Medical Gases. Piped and Cylinder Training. Aim Understand The Reasons For Medical Gas Training

Medical Gases.
Piped and Cylinder

Training
Aim
Understand the reasons for medical gas training
Define a medical gas.
To Identify Medical gases in common use and their
application
To Understand the hazard warning signs and safety
information
Understand how to safely move and store medical
gas cylinders.
Have an understanding of the types and uses of
Piped gases
Reasons for training

You are required to undertake this training under;
The Health and Safety at Work etc Act 1974.
Control of Substances Hazardous to Health
(COSHH) and
HTM02-01
Which state that to enable you carry out your
duties safely and effectively you must be trained
in the safe use and hazards involved in all
aspects of your job.
What is a medical gas?

Any gaseous substance that meets medical
purity standards and has application in a
medical environment,
e.g. oxygen, nitrous oxide and air.
Medical Gases at KHT:

What are they?
What is their use?
Oxygen
Entonox
Air
Heliox
Nitrous Oxide
Carbon Dioxide
Oxygen (O2) Black with white shoulders

Within the hospital environment oxygen
is usually found in 3 main areas
Critical care areas
Operating theatres
Most wards, A&E & treatment therapy
areas
In most areas the oxygen service is
piped. Cylinder oxygen is normally
used as an emergency back up and
for patient transport/transfer.
Oxygen therapy must be prescribed,
or used as per local policy as oxygen
is classified as a drug.
Entonox (50% N2O / 50% O2 )Blue with

Blue & White Quartering
Entonox can be used for short term
relief for procedures involving pain.
Common areas who use Entonox are
Midwifery
A&E
Doses may be self regulated in nearly
all cases by the use of a mouthpiece
connected through the demand valve
to the Entonox cylinder
Air (21% O2 /79% N2)Grey body with black &

white shoulder quartering
Medical air is used:
In anaesthesia as a carrier gas
for volatile anaesthetic agents
For drug delivery through
nebulisation.
In ventilators and incubators to
provide uncontaminated and
controlled air flows.
Heliox( 21%O2 /79%He), Brown with white

quartering
Heliox is a mixture of helium and
oxygen and is often used in
emergency situations where upper
or lower airways are partially
obstructed, but may also be used
within an intensive care setting for
those patients receiving both
invasive and non invasive
ventilation.
Heliox should be administered via
appropriate equipment calibrated
for the gas mixture.
Nitrous Oxide (N2O) All Blue

Nitrous Oxide is used:
As an inhalation anaesthetic as
part of a balanced maintenance
of a General Anaesthetic.
Only medical personnel trained in
the appropriate techniques
should administer nitrous oxide.
Carbon Dioxide (CO2) All grey green

Carbon dioxide is insufflated into
the abdominal cavity to distend it
to allow investigation &
treatment of intra abdominal
disease and for laparoscopic
surgery.
Carbon dioxide should only be
given under the direct
supervision of a clinician.
Common Medical Gas cylinders by

size used in KHT
In order from left to
right:
CD (Oxygen)
E
F
G
How to Order Medical Gas

Cylinders
Contact ISS Help desk on Extension 2245
You will need to provide them with the size and
type of Medical Gas cylinder you require.
The system relies on an old for new basis, so
when the Porters deliver they will expect to pick
up any empty cylinders.
Patient Transfers Around Hospital

Contact Help Desk on extension 2245
State if Oxygen is required for transfer.
The porters will bring a cylinder and on
completion of transfer take the cylinder
back. Porters are not responsible for turning
cylinders on or adjusting flow rates.
The approximate consumption rate of a CD
cylinder at 5L per min is 1.5hrs.
Hazard Warning Signs associated

with Medical Gases
Oxidisation.
Storage pressure
Temperature
Ability to asphyxiate
Oxidisation
Gases if released will
Increase the levels of
oxygen in the atmosphere
and will support and
increase the rate of
combustion
Storage pressure
The stored pressure in a
medical gas cylinder can
be up to 300 bar, which is
150 times greater than
your car tyre.
It is essential that
Cylinders are stored
correctly in a well
ventilated area and not
exposed to extremes of
temperature
Temperature
The storage temperature

of certain gases can be
below minus 180 degrees
Celsius
Ability to asphyxiate
Gases stored in liquid
form can expand up to
800 times its volume and
cause oxygen deficient
atmospheres.
Where to find Safety Information

Cylinder collar
Product &
cylinder size
bar code
Cylinder size
code
Hazard warning diamonds
UNSI number
Batch Label to be
affixed here
Max cylinder pressure
in bar
Cylinder collar labels give important safety and usage information, as well
as confirming the identity of the cylinder contents. They should ALWAYS be
checked before a cylinder is used and should NEVER be removed.
Cylinder collar
Name, chemical symbol,
pharmaceutical form
of product
Safety information
Nominal contents
in Litres
Directions for use, storage

and handling precautions
The contents stated on the cylinder collar should correspond with the colour
of the cylinder.
It is NOT sufficient to assume that the colour coding of the cylinder
accurately reflects the contents.
Quality Control Batch Label

FILL PLANT
1028
BATCH NO.
041h8323
EXPIRY DATE
31.05.07
G
OXY
BOC Medical gases have a 3 year shelf life

and should not be used after the expiry date.
Safety
Moving and Handling

and
Storage
Moving and Handling
It is important to adhere to manual

handling techniques when moving
cylinders.
When moving cylinders with working

equipment (and possibly patients)
attached, particular care must be
taken to ensure that cylinders and
equipment are secured to the trolley,
bed or wheelchair in order to prevent
inadvertent disconnection and
possible loss of supply. If the gas is
not being used, the cylinder valve
should be closed.
Storage
HTM 02-01 and HTM 05-03 set out storage requirements
and these are summarised below.
Storage is divided into two types, a MAIN store and smaller
units, situated in convenient locations around the hospital
and known as READY TO USE stores.
In addition to this you will have areas on your ward where
one or two cylinders will be held, ready for administration to
a patient, this we would refer to as a cylinder parking area.
Where ever medical gases are stored, they should be on
their own and away from any other flammable gases or
other materials.
Piped Gases:
The medical gases are delivered to localised delivery points which
are gas specific and easily identified.
The localised delivery point, referred to as the outlet point, or
sometimes the 'terminal unit', are normally wall mounted. In places
like theatres or the intensive care they can sometimes be installed
within ceiling mounted pendant assemblies or beams.
It should be possible to operate the outlet point (engage and
release) with one hand. To prevent the wrong gas being given to the
patient each gas type has a gas specific connection and therefore it
cannot accept any probe for which it has not been designed.
Under no circumstances should you attempt to force a wrong
connection which could cause damage to the equipment and result
in malfunction or leakage.
Gas Outlet arrangement

Medical gas outlets are always
arranged in the same order
from left to right and are
identified by colour and the
name of the gas. In addition
they should also bear the
name of the manufacturer and
the relevant standard to which
they were manufactured.
Either BS5682 or more latterly
BS EN 737, and a CE mark,
indicating that they are a
medical device.
FLOW METERS
Before using flow meter check for no
signs of damage, loose connections
or dirt or grease
Flow meters can be obtained from
Clinical Engineering and departments
crossed charged.
To set flow turn knob anti clockwise
until ball rises to the flow rate
required, watch for 2-3 seconds to
ensure flow rate maintained, the ball
should sit in the middle of the required
rate
When not in use the flow of gas must
be turned off by turning knob
clockwise and the ball falls to zero.
Flow meters should be operated by
qualified nursing/medical staff
Types of piped gases
Oxygen
Air
Suction
Oxygen
Oxygen therapy must be
prescribed, or used as per
local policy as oxygen is
classified as a drug.
All bed spaces with
access to piped oxygen
should have a flow meter
in situ so it can be used if
necessary
When oxygen is not in use
flow meters should be
switched off
Air
Air is used for drug
delivery through
nebulisation.
Unless air being used
flow meters should NOT
be kept in piped air
outlets as they could be
confused for oxygen
Suction
There are many different
types of suction
regulators, High flow, Low
flow, Intermittent flow and
as many different
manufacturers, and all
have different methods of
operation and clinical
uses.
Suction regulators are
designed to control the
level of vacuum to the
patient.
Summary
Remember :
The types and uses of both piped and cylinder
medical gases.
How to safely move and store medical gas
cylinders.
The process for ordering gas cylinders and
How to identify and find safety information for
medical gases.
Question 1
How do we order cylinders?
Contact the porters
Contact ISS help desk
Contact pharmacy
Answer: Contact ISS help desk. They will swap cylinders

on a like for like basis
Question 2
How should cylinders be stored?
At the end of patients beds
In a locked cupboard
Upright in a designated parking area
Answer: Upright in a designated parking area
Question 3
Can you identify three pieces of information
that is identified on a cylinder collar?
Expiry date
Department contact details
Hazard warnings
Contents
Cylinder start date
Answer: Expiry date, Hazard warnings, Contents

Medical Gases. Piped and Cylinder Training. Aim Understand The Reasons For Medical Gas Training

Uploaded by

Copyright:

Available Formats

Medical Gases. Piped and Cylinder Training. Aim Understand The Reasons For Medical Gas Training

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Medical Gases. Piped and Cylinder Training. Aim Understand The Reasons For Medical Gas Training

Uploaded by

Copyright:

Available Formats

Medical Gases.

Piped and Cylinder

Reasons for training

What is a medical gas?

Medical Gases at KHT:

Oxygen (O2) Black with white shoulders

Entonox (50% N2O / 50% O2 )Blue with

Air (21% O2 /79% N2)Grey body with black &

Heliox( 21%O2 /79%He), Brown with white

Nitrous Oxide (N2O) All Blue

Carbon Dioxide (CO2) All grey green

Common Medical Gas cylinders by

How to Order Medical Gas

Patient Transfers Around Hospital

Hazard Warning Signs associated

The storage temperature

Where to find Safety Information

Hazard warning diamonds

Directions for use, storage

Quality Control Batch Label

BOC Medical gases have a 3 year shelf life

Moving and Handling

Moving and Handling

It is important to adhere to manual

When moving cylinders with working

Gas Outlet arrangement

Types of piped gases

Answer: Contact ISS help desk. They will swap cylinders

Answer: Upright in a designated parking area

Answer: Expiry date, Hazard warnings, Contents

You might also like