Portable FID

Portable FID
For Method 21 and Environmental Monitoring of VOCs including methane

Ambient Air, Chemical & Petrochemical Industry, Leak detection Stacks, Laboratories, Remediation Sites, Landfills
Model 115 Snap On FID Model 115 Snap on FID
Model 115 with fuel cylinder
Leak Detection (EPA Method 21), Stacks, Area Monitoring, Effluents
Model 115 PORTABLE FID
INTRODUCTIONPID Analyzers acquired HNUs technology including Portable PIDs, FID's Laboratory Instruments and Continuous Monitors. HNU introduced the first commercial photoionization based instrumentation. Nearly 40,000 of the portable and and laboratory PIDs have been sold throughout the world. Many United States Environmental Protection Agency and Occupational Safety & Health Administration (OSHA) methods have been published in the Federal Register.
Snap On FID- easy to interchange modules-just snap on to the Docking Module and the instrument is ready for calibration in seconds. No cables or wires to fuss with.
Chemicals Detected Principle of Operation VOCs, hydrocarbons, methane, ethane, propane, benzene, TCA, methylene chloride, 1.3 butadiene ... Extended Range- (linear) From 1 ppm to 30,000 ppm for DL115-FID for EPA Method 21 for leak detection Fast response <3 seconds to 90% Wide dynamic range (16 bit ADC) ppm to % Library- >200 compounds Excellent stability (zero & span) Alphanumeric display- pt. #, units, mode Other snap on detectors for CO, NH3, H2S, CH4, SO2, NO, Cl2, H2 ...- available now
The process of burning a hydrocarbon in a hydrogen flame generates positive (carbon) ions. An accelerator electrode (positively biased) pushes the ions, to the collector electrode where the current generated (proportional to concentration) is amplified and displayed on the digital meter.
FEATURES
Durable & Rugged More than 25,000 HNU portable PIDs (101s) have been sold worldwide since HNU introduced the first PID in 1974. More than 90% of these instruments are still working today. These instruments are the most rugged and durable instruments on the market today. They do not require replacement every two to three years. Accurate Results HNUs unique FID design, state-of-the-art electronics and microprocessor control ensures the most accurate results for VOC measurements. Zero HNUs unique automatic zero with zero gas provides a reliable calibration point so that when calibrated with a span gas, this is a two point calibration. Easy to Maintain HNUs new DuracleanTM FID is more inert and will run for longer periods without the need for cleaning the FID head or the ion chamber In addition, a new library of compounds > 200 is available for selection by the customer.
APPLICATIONS
Non-specific- 115- Responds to all VOCs including methane Headspace- VOCs in soil or water Quality control- residual monomer in resins, residual solvents in paper or food, testing gas masks... EPA Method 21- to 30,000 ppm Emergency response- spills from trucks & trains Fugitive emissions- leak detection Arson investigations- find trace accelerants Confined space entry- health & safety
Controls On/off Bkl- Backlight Incr Decr Menus Log Cal Options Dilution probe (10:1) extends range to 30,000 ppm ppb Readout Carrying case Calibration kit RS232 & downloading software Belt clip for holding 102 via strap Specifications Single unit construction 12.0" L x 3" W x 5"H- includes fuel cylinder Weight 5.5 pounds Simple 3 button operation No keyboard Easy to use even for unskilled operators Library of sensitivities built in for > 200 compounds Use Resp as to setup for direct reading Alphanumeric display for compound, detector, alarm, range, & logging Linear to 30,000 ppm Bright LCD digital display for readability/backlighting selectable Fast response 3 sec to 90% Datalogging for 7,000 points Wide dynamic range FID- >6 decades RS232 output Auto zero in Cal, background zero Simple pushbutton sensitivity control Reliability The basic simplicity, durable construction and design of the Model 102 has resulted in the elimination of problem areas associated with many measurement techniques. Other InstrumentsPID Analyzers manufactures continuous monitors such as: FIDs & PIDs for total hydrocarbons, NDIRs for CO, CO2, CH4, N2O NO SO2 and hydrocarbons, & Process GCs. Additional products include portable PIDs, portable GCs laboratory GCs, add-on detectors and XRF instruments
Controls for the Model 115

On/Off- Battery power Incr-Function ON, scrolling menu up, increase number Decr-Function OFF, scrolling menu down, decrease number Bkl-Turns backlight on/off Menus Log Manual-Set site #, and manually log each pt. Auto- Set ave. time (sec) and samples/hr. to Auto log Site # 1-7000 Setup- Setup Auto; Ave. time sec., samples/hour ExitReturn to Run Cal CalPerforms zero, set cal value, calibration Bkg ZeroCal Gas- Select name of cal gas Resp as- Once the 115 is calibrated-change to direct reading on any of > 200 compounds Alarm- Set Alarm value for audible alarm ExitReturn to Run mode Datalogging The 115 has manual or automatic datalogging capability for up to 7,000 points. The software for data logging is included with the Model 102. IT uses Windows Hyperterminal for downloading the information for the 102. A typical Auto datalogging fromat is shown below:
102 Data From Hyperterminal Date Time SP6 6/12/2004 15:02:27 7 SP6 6/12/2004 15:03:27 7 SP6 6/12/2004 15:04:27 7 SP6 6/12/2004 15:05:27 7 SP6 6/12/2004 15:06:27 7 SP6 6/12/2004 15:07:27 7 End Of Log Data
Site 495 496 497 498 499 500
ppm 1.7 1.6 1.6 1.6 1.6 1.6
This data cab be imported directly into Excel as Tab Delimited ASCII.
SNAP ON HEADS
There are more than 20 sensors available for the HNU Snap On Head. Each head has a PID (except for the FID head). Three additional sensors can be added to an FID. These include a choice of the following sensors: Electrochemical (choice of 12),Infrared (choice of 2), RH/T (combined 2 sensors), and TCD Typical Applications include:
Indoor Air Quality- PID/RH/T/CO2 Confined Space- PID/LEL/O2/CO Leak Detection- PID/LEL, FID Wastewater tmt.-PID/H2S Chemical Plant- PID/Cl2 Pulp & Paper- PID/H2S Combustion leaks- PID/CO, FID/CO
Sensors for the Model 115 Snap On Head

There are more than 20 sensors available for the Model 115. A PID or FID and any three sensors can be incorporated into the head.
Table I Specifications of Gas Sensors for the Model 115 Range ppm Det. Limit Response Time Interferences 0-30,000 0-500/1000 0-10 0-1000 0-100 0-100 0-100 0-50 0-20 0-30% 0-20 0-3000 0-3000 0-100% 0-2% 0-100% 0-600C 1ppm 1/2 0.1 2 0.1 0.1 0.1 0.1 0. 0.1% 0.1 1 0.1 1% 0.04% 0.1% 0.10C 0.5 % 3 sec. resp. to all VOCs incl CH4 15 sec. 30 sec. 45 sec. 50 sec. 1.5 min. 20 sec. 10 sec. 15 sec 15 sec. 20 sec. 25 sec. 15 sec. 20 sec. 20 sec. 50 sec 20 sec. 30 sec. H2, C2H4 ----CO, C2H4 C2H4, H2S, SO2 --------NO2 Cl2, H2S ----NO2 vol. org acids vol. amines ----------------NA
Analyzer FID FID Electrochemical Carbon Monoxide Chlorine Hydrogen Hydrogen Cyanide Hydrogen Chloride Hydrogen Sulfide Nitric oxide Nitrogen dioxide Oxygen Sulfur dioxide Carbon dioxide Ammonia Infrared LEL Carbon dioxide RH/Temperature Relative humidity Temperature
TCD* Organic cpds 0-100% _________________________
Not available with PID in head at the same time PID Analyzers, LLC 780 Corporate Park Drive Pembroke, MA 02359 T 1 781 709 2131; F 1 781 709 2050

Portable FID

Uploaded by

Copyright:

Available Formats

Portable FID

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Portable FID

Uploaded by

Copyright:

Available Formats

Portable FID

For Method 21 and Environmental Monitoring of VOCs including methane

Model 115 Snap On FID Model 115 Snap on FID

Model 115 with fuel cylinder

Leak Detection (EPA Method 21), Stacks, Area Monitoring, Effluents

Model 115 PORTABLE FID

Controls for the Model 115

Site 495 496 497 498 499 500

ppm 1.7 1.6 1.6 1.6 1.6 1.6

Sensors for the Model 115 Snap On Head

TCD* Organic cpds 0-100% _________________________

You might also like