Auxiliary Equipment: Service Data
Auxiliary Equipment: Service Data
CONTENTS
SERVICE DATA ........................................... EA-1- 1
SPECIFICATIONS ....................................... EA-1- 1
SERVICE DATA ........................................... EA-1- 1
VACUUM PUMP .......................................... EA-2- 1
CONSTRUCTION ........................................
DISASSEMBLY ............................................
INSPECTION ...............................................
REASSEMBLY .............................................
EA-2EA-2EA-2EA-2-
1
2
2
3
SERVICE DATA
SERVICE DATA
SPECIFICATIONS
VACUUM PUMP
Model
Type
Vane
3
Theoretical discharge
cm (cu in)/rev
rpm
Vacuum
performance
30 (1.83)
7,800
Less than 40 seconds/1,000 rpm
Less than 10 seconds/5,000 rpm
More than 90.6 kPa {680 mmHg, 26.77 inHg}/5,000 rpm
Alternator model
SERVICE DATA
VACUUM PUMP
Unit: mm (in)
Item
Vane height
Maintenance standard
Service limit
13.5 (0.531)
13.0 (0.512)
EA-1-1
Remarks
VACUUM PUMP
VACUUM PUMP
CONSTRUCTION
Model 1290 009 00 (VD-30)
WEA045A
EA-2-1
VACUUM PUMP
DISASSEMBLY
WEA056A
j
6
j
7
j
8
j
9
Housing
Valve
Packing
Connector
Packing
10
>j
j
11
12
>j
13
>j
Connector
Packing
Retaining ring
Oil seal
Center plate
O-ring
Rotor assembly
Vane
Marks . and > indicate that the key points of operation are explained in the text.
INSPECTION
+ Clean all disassembled parts in cleaning solvent. Check for
scratches, cracks or damage and replace faulty parts.
+ If measurement indicates that the service limit has exceeded,
repair or replace faulty parts.
VANE
Unit: mm (in)
Item
Height
Maintenance standard
Service limit
13.5 (0.531)
13.0 (0.512)
CENTER PLATE
Check for damage at the sliding surface with the rotor and replace
when worn or damaged.
HOUSING
Inspect the sliding surface with the rotor for damage and replace
when worn or damaged, especially when the inside diameter is
worn or damaged.
EA-2-2
VACUUM PUMP
OTHERS
+ Replace the O-ring at each disassembly.
+ Replace and discolored copper packing. Moreover, check the
threads of each part for damaged and replace when damaged
beyond use.
REASSEMBLY
Key point of reassembly
j
13 Vane
Assemble the four vanes with the end having the round chamfer at
the outside.
ZEA007A
j
12 Rotor assembly, j
10 Center plate
1. Insert the rotor into the housing. The side which has no
crossed oil groove should face the center plate.
2. Position the center plate on the housing. Make sure a gasket is
used between both parts.
EEA3-020
EF11-41
EA-2-3