Minor Project PPT Solar

CONTENT
• INTRODUCTION
• HISTORY
• CLASSIFICATION
• DESIGN OBJECTIVE
• BASIC CONCEPT
• COMPONENT
• ASSEMBLING AND MANUFACTURE
• COST ANALYSIS
• CONCLUSIONS
• REFERENCES
INTRODUCTION
• Distillation is one of many processes available for water purification, and

sunlight is one of several forms of heat energy that can be used to power
that process.
• Solar Distillation is by far the most reliable, least costly method of 99.9%
true purification of most types of contaminated water especially in
developing nations where fuel is scarce or too expensive. Solar distillation
is used to produce drinking water or to produce pure water for lead acid
batteries, laboratories, hospitals and in producing commercial products
such as rose water.
• Conventional boiling distillation consumes three kilowatts of energy for
every gallon of water, while solar distillation uses only the free pure power
of the sun.
HISTORY
• Father of solar distillation,

Carlos Wilson, the creator
of the first known
application of solar
distillation, built in Las
Salinas (The Salts), Chile in
1872
• First documented
account of solar
distillation use for
desalination was by
Giovani Batista Della
Porta in 1958
CLASSIFICATION
SOLAR DISTILLATION
Active Passive
Active – extra thermal energy is

fed to the water to
create faster rate of
evaporation.
Passive – takes place by direct
sunlight.
DESIGN OBJECTIVE OF AN
EFFICIENT SOLAR STILL
 For high efficiency the solar still should maintain:
 a high feed (uninstalled) water temperature
 a large temperature difference between feed water and condensing
surface
 A high feed water temperature can be achieved if:
 a high proportion of incoming radiation is absorbed by the feed water
as heat. Hence low absorption glazing and a good radiation absorbing
surface are required
 heat losses from the floor and walls are kept low
 A large temperature difference can be achieved if:
 the condensing surface absorbs little or none of the incoming radiation
 condensing water dissipates heat which must be removed rapidly from
the condensing surface .
BASIC CONCEPT
The basic concept of are simple yet effective ,solar water

distillation solar still has a top cover made of glass, with an
interior surface made of a waterproof membrane. This
interior surface uses a blackened material to improve
absorption of the sun's rays. The glass cover allows the
solar radiation (short-wave) to pass into the still.
Purified drinking water is collected from the output

collection port.
 The sun's energy heats water to the point of evaporation.
As the water evaporates, water vapor rises, condensing
on the glass surface for collection.
 This process removes impurities such as salts and heavy

metals as well as eliminates microbiological organisms.
• Energy transfer from
basin to cover occurs by
evaporation-
condensation in addition
to convection and
radiation.
• output is measured by
the evaporation-
condensation transfer
Component of solar water distillation
1 Supply fill port :

Water should be added to the still via this port. Water can be
added either manually or automatically. Care should be taken
to add the water at a slow enough flow rate to prevent
splashing onto the interior of the still glazing or overflowing into
the collection trough.
2. Over flow port :

Once the still basin has filled, excess water will flow out of this
port. Sol Aqua recommends three times daily distilled water
production to be allowed to overflow from the still on a daily
basis to prevent salt build-up in the basin.
Basic concept of Solar Water Distillation
3. Distilled output collection port :
Purified drinking water is collected from this port, typically
with a glass collection container. Stills that are mounted on
the roof can have the distillate output piped directly to an
interior collection container.
4.Glass cover :
A solar still has a top cover made of glass The glass cover
allows the solar radiation (short-wave) to pass into the still,
The cover on the top is made of tempered glass so that the
birds can’t see their reflection and hence avoid nuisance.
5. Insulation :
The side and bottom walls need to be insulated. This can be
achieved by using multilayered insulator. Glass wool will be
sand-witched between two metallic plates. This will ensure
negligible heat loss to the surroundings.
6.Basin :
it is Aluminum box which fill with water (in liquid and vapor
forms). . Three boards are required for the construction a
solar still with base dimensions of .50x1 m, with a 20º
inclined slope glazing. The side height is .25 m.
BASIN
c
8.WATER PRE-
HEATER:
we are using water
preheater for increasing the
feed water temperature
It consist copper tubes in a
parallel manner and
parabolic shaped reflective
coating mirrors.
Assembling and manufacture
Fabrication of the whole unit is pretty straight forward and

involves metal cutting, welding, glass cutting, sealing,
painting and drilling. All these processes can be done at
any local workshop using simple machines – lathe, drill,
welding, milling etc.
• The steps in the process of assembling are outlined as
follows:
1. The outer box will be fabricated first. It will be made of
double wall and will be filled with glass wool to provide
insulation.
2.The stages will be fabricated second the collector holes
will be made at the time of fabrication. Finally the stages
will be assembled inside the outer covering.
3. The collector tubes are then made and attached to the
lowermost stage.
4. The holes are provided for
a.Collecting distilled water
b.Transporting saline water
c.To attach the pump
5. The whole system is sealed using sealant to
prevent the air from leaking in from the
atmosphere.
6. Preheater out put port is connected to the inlet

port of the basin with proper insulation.
Cost Analysis
Total cost of Aluminum box = Rs2700

carbon black paint = Rs200
Cost of tempered glass = Rs800
Cost of Reflector = Rs500
Cost of insulation and sealing = Rs 250
Cost of copper tube =Rs400
Cost of the hoisting mechanism and other
auxiliaries=Rs500
Cost of other parts = 400
Net cost of the Project = Rs 5750

CONCLUSIONS
Solar energy technologies and its usage are very important

and useful for the developing and under developed countries
to sustain their energy needs. Following are the important
conclusions drawn from the above:
 The simple conventional solar still is more economical than
active solar distillation
 system to provide drinking for the domestic applications.
 A single sloped solar still receives more radiation than a
double sloped solar still at low and high altitude stations.
 Solar still productivity mainly depends on temperature
difference between water and glass.
 The hourly yield is only possible in the active mode of
operation and hence commercially viable.
References
1)BOOK-Renewable Energy Sources By G.D.Rai
2)http://en.wikipedia.org/wiki/Solar_still
3)http://www.solaqua.com/solstilbas.html
4)http://practicalaction.org/solar-distillation-1
5)http://www.motherearthnews.com/Renewable-Energy/1974-09-
01/How-To-Build-and- Use-A-Solar-Still.aspx
6)http://www.desertusa.com/mag98/dec/stories/water.html

Minor Project PPT Solar

Uploaded by

Copyright:

Available Formats

Minor Project PPT Solar

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Minor Project PPT Solar

Uploaded by

Copyright:

Available Formats

CONTENT

• Distillation is one of many processes available for water purification, and

• Father of solar distillation,

Active – extra thermal energy is

The basic concept of are simple yet effective ,solar water

Purified drinking water is collected from the output

 This process removes impurities such as salts and heavy

1 Supply fill port :

2. Over flow port :

Fabrication of the whole unit is pretty straight forward and

6. Preheater out put port is connected to the inlet

Total cost of Aluminum box = Rs2700

Net cost of the Project = Rs 5750

Solar energy technologies and its usage are very important

1)BOOK-Renewable Energy Sources By G.D.Rai

You might also like