control scheme
Recently Published Documents

Based on the previous research on the production line automation, this paper carries out further research and further design and development on the basis of the original production line automation equipment. In this paper, the overall design of the automatic production line is carried out, and the various systems in the automatic production line are optimized, and the backward instruments are eliminated, and then some more advanced and convenient instruments are applied. Then, the hardware and software of the automatic production line are studied respectively, and the human-computer interaction module and real-time main control circuit module are re developed, and the electric shaft is applied to the automatic production line. Finally, the fuzzy PID controller of the stepping motor is designed. The experiment shows that the fuzzy PID control scheme is better than the traditional PID control scheme. After the rationalization of the system, the quality robustness of proactive planning is improved obviously. Then, the temperature of motorized spindle was tested.

In this article, a three-phase multilevel neutral-point-clamped inverter with a modified t-type structure of switches is proposed. A pulse width modulation (PWM) scheme of the proposed inverter is also developed. The proposed topology of the multilevel inverter has the advantage of being simple, on the one hand since it does contain only semiconductors in reduced number (corresponding to the number of required voltage levels), and no other components such as switching or flying capacitors, and on the other hand, the control scheme is much simpler and more suitable for variable frequency and voltage control. The performances of this inverter are analyzed through simulations carried out in the MATLAB/Simulink environment on a three-phase inverter with 9 levels. In all simulations, the proposed topology is connected with R-load or RL-load without any output filter.

<p>Modern microprocessors in high-power applications require a low input voltage and a high input current, necessitating the use of multiphase buck converters. As per microprocessor computing complexity, the power requirements of the switching converter will also be more important and will be increasing as per load demand. Previous studies introduced some methods to achieve the advantages associated with multiphase regulators. This paper presents an effective closed closed-loop control scheme for multiphase buck converters that reduces ripple and improves transient response. It is suitable for applications that require regulated output voltage with effectively reduced ripple. The analysis began with a simulation of the entire design using the OrCAD tool, followed by the construction of a hardware setup. Experiments on a 200 Khz, 9 V, 12 A, 2-phase buck voltage regulator were conducted and the proposed experiment found to be useful.</p>

Considering the performance requirements in actual applications, a look-up table based fractional order composite control scheme for the permanent magnet synchronous motor speed servo system is proposed. Firstly, an extended state observer based compensation scheme was adopted to suppress the motor parametric uncertainties and convert the speed servo plant into a double-integrator model. Then, a fractional order proportional-derivative (PDμ) controller was adopted as the speed controller to provide the optimal step response performance for the servo system. A universal look-up table was established to estimate the derivative order of the PDμ controller, according to the optimal samples collected by an improved differential evolution algorithm. With the look-up table, the optimal PDμ controller can be tuned analytically. Simulation and experimental results show that the servo system using the composite control scheme can achieve optimal tracking performance and has robustness to the motor parametric uncertainties and disturbance torques.

This paper studies the multi-source disturbances attenuation problem on the yaw motion of unmanned aerial helicopter with a variable-speed rotor. The yaw motion subsystem dominated by an electrically-driven tail rotor is firstly introduced, and its trajectory accuracy requires particularly close attention. To this end, we establish a fourth-order yaw error dynamic equation; subsequently, a nonlinear robust control scheme based on optimal H∞ principle is developed, consisting of laws of virtual functions, parameter estimation and a compensation signal. The novelty of this scheme lies in unifying the techniques to deal with the uncertain parameters, noise perturbations, actuator output fault and external airflow turbulence into a simple framework. Stability analysis guarantees that the yaw closed-loop system has the predefined performance of disturbance suppression in the sense of a finite L2-gain. Comparison results with the extended state observer based backstepping controller verify the effectiveness and superior performance of proposed scheme in an aircraft prototype.