Safety Data Sheet

E236 Urethane Mold Release™

Copying and/or downloading of this information for the purpose of properly utilizing Stoner Inc. product is allowed provided that: (1) the
information is copied in full with no changes unless prior agreement is obtained from Stoner Inc., & (2) neither the copy nor the original is
resold or otherwise distributed with intention of earning profit thereon.

1. IDENTIFICATION
Stoner Incorporated Product Name: Urethane Mold Release™
1070 Robert Fulton Hwy. Product Code: E236
Quarryville, PA 17566 Product Use: Mold Release
1-800-227-5538 24-hour emergency phone: 1-800-424-9300 [CHEMTREC]

2. HAZARD IDENTIFICATION
POTENTIAL HEALTH EFFECTS
Classification of the chemical in accordance with paragraph (d) of §1910.1200;
GHS Hazard Symbols

GHS Classification Gases under pressure - Liquified Gas

Flammable Aerosol Category 2

Signal Word Warning

Hazard Statements Flammable aerosol.

Contains gas under pressure; may explode if heated.

Precautionary Statements

Prevention Keep away from heat/sparks/open flames/hot surfaces. – No smoking.

Do not spray on an open flame or other ignition source.
Pressurized container: Do not pierce or burn, even after use.

Storage Protect from sunlight. Store in a well-ventilated place.

Protect from sunlight. Do no expose to temperatures exceeding 50°C/ 122°F.

3. COMPOSITION/INFORMATION ON INGREDIENTS
COMPONENT CAS # Percent
Halogenated hydrocarbon/ether blend Mixture 80-100

HMIS® III* HAZARDOUS WARNINGS:

Health: 1 Flammability: 2 Physical: 2 Personal See Section 8
Protective
Equipment:

* See www.paint.org/hmis or call the ACA at 1 (202) 462-6272 for more information on this current rating system.
4. FIRST AID MEASURES
Eyes: Immediately flush eyes gently with plenty of water for at least 15 minutes while holding eyelids apart. If symptoms persist or there
is visual difficulty, seek medical attention.
Skin Contact: In case of contact, immediately wash contaminated area with plenty of water for at least 15 minutes. For liquid contact, treat for
frostbite if necessary. Seek medical attention if symptoms persist. Wash clothing before reuse.
Ingestion: Contact a physician, medical facility, or poison control center immediately.
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Seek immediate medical
attention.
NOTES TO PHYSICIAN:
Because of possible disturbances of cardiac rhythm, catecholamine drugs, such as epinephrine, should be used only in situations of emergency life
support.

Stoner Incorporated E236 PAGE 1

 5. FIRE FIGHTING MEASURES
Fire and/or Explosion Hazards: This product contains a component(s) that is considered an extremely flammable gas(es), which has vapors that
are heavier than air and may travel along the ground or be moved by ventilation and ignited by heat, pilot lights,
or other flames and ignition sources at locations distant from the material's handling point.Containers may rupture
or explode under fire conditions. This material burns with difficulty, but will support combustion.
Fire Fighting Instructions: Use CO2, foam or dry chemical. Water is generally not effective and may spread fire; however, water spray may
be used from a safe distance to cool closed containers and protect surrounding area.

6. ACCIDENTAL RELEASE MEASURES

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
Ventilate contaminated area. Remove all sources of ignition. Wear appropriate personal protective equipment (PPE). Stop or reduce discharge if it can be
done safely. Avoid run-off into storm sewers and ditches which may lead to natural waterways. Clean up with absorbent material. Place absorbent
materials into container and close it tightly. Dispose of container properly. If runoff occurs, notify authorities as required.

7. HANDLING AND STORAGE

Handling: Use with adequate ventilation. Do not use near ignition sources. Avoid prolonged or repeated contact with skin. Avoid prolonged or
repeated breathing of vapor. May cause frostbite. Inhalation of respirable aerosols of the lubricant in this product may cause serious toxic
effects in the lungs, based on animal studies. Use proper PPE. Usual precaution for combustible liquids. Wash hands thoroughly after
handling.
Storage: Store in a cool, dry, well ventilated area away from all sources of ignition. Do not store at temperatures above 122 degrees F. Empty
container may contain residues which are hazardous. Store away from incompatible materials such as materials that support combustion
(oxidizing materials) and corrosive materials (strong acids or bases). Store away from oxygen cylinders or other oxidizing materials and
possible ignition sources. Ground all equipment and cylinders before use. This material (or a component) evolves flammable methyl
alcohol when exposed to water or humid air.

8. EXPOSURE CONTROLS / PERSONAL PROTECTION

Engineering Controls: Ventilation should be adequate to prevent exposures above the limits indicated below in this section of the SDS (from
known, suspected or apparent adverse effects).
Eye Protection: Wear chemically resistant safety glasses with side shields when handling this product. Wear additional eye protection such as
chemical splash goggles and/or face shield when the possibility exists for eye contact with splashing or spraying liquid or
airborne material. Have an eye wash station available.
Skin Protection: The use of chemically resistant gloves is recommended if there is any possibility of prolonged or repeated liquid contact with
skin.
Respiratory Protection: A supplied air respirator should be used if ventilation is not sufficient to maintain exposure limits. Use NIOSH approved
respirator where there is likelihood of inhalation of the product mist, spray or aerosol. The use of an approved dust, fume and
mist respirator designed for exposure limits greater than 0.05 mg/m3 is recommended.
COMPONENT CAS # ACGIH TLV OSHA PEL OTHER
Halogenated hydrocarbon/ether blend Mixture Not established Not established 1000ppm TWA (Mfr.)

9. PHYSICAL AND CHEMICAL PROPERTIES

Physical State: Aerosol can Lower Flammability Limit (%): Not applicable
Appearance: Colorless Upper Flammability Limit (%): Not applicable
Odor: Slight Ether Vapor Pressure (PSIG @ 70°F): 78.0
Odor Threshold: Mild Vapor Density [air = 1]: >1
pH: Not applicable Relative Density (H2O=1): 0.8
Melting/Freezing Point (°F): No data available Solubility in Water: Not determined
Boiling Point (°F): No data available Partial Coefficient: n- No data available
octanol/water:
Flash Point (°F PMCC): Not applicable Autoignition Temperature (°F): Not applicable
Evaporation Rate: No data available Decomposition Temperature (°F): No data available
Flammability (solid, gas): No data available Viscosity, dynamic (cSt): No data available
Percent VOCs (%): 40 - 60

10. STABILITY AND REACTION

Chemical Stability: Stable.
Conditions to Avoid: Avoid contact with: Alkali. Alkaline earth metals. Powdered metals. Ignition sources such as open flames, sparks, static
discharges or glowing metal surfaces. Oxidizers. Acetic acids Organic acid anhydrides. Strong oxidizing agents.
Decomposition Products: This material can be decomposed by extremely high temperatures (open flames, glowing metal surfaces, etc.) forming
hydrofluoric acid and carbonyl fluoride. If heated with peroxides present, violent decomposition can occur. When
heated to temperatures above 150°C in the presence of air, one of the ingredients in this product can form formaldehyde
vapors. Formaldehyde vapor is harmful by inhalation; irritating to eyes; sensitizer to the respiratory system; an acute
toxicant and a potential cancer hazard at concentrations greater than 0.75 ppm. Burning can produce the following
combustion products: Carbon dioxide and carbon monoxide. Formaldehyde.

11. TOXICOLOGICAL INFORMATION

Inhalation Toxicity: Inhalation of respirable aerosols of the lubricant in this product may cause serious toxic effects in the lungs, based on
animal studies. Use proper PPE.
Reproductive & No data available.
Developmental Toxicity:
IARC Carcinogen Designation: No data available

Stoner Incorporated E236 PAGE 2

 Ingredient CAS # Toxicological Data
No data available

12. ECOLOGICAL INFORMATION

Ecological Toxicity: No data available
Mobility: No data available
Ingredient CAS # Toxicological Data
Ether propellant 115-10-6 48HR NOEC GUPPIES > 4000 mg/L
48HR NOEC Daphnia > 4000 mg/L
No data available

13. DISPOSAL CONSIDERATIONS

Disposal : Dispose according to Federal, State and local regulations.

14. TRANSPORTATION INFORMATION

Agency UN Number Proper Shipping name Hazard Class Packing Group
DOT UN1950 Aerosols, Flammable† 2.1 Not applicable
IATA ID8000 Consumer Commodity† 9 Not applicable
IMDG UN1950 Aerosols, Flammable† 2.1 Not applicable
† "Limited Quantities" may be applicable for this transportation mode.

15. REGULATORY INFORMATION

Warning: This product contains the following chemicals that are subject to reporting requirements for the following regulatory bodies listed below:
COMPONENT CAS # % BY WEIGHT Regulatory Body
No components listed in this section. SARA Section 313

Toxic Substances Control Act

All components of this product are listed on the TSCA inventory.

California Prop 65
This product contains no California Proposition 65 ingredients that cause cancer, birth defects or other reproductive harm.

16. OTHER INFORMATION

Other Information : SDS Prepared by L. Dean Swartz, SDS Coordinator

Version Date: 7/10/19

This information contained in this SDS is believed to be accurate as of the version date, but is not warranted to be. Since the use of this
information and the conditions of use of this product are not within the control of Stoner Inc, it is the user's obligation to determine the conditions
of safe use.

Stoner Incorporated E236 PAGE 3