Saph 440
Saph 440
JIS G 3113 1990 Hot-Rolled Steel Plates, Sheets and Strip for Automobile Structural Uses
Chemical Composition
Symbol SAPH 310, SAPH370, SAPH400, SAPH440 Chemical Composition P 0.040max. S
Unit : %
0.040max.
Mechanical Properties
Yield Point N/mm2 Elongation (rolling direction) % No.5 Test Piece Symbol Tensile Thickness Thickness Strength up to 6mm or N/mm2 and excl. over to and excl. 6mm 8mm Thickness 8mm or Thickness Thickness over to 1.6 or 2.0 or and incl. over to over to 14mm and and excl. excl. 2.0mm 2.5mm Thickness 2.5 or over to and excl. 3.15mm Thickness 3.15 or over to and excl. 4.0mm No.1 A Test Piece Bendability Inside Radius
Thickness Bending Test 4.0 or Thickness Thickness Angle Thickness Piece over to up to 6.3mm 2.0mm and and excl. or over or over excl. 2.0mm 6.3mm
Flat on itself Thickness 180 0.5 Thickness 180 1.0 Thickness 180 1.0 180 Thickness 1.0 No.3 Thickness trans 1.0 versely Thickness to rolling 1.0 direction Thickness 1.5
SAPH 310 310min. (185)min. (185)min. (175)min. 33min. 34min. 36min. 38min. 40min. 26min. SAPH 370 370min. 225min. 225min. 215min. 32min. 33min. 35min. 36min. 37min. 25min. SAPH 400 400min. 255min. 235min. 235min. 31min. 32min. 34min. 35min. 36min. 24min. SAPH 440 440min. 305min. 295min. 275min. 29min. 30min. 32min. 33min. 34min. 22min.
Remarks : 1. The values specified in the above table shall no to be applied to the irregular portions of both ends of the steel coil. 2. The figures in ( ) are given for informative reference.
Chemical Composition
Symbol SG 255 SG 295 SG 325 SG 365 Chemical Composition C 0.20 max. 0.20 max. 0.20 max. 0.20 max. Si
Remarks : Alloying elements other than those shown in the table may be added if necessary.
Mechanical Properties
Symbol Yield Point or Tensile Elongation Proof Stress Strength N/ % 2 2 N/mm mm 255min. 295min. 325min. 365min. 400min. 440min. 490min. 540min. 28min. 26min. 22min. 20min. No.5 in rolling direction Tensile Test Piece Bendability Bending Angle 180 180 180 180 Thickness 1.5 Inside Radius Thickness 1.0 No.3 in rolling direction Test Piece
Remarks : The values specified shall not be applied for irregular portions on each end of steel strip.
29