Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

TAM4 Manual

Download as pdf or txt
Download as pdf or txt
You are on page 1of 10

(Ver.

03/2022)

OWNER’S MANUAL
Under Sink Water Filtration System

Alkaline Remineralization
CONTENT

1. BEFORE INSTALLATION 01

2. PRODUCT INTRODUCTION 02

3.SAMPLE CONNECTION 03

4. INSTALLATION TIPS 03

5. INSTALLATION STEPS 04

6. REPLACEMENT FILTER 06

7. FILTER REPLACEMENT INSTRUCTION 06

8. FREQUENTLY ASKED QUESTIONS 07

9. LIMITED PRODUCT WARRANTY 07

10. WARRANTY REGISTRATION 08

If you have problems during the purchase or installation


process, please contact our customer service.
FOLLOW US @Frizzlife
Receive first-hand promiton info and be
www.frizzlife.com support@frizzlife.com the first one getting exclusive benefits.
Register to activate your warranty with Frizzlife.
Scan the QR code to register
Email us your order ID and full name at
support@frizzlife.com

Find the Installation Video


Search “Frizzlife TAM4 Installation” on www.youtube.com

1. BEFORE INSTALLATION
Inspect Box
Please take out the system and all the components from the box. Inspect
them carefully according to “Product Introduction”, and make sure nothing in
missing or damaged during shipping. If any parts are cracked or broken,
please do not proceed with installation, and contact Frizzlife for an exchange
or diagnosis.
Technical Parameters
Model No. TAM4 Dimension 4.9 x 6.1x 15 in
Replacement Filter FZ-4 Replacement Period 12 months

Min.20psi, Feed Water


Feed Water Pressure Min.39ºF,Max 100ºF
Max. 80psi Temperature

Applicable Water Source Municipal water (Recommended to treat with RO water)

Precautions
Do not use it with water that is microbiologically unsafe or of unknown
quality without adequate disinfection.
For cold water use only.
Do not freeze the filter, as this case cause cracking and water leakage.
Do not allow children under 3 years of age to have access to small parts
duringthe installation of this product.
Testing was performed under standard laboratory conditions, actual
performance may vary.
This installation must comply with all applicable state and local regulations.
Please flush water for 15 minutes for the first time usage.

01
2. PRODUCT INTRODUCTION

1 2 3 5

6 7 8

1 TAM4 Filter System 5 Wrench

2 FZ-4 Filter Cartridge (Pre-loaded) 6 Blade


3 1/4” Tubing 7 Mounting Screws
4 1/4” Quick Fitting 8 Elbow Fitting

02
3. SAMPLE CONNECTION

Existing main faucet

Outlet tubing

Inlet tubing

Cold TAM4
The RO
System

4. INSTALLATION TIPS

How to cut the tubing?

Please cut the tubing into two sections in proper length, make sure
cut them squarely and cleanly.

How to connect/disconnect the tubing?

To connect: Please push the tubing into the fitting and make sure it is
fully inserted. Then put the blue lock clip on the fitting, it
will lock the tubing in place.
To disconnect: Please remove the bule lock clip from the fitting, push in
the lock sleeve, and then pull out the tube from the fitting.

Note: If the tubing is not fully inserted, water leakage may occur.
Pulling out the tubing directly will damage the fitting, which
may also cause water leakage.

03
1. Insert to seal the connection 2. Remove to disconnect

Remove Press
blue clip

Remove

1.25 inch

5. INSTALLATION STEPS

Note: Please always use plumber tape on threaded connection parts


to ensure a watertight seal.

Step 1: Cut off both water supply and power supply


1.Please unplug the RO system
to cut off the power firstly.
2. Please turn off the angle valve
to cut off water supply.

Step 2: Connect RO system and TAM4


filter system
1. Please remove the small blue clip on
the "Inlet" side of TAM4 filter.

2.Connect the filtered water tubing from RO system to the "Inlet" side
of TAM4 filter, make sure it hits the bottom of fittings.

RO Water Inlet

04
3.Put back and lock the blue clip.

Please note that the elbow fitting is not a must for installation, you
do not have to use the elbow fitting if it is not necessary. Please make
sure the tubings are fully inserted, otherwise may result in water
leakage.

Step 3: Connect TAM4 filter system to dedicated faucet

1.Insert the 1/4” tubing provided into the “Outlet” port of TAM4 filter system
in the same way.

2.Connect the other end of 1/4” tubing from


“Outlet” port of TAm4 filter system to 1/4”
quick fitting.

Please cut the 1/4” plastic tubing provided in proper length firstly
if necessary.

Step 4: Check for leaks

1.Turn on the angle valve and check for leaks.


2.Connect the power supply.

Step 5: Flush the TAM4 filter 15 min


1.Please flush the system for 15-20
minutes before starting to use.

TDS result after TAM4 filter system will be higher than result directly from
RO system. This is normal as TAM4 filter remineralizes the RO water.

Note: Please make sure tubings are FULLY inserted


into the ports, otherwise water leakage may occure.
1.25 inch

05
6. REPLACEMENT FILTER
The Frizzlife Under Sink Water Filter System requires care and cleaning after a
period of time. It is recommended to change the cartridge according to
corresponding time intervals in the table below. If the system has been work-
ing properly and the filtered water output is slowing down, it may be time to
change the filter cartridge.

System Model No. Replacement Filter No. Filtration Capacity


TAM4 FZ-4 12M

Note: All the service life of the filter cartridge listed are based on
actual laboratory test and the provided water. The actual service life
of filter cartridge depends on source water quality and daily water
usage.

7. FILTER REPLACEMENT INSTRUCTION

Note: With the ATUO Shut off design of the system, you do not need
to shut off the water supply when doing the replacement.

Step 1: Twist the housing clockwise

Step 2: Using the wrench to unscrew


the housing body

Step 3: Take out the old cartridge and


load with new one, then install back in
the same way
Change

Step 4: Flush the new cartridge for 15


minutes before starting to use

06
8. FREQUENTLY ASKED QUESTIONS
Q: What should I do if water leaks after installation?
A: If once installed the system should leak, please shut off water supply firstly. If
the leaking occurs at the thread, please wrap plumber tape on the external thread.
Please contact Frizzlife customer service team for solutions if the water leakage
persists.

Q: Why TDS result goes up after TAM4 filter?


A: TDS result after TAM4 filter system will be higher than result directly
from RO system. This is normal. Because RO systems remove the minerals together
with harmful contaminants, but now TAM4 post filtration adds these minerals back
to your drinking water.

Q: When should I replace the filter cartridge?


A: The recommended service life of FZ-4 filter cartridge is 12 months. Please note all the
service life of filter cartridge listed are based on actual laboratory test and the provided
water. The actual service life of filter cartridge depends on feed water quality and daily
water usage.

9. LIMITED PRODUCT WARRANTY

TAM4 Under Sink Alkaline Remineralization Filter System Warrantor: FRIZZLIFE INC

ONE YEAR LIMITED FRIZZLIFE WARRANTY


The Frizzlife TAM4 Under Sink Alkaline Remineralization Filter System are warranted to the
original purchaser. To be free of defects in material and workmanship by FRIZZLIFE INC,
FRIZZLIFE will replace or repair components of the unit that Frizzlife has deemed to be
broken within the limits of the warranty without charge. The customer is not responsible
for any freight involved with shipping the item back for inspection and shipment of
replacement for items. Frizzlife is not liable for cost of removal, installation, transportation
or any other charges in connection with a warranty claim.

Customer must register their systems with Frizzlife within 90 days of purchase in order to
obtain a warranty. Warranty will discontinue after the unit is removed from the location
where it was originally installed. Warranty begins on the date of delivery of product to
the customer.

07
Owner’s Warranty Responsibility:
As a condition of this Limited Warranty, the owner must ensure that periodic
maintenance of the system is performed as described in the literature enclosed with
the system. Should your unit develop a defect or otherwise fail to perform in
accordance with this warranty, you should contact the retailer from whom the product
was originally purchased.

1. Frizzlife is not liable for anything that we deem as abuse of the units, including
but not limited to, misuse of product outside of intended use, equipment modifications,
unauthorized repairs, improper installation, damage from freezing, hot water, fire or
other acts of God outside of Frizzlife control.

This warranty will be void if defects occur due to failure to observe the
following conditions:

Incoming water to the the system cannot exceed 100°F.


Do not use outdoors or in a location that is subjected to direct sunlight or freezing.
This warranty will not be effective unless and until the Frizzlife is shown to have
been used in accordance with the installation and maintenance instructions
accompanying the product.
The filter cartridges should be replaced in time according to the recommended
replacement period.
The plastic housings should be replaced every 18 months.
2. Filter Cartridges are considered as disposable items, thus are not covered by
warranty.
3. Customer is responsible for proper operation, which includes complete and
continual leak inspection.

Most of the unit components are made of plastic and eventually can break
or crack from stress.
There are no other warranties which extend beyond what is described above.

10. WARRANTY REGISTRATION

150% EXTENDED WARRANTY


1.Email us you order ID and full name at
support@frizzlife.com within 90 days.
2.Scan the QR code below to register

If you have any questions, any suggestions, or you need any assistance, please free
to contact us anytime at support@frizzlife.com.

Your satisfaction is always our top priority!

08

You might also like