-
Beyond symmetry-protected BICs: transmission through asymmetric crossbar junctions in one-dimensional waveguides
Authors:
Sofía Pinto,
Rafael A. Molina,
Pedro A. Orellana
Abstract:
Over the last few decades, the study of Bound States in the Continuum, their formation, and properties has attracted lots of attention, especially in optics and photonics. It is particularly noticeable that most of these investigations base their studies on symmetric systems. In this article, we study the formation of bound states in the continuum in electronic and photonic transport systems consi…
▽ More
Over the last few decades, the study of Bound States in the Continuum, their formation, and properties has attracted lots of attention, especially in optics and photonics. It is particularly noticeable that most of these investigations base their studies on symmetric systems. In this article, we study the formation of bound states in the continuum in electronic and photonic transport systems consisting of crossbar junctions formed by one-dimensional waveguides, considering asymmetric junctions with commensurable lengths for the upper and lower arms. We also study how BICs form in linear junction arrays as a function of the distance between consecutive junctions and their commensurability with the upper and lower arms. We solve the Helmholtz equation for the crossbar junctions and calculate the transmission probability, probability density in the intersections, and quality factor. The presence of quasi-BICs is reflected in the transmission probability as a sharp resonance in the middle of a symmetric Fano resonance along with Dirac's delta functions in the probability density and divergence in the quality factors.
△ Less
Submitted 5 January, 2024;
originally announced January 2024.
-
Crack-free caustic magnesia-bonded refractory castables
Authors:
V. C. Miguel,
D. S. Fini,
V. S. Pinto,
M. H. Moreira,
V. C. Pandolfelli,
A. P. Luz
Abstract:
A growing interest in designing high-alumina MgO-bonded refractory castables has been identified in recent years due to the magnesia ability to react: (i) with water at the initial processing stages of these materials (inducing the precipitation of brucite phase) or (ii) with alumina, giving rise to in situ MgAl2O4 generation at high temperatures. Nevertheless, despite the great potential of caust…
▽ More
A growing interest in designing high-alumina MgO-bonded refractory castables has been identified in recent years due to the magnesia ability to react: (i) with water at the initial processing stages of these materials (inducing the precipitation of brucite phase) or (ii) with alumina, giving rise to in situ MgAl2O4 generation at high temperatures. Nevertheless, despite the great potential of caustic magnesia to be used as a binder in such systems due to its high reactivity, it is still a challenge to control the hydration reaction rate of this oxide and the negative effects derived from the expansive feature of Mg(OH)2 formation. Thus, this work evaluated the incorporation of different contents of aluminum hydroxyl lactate (AHL) into caustic magnesia-bonded castables, aiming to control the brucite precipitation during the curing and drying steps of the prepared samples, resulting in crack-free refractories. The designed compositions were characterized via flowability, setting behavior, X-ray diffraction, cold flexural strength, porosity, permeability and thermogravimetric measurements. According to the results, instead of Mg(OH)2, hydrotalcite-like phases [Mg6Al2(OH)16(OH)2.4.5H2O and Mg6Al2(OH)16(CO3).4H2O] were the main hydrated phases identified in the AHL-containing compositions. The addition of 1.0 wt.% of aluminum hydroxyl lactate to the designed castable proved to be, so far, the best option for this magnesia source, resulting in the development of a crack-free refractory with enhanced properties and greater spalling resistance under heating.
△ Less
Submitted 9 March, 2021;
originally announced March 2021.
-
Aluminum lactate role in improving hydration and drying behavior of MgO-bonded refractory castables
Authors:
D. S. Fini,
V. C. Miguel,
V. S. Pinto,
V. C. Pandolfelli,
M. H. Moreira,
A. P. Luz
Abstract:
Developing MgO-bonded castables is still an important subject for refractory producers and end-users based on the expansive character of the in-situ Mg(OH)2 formation. Considering that magnesia undergoes hydration when exposed to water and the generated hydrated phase needs to be properly accommodated in the resulting microstructure to inhibit the generation of cracks, it is very important to find…
▽ More
Developing MgO-bonded castables is still an important subject for refractory producers and end-users based on the expansive character of the in-situ Mg(OH)2 formation. Considering that magnesia undergoes hydration when exposed to water and the generated hydrated phase needs to be properly accommodated in the resulting microstructure to inhibit the generation of cracks, it is very important to find out alternatives to control the MgO hydration reaction rate. This research investigated the use of aluminum lactate (AL) as a likely additive to change the hydration and drying behavior of vibratable castables bonded with different MgO sources (dead burnt, caustic or fumed one). Firstly, XRD, TG and DSC measurements of magnesia-based aqueous suspensions were evaluated to identify the AL effect on changing the hydration reaction products during the curing and drying steps. After that, Al2O3-MgO refractories were prepared and their flowability, curing behavior, cold flexural strength, apparent porosity, permeability and explosion resistance were evaluated. The results indicated that, instead of Mg(OH)2, Mg6Al2(OH)16(OH)2.4.5H2O/ Mg6Al2(OH)16(CO3).4H2O was the main hydrated phase identified in the AL-containing compositions. Due to this change in the hydration behavior of the refractories, the mixtures prepared with dead-burnt or magnesia fumes plus organic salt presented a longer setting time. Besides that, crack-free samples with improved permeability and green mechanical strength could be obtained when adding 0.5 wt.% or 1.0 wt.% of aluminum lactate to the tested castable compositions. Consequently, 1.0 wt.% of the selected additive favored the design of refractories with enhanced properties and greater spalling resistance, as no explosion could be observed even when subjecting the prepared samples to severe heating conditions (20C/min).
△ Less
Submitted 2 February, 2021;
originally announced February 2021.
-
Fast drying of high-alumina MgO-bonded refractory castables
Authors:
V. S. Pinto,
D. S. Fini,
V. C. Miguel,
V. C. Pandolfelli,
M. H. Moreira,
T. Venancio,
A. P. Luz
Abstract:
Refractory producers face many challenges in terms of producing MgO-containing castables due to the high likelihood of magnesia to hydrate in contact with water, resulting in Mg(OH)2 generation. The expansive feature of this transformation affects the performance of such refractories, as (i) if this hydrated phase is not accommodated in the formed microstructure, ceramic linings with cracks and lo…
▽ More
Refractory producers face many challenges in terms of producing MgO-containing castables due to the high likelihood of magnesia to hydrate in contact with water, resulting in Mg(OH)2 generation. The expansive feature of this transformation affects the performance of such refractories, as (i) if this hydrated phase is not accommodated in the formed microstructure, ceramic linings with cracks and low green mechanical strength will be obtained; and (ii) if crack-free pieces are prepared, they should present low porosity and reduced permeability, which require special attention when heating these materials. This work investigated the ability of various additives in the optimization of the drying behavior of Al2O3-MgO castables. Vibratable compositions were tested after incorporating polymeric fibers (PF), an organic salt (OAS), SiO2-based additive (SM) or permeability enhancing active compound (MP) into the dry-mixtures. Various experimental measurements were performed to infer the role of the drying agents to prevent the samples explosion and whether they would also influence other properties of the castables. As observed, OAS and MP helped to inhibit the MgO-bonded samples explosion even under severe heating conditions (2-20C/min) and increased their green mechanical strength and slag infiltration resistance when compared to the additive-free composition. On the other hand, the addition of polymeric fibers (PF) or silica-based compound (SM) to the formulations was not able to prevent the castables explosion when using a high heating rate and other side effects could also be observed when testing these materials. Thus, the selection of suitable drying agents is a key issue, as they may allow the development of MgO-bonded castables with enhanced properties and lower spalling risk during their first thermal treatment.
△ Less
Submitted 30 January, 2021;
originally announced February 2021.
-
Light-tunable optical cell manipulation via photoactive azobenzene-containing thin film bio-substrate
Authors:
Olivier Lefebvre,
Mireille Lambert,
Clotilde Randriamampita,
Sandra Pinto,
Khalid Lahlil,
Jacques Peretti,
Claire Smadja,
Filippo Fabbri
Abstract:
In-vivo, real-time study of the local and collective cellular biomechanical responses requires the fine and selective manipulation of the cellular environment. One innovative pathway is the use of photoactive bio-substrates such as azobenzene-containing materials, which exhibit spectacular photomechanical properties, to optically trigger the local, mechanical stimulation of cells. Excited cells ex…
▽ More
In-vivo, real-time study of the local and collective cellular biomechanical responses requires the fine and selective manipulation of the cellular environment. One innovative pathway is the use of photoactive bio-substrates such as azobenzene-containing materials, which exhibit spectacular photomechanical properties, to optically trigger the local, mechanical stimulation of cells. Excited cells exhibit spectacular morphological modifications and area shrinkage, which are dependent on the illumination. This demonstrates the capabilities of photomechanically active substrates to study the phenomena resulting from the mechanical interaction of cells with their environment.
△ Less
Submitted 28 December, 2021; v1 submitted 1 December, 2020;
originally announced December 2020.
-
Explosive synchronization with partial degree-frequency correlation
Authors:
Rafael S. Pinto,
Alberto Saa
Abstract:
Networks of Kuramoto oscillators with a positive correlation between the oscillators frequencies and the degree of the their corresponding vertices exhibits the so-called explosive synchronization behavior, which is now under intensive investigation. Here, we study and report explosive synchronization in a situation that has not yet been considered, namely when only a part, typically small, of the…
▽ More
Networks of Kuramoto oscillators with a positive correlation between the oscillators frequencies and the degree of the their corresponding vertices exhibits the so-called explosive synchronization behavior, which is now under intensive investigation. Here, we study and report explosive synchronization in a situation that has not yet been considered, namely when only a part, typically small, of the vertices is subjected to a degree frequency correlation. Our results show that in order to have explosive synchronization, it suffices to have degree-frequency correlations only for the hubs, the vertices with the highest degrees. Moreover, we show that a partial degree-frequency correlation does not only promotes but also allows explosive synchronization to happen in networks for which a full degree-frequency correlation would not allow it. We perform exhaustive numerical experiments for synthetic networks and also for the undirected and unweighted version of the neural network of the worm Caenorhabditis elegans. The latter is an explicit example where partial degree-frequency correlation leads to explosive synchronization with hysteresis, in contrast with the fully correlated case, for which no explosive synchronization is observed.
△ Less
Submitted 24 February, 2015; v1 submitted 11 August, 2014;
originally announced August 2014.
-
A Self-Consistent Extrapolation Method for the Complex Permittivity and Permeability Based on Finite Frequency Data
Authors:
Christine C. Dantas,
Mirabel. C. Rezende,
Simone S. Pinto
Abstract:
We describe a method of extrapolation based on a "truncated" Kramers-Kronig relation for the complex permittivity ($ε$) and permeability ($μ$) parameters of a material, based on finite frequency data. Considering a few assumptions, such as the behavior of the loss tangent and the overall nature of corrections, the method is robust within a small relative error, if the assumed hypotheses hold at th…
▽ More
We describe a method of extrapolation based on a "truncated" Kramers-Kronig relation for the complex permittivity ($ε$) and permeability ($μ$) parameters of a material, based on finite frequency data. Considering a few assumptions, such as the behavior of the loss tangent and the overall nature of corrections, the method is robust within a small relative error, if the assumed hypotheses hold at the extrapolated frequency range.
△ Less
Submitted 4 December, 2014; v1 submitted 14 February, 2014;
originally announced February 2014.
-
Analytical results for coupled map lattices with long-range interactions
Authors:
C. Anteneodo,
S. E. de S. Pinto,
A. M. Batista,
R. L. Viana
Abstract:
We obtain exact analytical results for lattices of maps with couplings that decay with distance as $r^{-α}$. We analyze the effect of the coupling range on the system dynamics through the Lyapunov spectrum. For lattices whose elements are piecewise linear maps, we get an algebraic expression for the Lyapunov spectrum. When the local dynamics is given by a nonlinear map, the Lyapunov spectrum for…
▽ More
We obtain exact analytical results for lattices of maps with couplings that decay with distance as $r^{-α}$. We analyze the effect of the coupling range on the system dynamics through the Lyapunov spectrum. For lattices whose elements are piecewise linear maps, we get an algebraic expression for the Lyapunov spectrum. When the local dynamics is given by a nonlinear map, the Lyapunov spectrum for a completely synchronized state is analytically obtained. The critical lines characterizing the synchronization transition are determined from the expression for the largest transversal Lyapunov exponent. In particular, it is shown that in the thermodynamical limit, such transition is only possible for sufficiently long-range interactions, namely, for $α\le alpha_c<d$, where $d$ is the lattice dimension.
△ Less
Submitted 22 January, 2004; v1 submitted 12 August, 2003;
originally announced August 2003.
