Hydroproof Xtra Waterproofing Chemicals

Hydroproof Xtra constructive solutions
Single component acrylic polymer for ce-

ment based waterproof composite coating
membrane
Uses Priming
Provides an effective and economical method of waterproofing Before application, the surface should be primed with Hydro-
to concrete and masonry surfaces, by mixing with cement and proof Xtra as follows:
application by brush. 1 part of Hydroproof Xtra : 2 parts of Water : 4 parts of Cement
Advantages
Mixed material with the above proportion will cover an area of
Non - toxic, non-flammable and user friendly 16-17m2 for 1L of Hydroproof Xtra.
Provides a tough, impermeable waterproof membrane Topcoat
Can be applied by brush, on horizontal and vertical surfaces Hydroproof Xtra acrylic polymer shall be mixed with neat ce-
ment in the ratio of 1:2 respectively, to obtain a uniform and
Excellent adhesion to concrete and masonry surfaces
consistent slurry avoiding any lump formation. This can be
Protects concrete and mortar from natural elements such achieved with a low duty, low speed drilling machine attached
as wind, rain, sunlight with a mixing paddle. Do not mix for more than 2 minutes. Do
not mix more material than which can be used within the pot
Breathable - allows inside water vapour to escape
life. Retempering the mix with water should not be done. Oc-
Description cassionally stirr the material till the entire quantity is applied, so
Hydroproof Xtra is formulated to be mixed with cement on site that solids do not settle at the bottom of the container.
or simply brush applied over concrete or masonry surfaces to
Mixing Ratio
provide an effective waterproof membrane.
Technical support Hydroproof Xtra liquid Neat cement
Fosroc provides a technical advisory service supported by a 0.5L 1 kg

team of specialists in the field. 1L 2kg
Areas of application
5L 10 kg
Below sloping screed or waterproof plaster on :
20L 40 kg
Roofs, terraces and balconies as a sandwich layer
For white colour - mix white cement, for other colours, add
Pools and fountains
cement compatible pigments to white cement.
Reservoirs and channels
Application
End walls subjected to rain
Properties For best results, wet the surface before coating. Apply the mix
with a short, stiff bristle brush like a paint to an approximate
Water absorption : 1% maximum thickness of 1 to 2mm. During the first 12 hours of curing,
Hydroproof Xtra surface must be protected from abrasion, rain
Pot life at 300C : 30 min.
or other adverse conditions. No traffic shall be allowed within
Application temperature : Not less than 100C 48 hours after application.
Toxicity : Non-toxic Normally 2 coats of application of Hydroproof Xtra are recom-

mended. First coat should be allowed to air dry for 5 - 6 hours.
Bond strength to concrete : Approx. 1 N/mm2
After application of the final coat, initial air drying shall be al-
Application instructions lowed for 2 to 6 hours. During this period water should not be
used for curing. Moist curing should be done for the next 24
Preparation hours by spraying water on Hydroproof Xtra coating. Following
All surfaces to be treated with Hydroproof Xtra must be thor- moist curing, Hydroproof Xtra should be allowed to dry for three
oughly cleaned by a wire brush or other mechanical means, to days before subjecting it to submersion in water.
remove all dust, laitence or debris. The surface must also be
Hydroproof Xtra
free from oil, grease, wax or any other form of foreign matter
which might affect adhesion. Spalled and deeply disintegrated
concrete or mortar must be removed to a sound substrate and
repaired suitably before coating.
page 1 of 2
Hydroproof Xtra
Estimating Precautions
Packaging Health & Safety
Available in 0.5, 1, 5 & 20 L packs. Hydroproof Xtra is water based and non-toxic. Gloves should
be worn during application. Any splashes on the skin or eyes
Coverage must be washed off with clean water. Incase of prolonged ir-
Priming coat - 16-17m2 / L. ritation medical advice should be sought.
Topcoat - 4.5 - 5.0m 2 / L / coat. Fire
However the practical consumption varies depending on the Hydroproof Xtra is nonflammable.
texture and porosity of the surface and the application thickness.
Storage
Hydroproof Xtra liquid has a shelf life of 12 months,when stored
in unopened containers under normal warehouse conditions.
Important note :
Fosroc products are guaranteed against defective materials and manufacture and are sold
subject to its standard terms and conditions of sale, copies of which may be obtained on
request. Whilst Fosroc endeavours to ensure that any advice, recommendation specification
or information it may give is accurate and correct, it cannot, because it has no direct or
continuous control over where or how its products are applied, accept any liability either
Fosroc Chemicals directly or indirectly arising from the use of its products whether or not in accordance with
any advice, specification, recommendation or information given by it.
(India) Pvt. Ltd.
Head Office telephone fax e-mail
“Sapthagiri Palace”, No.38,
II & III Floor, 12th Cross, ++91 80-42521900 ++91 80-23551510 enquiryindia@fosroc.com
CBI Road, Ganganagar North,
Bangalore 560 024
Regional Offices
Chennai Mumbai Noida Kolkata

No. 26(old no.33), 1st Floor, 1401/1402, 14th Floor, D-166 Sector 10 304, Jodhpur Park
1st Street Postal Colony, A-Wing’The Great Eastern Summit’ Dist. Gautam Budha Nagar, Kolkata 700 068
West Mambalam, Sector-15, CBD, Belapur Noida, Ph:033-65343188
Chennai 600 033. Navi Mumbai 400 614 UP 201 301 Fax: 033-2499-0280
Ph: 044-24899949-94 Ph: 022-43406800-04 Ph:0120-4270620-21
Fax: 044-24896641 Fax: 022-27562423 Fax: 0120-4270622
www.fosroc.com
page 2 of 2 INDIA/2014/0826/A

Hydroproof Xtra Waterproofing Chemicals

Uploaded by

Copyright:

Available Formats

Hydroproof Xtra Waterproofing Chemicals

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Hydroproof Xtra Waterproofing Chemicals

Uploaded by

Copyright:

Available Formats

Hydroproof Xtra constructive solutions

Single component acrylic polymer for ce-

Provides a tough, impermeable waterproof membrane Topcoat

Fosroc provides a technical advisory service supported by a 0.5L 1 kg

Toxicity : Non-toxic Normally 2 coats of application of Hydroproof Xtra are recom-

Packaging Health & Safety

Topcoat - 4.5 - 5.0m 2 / L / coat. Fire

Chennai Mumbai Noida Kolkata

You might also like