MATERIAL SAFETY DATA SHEET Date of issued : 05-05-2018 Rev-2,

CM 63

1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

BRANDNAME : CM 63
COMPANY : PT CRYSTAL ANUGERAH ABADI
ADDRESS : GREEN SEDAYU BIZPARK, JL.DAAN MOGOT KM18, BLOK DM9/31
JAKARTA BARAT – 11840 – INDONESIA.
TELEPHONE : 021- 22952523 FAX NO : 021- 29725467
DEPARTMENT FOR INFORMATION : MARKETING DEPARTMENT EMERGENCY
CONTACT NUMBER
TELEPHONE : 021- 22952523 FAX NO : 021- 29725467
2. INFORMATION ON COMPOSITION
Stabilized chlorine base oxidizing biocide compound

2.1 The product is composed of the following important ingredients :

Stabilized Chlorine compound
2.2 Characterization of important component according to 2.1 :
CAS-No. EINECS-No. EC-No. WARNING SIGNS R-PHRASES
(a) 7681-52-9
(b) 1310-73-2

3. HAZARD IDENTIFICATION

TOXIC, CORROSIVE

3.1 Eye Contact : Corrosive. Will cause eye burns and permanent tissue damage
3.2 Skin Contact : May cause severe irritation or tissue damage depending on the length of exposure and the
type of first aid administer
3.3 Ingestion : Corrosive, causes burns to gastro-intestinal tract. Nausea, vomiting and stomach pain may
occur. In severe cases blood may be vomited
3.4 Inhalation : Corrosive to respiratory system

ENVIRONMENTAL HAZARDS :
Toxic to aquatic organisms

4. FIRST AID MEASURES

4.1 Eye Contact : Prompt action is essential in case of contact. Immediately flush eye with plenty of water
for at least 15 minutes while holding eyelids open. Get medical attention immediately.

4.2 Skin Contact : Removing contaminated clothing. Wash off affected area immediately with plenty of water
For a large splash, flood body under a shower. Get immediate medical attention.
Contaminated clothing, shoes and leather goods must be discarded or cleaned before re-use

4.4 Ingestion : Do NOT induce vomiting. If conscious, washout mouth and give a lot of water to drink.
Get immediate medical attention.
4.5 Inhalation : Remove to fresh air. Get medical attention.

1 of 5
MATERIAL SAFETY DATA SHEET Date of issued : 05-05-2018 Rev-2,
CM 63

5. FIRE FIGHTING MEASUREMENT

FLASH POINT : Not flammable

FIRE EXTINGUSING MEDIA

Not expected to burn. Use extinguishing media appropriate for surrounding fire

FIRE AND EXPLOSION HAZARD

Not flammable or combustible. Contact with reactive metal ( Eq. Alumminium) may result in the generation
of flammable hydrogen gas. May evolve toxic gases or fumes under fire conditions.

SPECIAL PROTECTIVE EQUIPMENT FOR FIRE FIGHTING

In case of fire, wear a full face positive-pressure self-contained breathing apparatus and protective suit.

6. ACCIDENTAL RELEASE MEASURE

PERSONAL PRECAUTIONS
Restrict access to area as appropriate until clean-up operations are complete. Stop or reduce any leaks if it safe
to do so. Ventilate spill ares if possible. Ensure clean-up is conducted by trained personnel only. Do not touch
spill material. Have emergency equipment ( for fire, spills, leaks, etc.) readily available. Notify appropriate
government, occupational health and safety and environmental authorities.

METHODS FOR CLEANING UP

SMALL SPILLS: Soak up spill with absorbent material. Place residues in suitable, covered, properly labeled
container. Wash affected area.

LARGE SPILL : Contain liquid using absorbent material, by digging trenches or by diking. Reclaim into
recovery or salvage drums or tank truck for proper disposal. Clean contaminated surfaces with water or
aqueous cleaning agents. Contact an approved waste hauler for disposal of contaminated recovered material.

LAND SPILL
Keep public and other shipping traffic away

ENVIRONMENTAL PROCAUTIONS
Harmful to aquatic organisms. Do not contaminated surface water.

7. STORAGE AND HANDLING

HANDLING:
Do not get in eyes, on skin ,on clothing. Do not take internally. Use with adequate ventilation.
Avoid generating aerosol and mists. Keep container closed when not in use. Have emergency
equipment (for fire, spills, leaks, etc.) readily available. Ensure all containers are labeled.

STORAGE CONDITION:
Store in suitable labeled containers. Store the containes tightly closed. Store separately with acids.
Storage condition should be under 15ºC

2 of 5
MATERIAL SAFETY DATA SHEET Date of issue : 07-02-2012
MSDS No. : KI-TCNT63 Rev-2, 12--03-2012

8. EXPOSURE CONTROLS AND PERSONAL PROTECTION

8.1 Engineering Measure
General ventilation is recommended. Use local exhaust ventilation if necessary to control airborne mist and
vapor

8.2 Respiratory Protection:

If significant mists, vapor or aerosol are generated and approved respirator is recommended. An organic
vapor cartridge with dust/mist pre-filter or supplied air may be used. In event emergency or planned entry
into unknown concentration a positive pressure, full face piece SCBA should be used.
If respiratory protection is required, institute a complete respiratory protection program including
selection, fit, testing , training, maintenance and inspection.

8.3 Hand Protection

PVC gloves, nitrile gloves, neoprene gloves, rubber gloves

8.4 Skin Protection

Wear chemical resistant apron, chemical splash goggles, impervious gloves and boots. A full slicker suit is
recommended if gross exposure is possible

8.5 Eye Protection

Wear a face shield with chemical splash goggles

8.6 Hygiene recommendation

Eye wash station/safety shower are necessary. If clothing is contaminated, remove clothing and thoroughly
wash the affected area. Lauder contaminated clothing before reuse

9. PHYSICAL AND CHEMICAL PROPERTIES

o
Form : at 20 C liquid Color : Colorless to light yellow Odor : Chlorine like (slight)

9.1 Specific Gravity (at 20ºC) : 1.25 ± 0.02

o
9.2 Freezing Point : -5 C
9.3 Water solubility : soluble in every proportion
9.4 pH value (at 20ºC.) : 12.0 ± 0.5 ( as 1 % solution)
9.5 Flash point : not applicable
9.6 Ignition point : not applicable
9.7 Explosion limits : not applicable
9.9 Thermal decomposition : by release toxic vapour
9.8 Further data :-

10. STABILITY AND REACTIVITY

STABILITY
Slowly decomposes. If the temperature increase to 40ºC, there are formation of Cl2.

CONDITION TO AVOID
Heat and light which can accelerate decomposition

MATERIAL TO AVOID
Contact with organic material (e.g. rags, sawdust, hydrocarbon oils or solvents) and recucing agents (e.g.
hydrazine, sulfite, sulfide, aluminium or which can generate heat, fire magnesium dust) which can generate
heat, fire and release of toxid fumed.

3 of 5
MATERIAL SAFETY DATA SHEET Date of issue : 07-02-2012
MSDS No. : KI-TCNT63 Rev-2, 12-03-2012

11. TOXICOLOGICAL INFORMATION

ACCUTE TOXICITY DATA

No toxicity sted on this product studies have been conducted on this product

SENSITIZATION
This product is not expected to be sensitizer

12. ECOLOGICAL INFORMATION

ECOTOXICOLYCAL EFFECTS
No toxicity studies have been conducted on this product.

13. DISPOSAL CONSIDERATIONS

Disposal in accordance with local, state and federal regulations. Hazardous waste must be transported by a
licensed hazardous waste transporter and disposed of or treated in a properly licensed hazardous waste
treatment, storage, disposal or recycling facility. Consult local, state and federal regulation for specific
requirements.

Triple rinse (or equivalent) all containers and offer for recycling or reconditioning or puncture and dispose of
in a sanitary landfill or by other procedure approved by state and local authorities.

14. TRANSPORT REGULATIONS

The information in this sections is for reference only and should not take the place of a shipping paper
specific to an order. Please note that the proper Shipping name/Hazard Class may vary by packaging,
properties and mode of transportation. Typical Proper Shipping Names for this product are:

Land Transport:
Proper Shipping Name : Hypochlorite Solution
UN/ID No : UN 1791
Hazard Class-primary 8
Packing Group III
Hazchem Code : 2X

Air Transport (ICAO/IATA)

Proper Shipping Name : Hypochlorite Solution
UN/ID No : UN 1791
Hazard Class-primary 8
Packing Group III
IATA Cargo Packing Instruction 821
IATA Cargo Aircraft Limit : 60L
IATA Passenger Packing Instruction : Y819/819
IATA Passenger Aircraft Limit : 1L/ 5L

Marine Transport:
Proper Shipping Name : Hypochlorite Solution
UN/ID No : UN 1791
Hazard Class-primary 8
Packing Group III
EmS-Nr. : 8-08

4 of 5
MATERIAL SAFETY DATA SHEET Date of issue : 07-02-2012
MSDS No. : KI-TCNT63 Rev-2, 12-03-2012

15. REGULATIORY INFORMATION

National Regulations,
Government Regulation No. 19/1994 On the treatment of Dangerous and Toxic Waste ( and amendment) as
applicable.

16. OTHER INFORMATIONS

This product material safety data sheet provides health and safety information. Individuals handling this
product should be informed of the recommended safety precautions and should have access to this
information. For any other uses, exposures should be evaluated so that so that appropriate handling practices
and training programs can be established to insure safe workplace operations.

other Special Considerations: Not available.

The information above is believed to be accurate and represents the best information currently available to
us. However, we make no warranty of merchantability or any other warranty, express or implied, with
respect to such information, and we assume no liability resulting from its use. Users should make their own
investigations to determine the suitability of the information for their particular purposes.

5 of 5