450 Europroof LWP

EuroProof LWP 450
Bituminous Liquid Applied Membrane
EuroProof LWP 450 is Rubber/fibre reinforced,

cold applied, specialised polymer latex modified
bitumen with outstanding adhesion, which forms
a tough, black, seamless, flexible, water proof
membrane.
EuroProof LWP cured film is an excellent waterproof

and resistant to chlorides and sulphates.
Description
EuroProof LWP 450 is high viscous liquid applied

elastomeric flexible membrane for
waterproofing and high grade protection system of a
wide range of surfaces.
Uses
EuroProof LWP ideally suitable for waterproofing on:-
 Waterproofing on concrete and block

foundations and basements.
 Retaining Walls, Sub structure, ground floor

Slabs, basements underground structures and
bridge abutments.
 Swimming Pools external waterproofing.
 Recommended for excess chloride content

areas.
 Recommended for submerged conditions

EuroProof LWP 450
Advantages Application Instructions
 Excellent and permanent barrier for concrete or

plaster waterproof protection. Surface Preparation
All surfaces must be smooth, dry, firm and free of

 Highly flexible product, self cures and forms
elastomeric anti – fracture membrane. voids, projections, lose materials, oil, grease, curing
 Excellent withstanding on severe cases of compounds and other foreign materials. Concrete
expansion, contraction and movements. should be cured a minimum of 14 days (Preferably 28
 Highly water resistant. days) before applying membrane.
 High bitumen content provides long lasting and

Application
durable protection.
 Resistant to aggressive chemicals solutions. EuroProof LWP 450 designed primarily for horizontal
applications with it’s self-levelling characteristics, and

 Excellent chloride resistant.
also can be applied to vertical surfaces with a roller
 Excellent alkaline resistant.
or suitable spray equipment. Apply EuroProof LWP
 Excellent crack resistant
450 at a thickness of 1000 micron WFT per coat.
However, it will be necessary to make 2 coats to
Packing build up the desired thickness. Recommended build
up thickness is 2-3 mm for horizontal surfaces. Each

Available in 20 & 200 Ltr Drum.
coat must have a gap of minimum 4-6 hours
Approx. Coverage depending on the temperature. Reinforcement with
fabric enhances the durability and waterproof

Wet Film Thickness WFT
2
1 mm 2 m /ltr property.
Colour Black
Recommendations
Subject to chloride contents, provide protection board
Two coats
for coating performance and long lasting durability.
EuroProof LWP 450
Typical properties
Shelf Life
Elongation
ASTM D 412-75 > 800% Shelf life of 24 months is guaranteed when stored in
Hardness Shore A factory packed unopened containers in a cool dry

ASTM D 412-75 Ply Up Method 65 ± 5
and elevated place away from direct sunlight and at a
Resilience (Recovery %) o
ASTM D 412 temperature not more than 30 C.
@ 100% Elongation 100%
@ 200% Elongation 95% Warranty
EuroProof LWP 450 waterproof membrane is guaranteed

Crack Bridging ASTM C 186 1.5 mm by the manufacturer not to break down, deteriorate or
disintegrate under normal conditions usage for period of
Specific Gravity 1.03 ± 0.01 (10) years from the date of installation.
Rubber Content 15% Min.

Health and Safety
Solid Content >60 % Wear suitable protective clothing, gloves, eye
protection and respiratory protective equipment. The
Fibber Content 5% use of barrier creams provide additional skin
o
protection. In case of contact with skin, rinse with
Drying Time @ 35 C 2-4 hours plenty of clean water, then cleanse with soap and
water. In case of contact with eyes, rinse
Technical Service immediately with plenty of clean water and seek
EUROBUILD offers full technical support to medical advise.
specifiers, contractors and end users, as well as
technical assistance on site and after sales NOTE: The information supplied in our literature or given by our
employees is based upon extensive experience and, together with
consultations. that supplied by our agents or distributors, is given in good faith in
order to help you. Our Company policy is one of continuous
Limitations Research and Development; we therefore reserve the right to
update this information at any time without prior notice. We also
guarantee the consistent high quality of our products; however, as
EuroProof LWP 450 is not designed for and may not we have no control over site conditions or the execution of the
perform under the following conditions or work, we accept no liability for any loss or damage which may
circumstances. EuroProof LWP 450 is not to be arise as a result thereof.
used a finishing traffic surfaces. Do not apply on
excessively hot decks. Long term of continuous water
submersion does not affect EuroProof LWP 450
adhesion to the substrate. Under such conditions,
two-part epoxy primer is to be used prior to applying
the membrane.

450 Europroof LWP

Uploaded by

Copyright:

Available Formats

450 Europroof LWP

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

450 Europroof LWP

Uploaded by

Copyright:

Available Formats

EuroProof LWP 450

Bituminous Liquid Applied Membrane

EuroProof LWP 450 is Rubber/fibre reinforced,

EuroProof LWP cured film is an excellent waterproof

EuroProof LWP 450 is high viscous liquid applied

EuroProof LWP ideally suitable for waterproofing on:-

 Waterproofing on concrete and block

 Retaining Walls, Sub structure, ground floor

 Swimming Pools external waterproofing.

 Recommended for excess chloride content

 Recommended for submerged conditions

Advantages Application Instructions

 Excellent and permanent barrier for concrete or

All surfaces must be smooth, dry, firm and free of

expansion, contraction and movements. should be cured a minimum of 14 days (Preferably 28

 Highly water resistant. days) before applying membrane.

 High bitumen content provides long lasting and

applications with it’s self-levelling characteristics, and

However, it will be necessary to make 2 coats to

Packing build up the desired thickness. Recommended build

up thickness is 2-3 mm for horizontal surfaces. Each

Approx. Coverage depending on the temperature. Reinforcement with

fabric enhances the durability and waterproof

Hardness Shore A factory packed unopened containers in a cool dry

EuroProof LWP 450 waterproof membrane is guaranteed

Rubber Content 15% Min.

You might also like