Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

5G Introduction

Download as pptx, pdf, or txt
Download as pptx, pdf, or txt
You are on page 1of 27

5G Introduction

Examples of use case evolution and supporting network


technologies.
Beamforming
Commom Beamforming
Supported Baseband Hardware
— The NR NSA may be deployed on the following
Baseband units:
— eNB: Baseband 5216/5212/6630/6620

— gNB: Baseband 6630


Supported Radios and Bands
Low band: ERS radios

Midband:
AIR 6488 B42D 3,500-3,600 MHz
AIR 6488 B42F 3,420-3,600 MHz
AIR 6488 B43 3,600-3,800 MHz

Highband:
AIR 5331 37-40 GHz

For more information on different bands, please refer to link:


http://niviuk.free.fr/nr_band.php
Midband AIR(macro) and DOT(small)
NR RADIO – AIR 6488
—NR Radio AIR 6488 B42D
— IWD = 100 MHz (3500-3600MHz)
— Supports n77/n78
- 20,40,60,80,100 MHz
— DATA –3x SFP+, eCPRI (10.3 Gbps line rate on
C2)
— 1 eCPRI sufficient
— 3 eCPRI recommended (future capacity / support max
specified layers)

— Power consumption : Peak: 1600W, Typical 50%


traffic 70% downlink / 30% uplink: 1000W
5G Modes - SA and NSA
— There are two modes of 5G :
— StandAlone (SA)
— Non Stand Alone (NSA)
— Currently, only Non StandAlone (NSA) is used.
— SA configuration does not need eNB, whereas,
in NSA eNB acts as the Anchor.
— In NSA, Control plane is handled by eNB and
gNB is used only for User Plane.
— The UE initially attaches to eNB and later if
certain conditions are met, connection is
reconfigured to attach with gNB.
EN-DC (E-UTRA - NR Dual Connectivity) Architecture

— One LTE eNB may be connected to multiple NR gNBs


— One NR gNB may be connected to multiple LTE eNBs
— NR Cell selection is based on
— UE measurement
— Operator configured LTE-NR cell relation
NR NSA (EN-DC) Overview
— LTE eNB terminates the S1 Control Signaling (S1-C) from EPC
and Signalling Radio Bearer (SRB) towards the UE

— The user Data Bearer (DRB) is setup either as:


— Split Bearer: using both LTE and NR radio resources
— LTE only bearer: using only LTE radio resources

— NR gNB terminates the S1-U user plane of the Split bearer for
the NR UE.

— LTE eNB terminates the S1-U user plane of the LTE only
bearer.

— The eNB and gNB have X2-C and X2-U connections, where
the user data of Split bearer is carried over X2-U, and control
signaling over X2-C
Synchronization
— NR NSA is a TDD System: Time and Phase Synchronization required

— Synchronization options:
— PTP (IEEE 1588)
— GNSS
— PTP and GNSS
— Can be connected to GNSS Receiver Unit by RJ45
5G - Sincronismo Tempo e Fase
Feature Massive Mimo p/ sites com AIR
AIR/AAS
Célula / Setor
Termpoints
SCTP
NCI Iguais CU e DU por setor
5G NR – Midband AIR Critical checks
• Sync Time and Phase • AIR do not measure VSWR
(RNT_TIME_LOCKED)
• Feature Massive Mimo (AIR)
(CXC4012272)
• SCTP Enabled
• TermPointToENodeB Enabled
• Cell/Sector/AIR Enabled
• NCI defined
4G LTE – Termpoint to gNodeBId Igual ao
NR
4G LTE – Critical Checks
• TermPointToGNB Enabled
• gNodeBId and IP defined
correctly according to 5G
Usuários em ENDC

You might also like