Preliminary Specifications

Product Data Sheet

2ULPX206.12R-C
XXXX Pol Dual Band Twin Beam 2×698-960/2×1710-2690 33°/ 32° 16.5/20dBi 2-10°/2-10° Integrated
RET
Electrical Specifications
698-960(R1, R2) 1710-2690(Y1,Y2)
Frequency Range (MHz):
698-806 806-880 880-960 1710-1880 1880-2170 2300-2690
Gain (dBi): 15.2±0.5 16.1±0.5 16.5±0.5 18.5±0.5 19.3±0.5 20.0±0.5
Return Loss (dB): >14 (VSWR<1.5)
Polarization (°): ±45
Horizontal 3dB beamwidth (°): 2×35 2×32 2×30 2×32 2×28 2×25
Horizontal Beam Pointing (°): -29, +29 -27, +27 -25, +25 -29, +29 -25, +25 -23, +23
Vertical 3dB beamwidth (°): 19.0 18.0 16.5 8.0 7.5 6.3
Electrical Downtilt (°): 2-10Independently Continuously Adjustable
RET Type: RET Cascade SRET, AISG 2.0 ,Upgradeable
1st Upper Sidelobe Suppression (dB): 18 19 18 18 18 18
Upper Sidelobe Suppression,+30°(dB): 18 17 18 18 16 16
Front to Back Ratio @180°(dB): 30 30 28 28 30 30
Front to Back Ratio @180±30°(dB): 28 28 28 26 28 28
Isolation Between Polarizations (dB): >25
Power Rating (W): 300 250
Intermodulation IM3 (dBc): <-150 (2×43 dBm)
Impedance (ohm): 50
Lightning Protection: DC Grounded
Connector Type: 8×4.3-10 Female
BASTA Electrical Specification
Frequency Range(MHz): 698-806 806-880 880-960 1710-1880 1880-2170 2300-2690
Average Gain by all Beam Tilts (dBi): 15.0 15.8 16.2 18.0 19.0 19.6
Gain by all Beam Tilts Tolerance(dB): ±0.3 ±0.4 ±0.4 ±0.9 ±0.9 ±1.2
2°|15.2 2°|16.1 2°|16.3 2°|18.1 2°|19.3 2°|20.1
Average Gain by Beam Tilt (dBi): 6°|15.0 6°|15.8 6°|16.2 6°|18.0 6°|19.1 6°|19.6
10°|14.8 10°|15.6 10°|16.0 10°|17.8 10°|18.8 10°|19.4
Horizontal Beamwidth Tolerance(°): ±1.4 ±1.6 ±2.0 ±3.8 ±1.4 ±2.4
Vertical Beamwidth Tolerance(°): ±1.7 ±1.8 ±1.5 ±0.9 ±0.9 ±1.1
Upper Side Lobe Suppression, Peak to 20°(dB): 18 16 16 17 16 16
Frontto back Total Power at 180° ± 30°(dB): 28 27 27 28 29 31
CPR at Boresight(dB): 20 21 22 15 14 13

W:www.broad-radio.com E:info@broad-radio.com V1.0 2018/2/28 Our products are compliant to the EU

BROADRADIO is continually improving products. Specifications may change at any time without notice. Directive RoHS as well as to other
Page 1 of 2 environmentally relevant regulations.
 Preliminary Specifications
Product Data Sheet
2ULPX206.12R-C
Mechanical Data
Antenna Dimensions (mm): 1500×675×224
Packing Dimensions (mm): 1662×823×340
Antenna Net Weight/Bracket (kg): 41/6.1
Antenna Gross Weight (kg): 55
Radome Material: Fiberglass
Pipe OD (mm): 70-114
Mounting Kits (Included): BA.K.04.00005,Adjustable Downtilt 0-12°
Environmental Ratings
Humidity: 95%RH@+30℃
Temperature (℃): -40～+70
Wind Load @150 km/h (N): Frontal/Lateral/Rearside: 1577/229/1551
Max. Wind velocity(km/h) 200
Internal RET Specifications
RET type: Integrated RET
RET protocol: AISG2.0 /3GPP
Input voltage range(V): 10-30 DC
< 5 (motor activated , single RET)
Power consumption(W):
< 1 (stand by, single RET), < 1.5 (stand by, 12V)
Adjustment time (full range): (s): < 120 (typically, depending on antenna type)
RET connector: two pair of AISG 8 pin male & female
Pin assignment according AISG: 8-pin circular connector conforming to IEC 60130-9 - Ed. 3.0
Lightning protection (kA): 5 (8/20 μs Differential mode), 8 (8/20 μs Common mode)
Typical Patterns

(698-960MHz) (698-960MHz) (1710-2690MHz) (1710-2690MHz)

Azimuth(698-960MHz) Elevation(698-960MHz) Azimuth(1710-2690MHz) Elevation(1710-2690MHz)

W:www.broad-radio.com E:info@broad-radio.com V1.0 2018/2/28 Our products are compliant to the EU

BROADRADIO is continually improving products. Specifications may change at any time without notice. Directive RoHS as well as to other
Page 2 of 2 environmentally relevant regulations.