Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Benq Rs232 Code: Model: Mp512 / Mp513 / Mp522

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

BenQ RS232 Code

Model: MP512 / MP513 / MP522


1. Connection : The below shows the illustration of connection between control terminal and projector.

<Pin assignment: P1 and P2> Pin 1 3 5 7 9 Description NC TXD GND RTS NC Pin 2 4 6 8 Description RXD NC NC CTS

1 6

2 7

3 8

4 9

Make sure that your computer and projector are turned off before connection. Power on the computer first, and then plug the power cord of the projector. (It may cause Com port incorrect function, if you do not follow this instruction) Adapters may be necessary depending on the PC connected to this projector. Please contact with your dealer for further details. 2. Interface Setting : Baud Rate 115200 bps (default) Changeable(2400/4800/9600/14400/19200/38400/57600/115200) Setting in OSD menu 8 bit None 1 bit None

Data Length Parity Check Stop Bit Flow Control

3. RS232 Commands Function Power Type Write Write Read Source Selection Write Write Write Read Picture Setting Write Write Read Write Write Read Write Write Write Operation Power On Power off Power Status Analog RGB Composite S-Video Current source Contrast + Contrast Contrast value Brightness + Brightness Brightness value Aspect 4:3 Aspect 16:9 Aspect Auto ASCII <CR>*pow=on#<CR> <CR>*pow=off#<CR> <CR>*pow=?#<CR> <CR>*sour=RGB#<CR> <CR>*sour=vid#<CR> <CR>*sour=svid#<CR> <CR>*sour=?#<CR> <CR>*con=+#<CR> <CR>*con=-#<CR> <CR>*con=?#<CR> <CR>*bri=+#<CR> <CR>*bri=-#<CR> <CR>*bri=?#<CR> <CR>*asp=4:3#<CR> <CR>*asp=16:9#<CR> <CR>*asp=AUTO#<CR>

Function Picture Setting

Type Write Write Write Read Write Write Read Write Write Write

Operation Aspect Real Blank On Blank Off Blank Status Freeze On Freeze Off Freeze Status Zoom In Zoom out Auto Lamp Hour Normal mode Economic mode Lamp Mode Status Menu On Menu Off Up Down Right Left Enter

ASCII <CR>*asp=REAL#<CR> <CR>*blank=on#<CR> <CR>*blank=off#<CR> <CR>*blank=?#<CR> <CR>*freeze=on#<CR> <CR>*freeze=off#<CR> <CR>*freeze=?#<CR> <CR>*zoomI#<CR> <CR>*zoomO#<CR> <CR>*auto#<CR> <CR>*ltim=?#<CR> <CR>*lampm=lnor#<CR> <CR>*lampm=eco#<CR> <CR>*lampm=?#<CR> <CR>*menu=on#<CR> <CR>*menu=off#<CR> <CR>*up#<CR> <CR>*down#<CR> <CR>*right#<CR> <CR>*left#<CR> <CR>*enter#<CR>

Lamp Control

Read Write Write Read

Menu Control

Write Write Write Write Write Write Write

NOTE :
Note1: If the command format is illegal, it will echo Illegal format. Note2: If the command is not supported, it will echo Unsupported item Note3: If the command is disabled, it will echo Block item Note4: All the echo text will be same with the command you execute except query command.

You might also like