ΔVOS/ΔT TA = -40°C to +125°C ±2.5 µV/°C
Input Bias Current IB 1 pA
Input Offset Current IOS ±1 pA
Common-Mode Voltage Range VCM V--0.3 V+-1.2 V
Common-Mode Rejection Ratio CMRR VCM=-0.3V~3.8V, V+=5.0V 75 90 dB
RL = 25kΩ
85 105 dB
VOUT=0.1V~ V-- 0.1V
Large Signal Voltage Gain AV
RL = 5kΩ
80 100 dB
VOUT=0.1V~ V-- 0.1V
RL = 25kΩ, AOL 100dB V-+100 V+-100 mV
Output Voltage VO
RL = 5kΩ, AOL 95dB V-+100 V+-100 mV
Short-Circuit Current ISC Sourcing, VO=0V 25 mA
Sinking, VO= V+ 20 mA
Slew Rate SR 2.3 V/μs
Gain-Bandwidth Product GBW 2.8 MHz
Phase Margin ΦM 25 degrees
f=1kHz 32 nV/ Hz
Voltage Noise Density en
f=10kHz 23 nV/ Hz
TEST CIRCUITS
TYPICAL CHARACTERISTICS
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other
parameters) listed in products specifications of any and all UTC products described or contained herein.
UTC products are not designed for use in life support appliances, devices or systems where malfunction
of these products can be reasonably expected to result in personal injury. Reproduction in whole or in
part is prohibited without the prior written consent of the copyright owner. UTC reserves the right to
make changes to information published in this document, including without limitation specifications and
product descriptions, at any time and without notice. This document supersedes and replaces all
information supplied prior to the publication hereof.