This document summarizes the internal structure of Earth based on seismic wave studies. It describes the crust, mantle, outer core, and inner core. The crust is thinner under oceans than continents and consists of less dense granite and more dense basalt. There is a sharp boundary between the crust and mantle. The mantle is divided into upper and lower sections. The outer core is liquid while the inner core is solid. Plate tectonics involves rigid lithospheric plates floating on the mantle that move and interact at boundaries.
2. • This drilling ship samples sediment and rock from the deep
ocean floor. It can only sample materials well within the
upper crust of the earth, however, barely scratching the
surface of the earth's interior
3. Seismic Waves Are The Key
Most of our understanding of
the Earth’s interior comes from
the detailed study of the
behavior of seismic waves
within the Earth’s interior.
Seismic waves “bounce” off
the different layers of the Earth
to send a “picture” of the
Earth’s interior.
4. The Crust
– The crust is the thin layer of solid, brittle material that covers
the Earth.
– There are some differences in the crust depending on where on
the surface you are.
• The crust under the oceans is known as Oceanic Crust and
the crust below the continents is known as Continental
Crust.
• The crust under the ocean is much thinner than the crust
under the continents.
• Seismic waves move faster through the oceanic crust than
through the continental crust.
– The material that makes up the continental crust is called sial
• This is due to the fact that it is mostly made up of rocks
containing silicon and aluminum.
• The oceanic crust is called sima as it is made up mostly of
rocks containing silicon and magnesium.
5. There is a sharp boundary between the crust and the mantle that is
called the Mohorovicic discontinuity or Moho for short.
• This is an area of increased velocity of seismic waves as the
material is denser in the mantle (due to higher proportion of
ferromagnesium materials and the crust is higher in silicates).
There are differences in the material that makes up the continental
crust and the oceanic crust.
• Continental crust is made mostly of less dense (2.7 g/cm3) granite
type rock, while the oceanic crust is made of more dense
(3.0g/cm3) basaltic rock.
6. • Continental crust is less dense, granite-type rock, while the
oceanic crust is more dense, basaltic rock. Both types of
crust behave as if they were floating on the mantle, which is
more dense than either type of crust.
7. • The Mantle
– The mantle is the middle part of the Earth’s interior.
– 2,900 km thick between the crust and the core.
– At about 400 and 700 km the pressure and temperature of
the mantle increase and change the structure of the
olivine minerals found.
8. • Seismic wave velocities increase at depths of about 400 km
and 700 km (about 250 mi and 430 mi). This finding agrees
closely with laboratory studies of changes in the character
of mantle materials that would occur at these depths from
increases in temperature and pressure.
9. – 700 km is the boundary between the upper mantle and
the lower mantle.
• No earthquakes occur in the lower mantle.
10. The Lithospheric Plates
The crust and the upper most mantle of the Earth is broken into
many pieces called plates. The plates "float" on the soft, semi-
rigid part of the mantle known as asthenosphere.
11. The Lithosphere
The crust and the upper layer of the mantle together make
up a zone of rigid, brittle rock called the Lithosphere.
15. The Outer Core
The core of the Earth
is like a ball of very
hot metals.
The outer core is
so hot that the metals
in it are all in the
liquid state.
The outer core is
composed of the
melted metals of
nickel and iron.
16. The Inner Core
The inner core of
the Earth has
temperatures and
pressures so great that
the metals are
squeezed together and
are not able to move
about like a liquid, but
are forced to vibrate in
place like a solid.
17. • Earth’s Core
– An earthquake will send out P-waves over the entire
globe, except for an area between 103O and 142O of arc
from the earthquake.
– This is called the P-wave shadow zone, as no P-waves
are received here.
– P-waves appear to be refracted by the core, which leaves
a shadow.
18. • The P-wave shadow zone, caused by refraction of P-
waves within the earth's core.
19. – There is also an S-wave shadow zone that is larger than
the P-wave shadow zone.
– S-waves are not recorded in the entire region more than
103O away from the epicenter.
– There appear to be 2 parts to the core.
• The inner core with a radius of about 1,200 km
(750 mi)
• The inner core appears to be solid
• The outer core has a radius of about 3,470 km
(2,160 mi)
• The core begins at a depth of about 2,900 km
(1,800 mi)
20. • The S-wave shadow zone. Since S-waves cannot pass
through a liquid, at least part of the core is either a liquid or
has some of the same physical properties as a liquid.
22. • Isostasy is an equilibrium between adjacent blocks
of the crust as they float on the upper mantle.
– There is an upward buoyant force that is exerted on the
crust by the upper mantle.
– This is because there is greater pressure upward from the
upper mantle than there is downward from the crust.
23. • Isostatic adjustment.
– The crustal plates sink to a depth where the pressure is
greater than the downward pressure and they are buoyed
up by this increased pressure.
– The crust can be viewed as a tall block with a deep root
that extends into the mantle.
24. • (A)Isostasy is an equilibrium between the upward buoyant
force and the downward force, or weight, of an object in a
fluid. (B) The earth's continental crust can be looked upon
as blocks of granitelike materials floating on a more dense,
liquidlike mantle. The thicker the continental crust, the
deeper it extends into the mantle.
26. • The Earth’s magnetic field is produced by the
slowly moving liquid part of the iron core.
• The Earth’s magnetic field circulates around the
geographic poles.
– It also undergoes occasional flips of polarity, called
Magnetic reversal.
– The magnetic orientation that we are currently
experiencing has persisted for about 700,000 years and is
currently about to undergo another reversal.
– Since the magnetic field also deflects cosmic rays, solar
wind, and charged particles, this reversal could represent
a major environmental hazard for all life on the Earth.
27. • Formation of magnetic strips
on the seafloor. As each new
section of seafloor forms at
the ridge, iron minerals
become magnetized in a
direction that depends on the
orientation of the earth's field
at that time. This makes a
permanent record of reversals
of the earth's magnetic field.
28. • There are several lines of evidence for this reversal
of field.
– Iron particles found in Roman artifacts show that the
Earth;s magnetic field was 40% stronger then than it is
now.
• At this rate the field strength would be zero in 2,000 years.
– Iron minerals that are crystallized on igneous rock, point
toward the magnetic poles like compasses.
• These give us evidence of the strength and the direction of the
magnetic field in the past.
29. • The earth's magnetic field. Note that the magnetic north
pole and the geographic North Pole are not in the same
place. Note also that the magnetic north pole acts as if the
south pole of a huge bar magnet were inside the earth. You
know that it must be a magnetic south pole, since the north
end of a magnetic compass is attracted to it, and opposite
poles attract.
30. • Magnetite mineral
grains align with
the earth's
magnetic field and
are frozen into
position as the
magma solidifies.
This magnetic
record shows the
earth's magnetic
field has reversed
itself in the past.
32. • Introduction
– When one looks at a globe, it is easy to visualize how the
continents at one time in the Earth’s history could have
been bound together.
– North and South America seem to fit into Europe and
Africa in a slight s-shaped curve.
– Alfred Wegener proposed that the continents were at one
time part of a super continent, called Pangaea
– Wegener further hypothesized that the continents had
moved apart during the history of the Earth by what is
called continental drift.
33. • (A)Normal position of the
continents on a world map.
(B) A sketch of South
America and Africa,
suggesting that they once
might have been joined
together and subsequently
separated by a continental
drift.
34. – Recall that the crust floats on the more liquid mantle and
is buoyed up by its density.
– Recall also that the mantle is molten, which gives it great
pressure and temperature.
– Given these lines of thought, it is not hard to see how the
continents, already floating on the magma which is at
great pressures, could be forced apart at certain areas
where perhaps the crust was weaker or could be forced to
break (fault).
35. • Evidence from the Ocean
– The ocean contains chains of mountains called oceanic
ridges.
– The ocean also contains long, narrow trenches that
always run parallel to the continents, called oceanic
trenches.
36. – Three kinds of observations started scientists to wonder
in the direction that allowed an explanation for
Wegener’s continental drift.
• All submarine earthquakes that were found and
measured were found to occur in a narrow band under
the crest of the Mid-Atlantic Ridge
• There is a long valley that runs along the crest of the
Mid-Atlantic Ridge, called a rift.
• There was a large amount of heat escaping from this
rift.
37. • The Mid-
Atlantic
Ridge divides
the Atlantic
Ocean into
two nearly
equal parts.
Where the
ridge reaches
above sea
level, it makes
oceanic
islands, such
as Iceland.
38. – It was thought that the rift might be a crack in the Earth’s
crust.
– This lead to the formation of the Seafloor Spreading
hypothesis
• Hot, molten rock moved from the interior of the Earth
to emerge alone the rift, flowing out in both directions
to create new rocks along the rift.
39. • The pattern of
seafloor ages on both
sides of the Mid-
Atlantic Ridge
reflects seafloor
spreading activity.
Younger rocks are
found closer to the
ridge.
40. • Lithosphere Plates and Boundaries
– Plate tectonics states that the lithosphere is broken into
fairly rigid plates that move on the asthenosphere.
– Some plates contain part of a continent and part of an
ocean basin, while others contain only ocean basins.
– Earthquakes, volcanoes, and the most rapid changes in
the Earth’s crust occur at these plate boundaries.
41. • The major plates of the lithosphere that move on the
asthenosphere. Source: After W. Hamilton, U.S.
Geological Survey.
42. – Three kinds of plate boundaries that describe how one
plate moves relative to another.
• Divergent boundaries.
–Occur where two plates are moving away from
each other.
–This forms a new crust zone, where the magma
flows as the plates separate releasing the pressure
on the.
»This forms new crust material
43. • A divergent boundary is a new crust zone where molten
magma from the asthenosphere rises, cools, and adds new
crust to the edges of the separating plates. Magma that cools
at deeper depths forms a coarse-grained basalt, while
surface lava cools to a fine-grained basalt. Note that
deposited sediment is deeper farther from the spreading rift.
44. • Convergent boundaries.
–Occurs where two plates are moving toward each
other.
–Old crust is returned to the asthenosphere where
the plates collide forming a subduction zone.
–The lithosphere of one plate is subducted under the
other plate.
45. • Ocean-continent plate convergence. This type of plate
boundary accounts for shallow and deep-seated earthquakes,
an oceanic trench, volcanic activity, and mountains along
the coast.
46. • Ocean-ocean plate convergence. This type of plate
convergence accounts for shallow and deep-focused
earthquakes, an oceanic trench, and a volcanic arc above the
subducted plate.
47. • Continent-continent plate convergence. Rocks are
deformed, and some lithosphere thickening occurs,
but neither plate is subducted to any great extent.
48. • Transform boundaries.
–Occur where two plates are sliding past each other.
–This produces the vibrations that are commonly felt
as earthquakes, such as those felt in California.
49. • Present-day Understandings
– Currently the most commonly accepted theory of plate
movement is that slowly turning convective cells in the
plastic asthenosphere drive the plates.
– Hot materials rise at the diverging plate boundaries.
– Some of this material escapes and forms new crust, but
some spreads out under the lithosphere.
– As it moves it drags the overlying plate with it.
– Eventually it cools and sinks back inward to the
subduction zone.
50. • Not to scale. One idea about convection in the mantle has a
convection cell circulating from the core to the lithosphere,
dragging the overlying lithosphere laterally away from the
oceanic ridge.