Ambushes
Ambushes
Ambushes
By Ashley Hiscock
Some information taken from Brecon Junior Tactics Course/Cadre
INTRODUCTION
Fighting Patrol
Tasked to:
• Harass, ambush, attack or create a diversion
Men may have to lie in wait for hours, days even, and be
alert and ready to engage and kill the enemy at a
moments notice, in just a few seconds of action.
Ambush Sites
Suitable places for ambush sites include:
• Known enemy routes
• Enemy withdrawal routes
• Enemy positions
• Admin areas, supply and water points
• Areas of marked vegetation change
• Routes to and from our own defensive positions
• The withdrawal route from an ambush or attack in case of
an enemy follow up
Control can be easily lost if the enemy are too strong for
the ambush. So all members of the ambush must
know:
1. Location of the FRV
2. Withdrawal routes to the FRV
3. Order of withdrawal
4. Actions at the FRV
Simple plan for springing the
Ambush
The ambush should be sprung by the commanders of the groups,
however, any man can open fire if he thinks an enemy has seen
the ambush.
A long term ambush may be divided into three parties. One in the
ambush position, one in reserve or cover party and one in the rest
area. This provides a rested party for the ambush area and a strong
cover party.
At troop level this may not work, resulting in three parties to tired to do
work properly. It may work better with two parties, one at the
ambush site and one ready to provide cover but resting at the same
time.
Long Term Ambushes-Cont 2
Because of security concerns you may not be
able to cook. In these conditions you will be on
“hard routine”. Commanders must ensure that
all food taken on the operation is able to be
eaten cold. You may have to prepare for water
patrols or carry in water that you want to use.
Triangular
With base line towards the enemy.
Triangular
With point towards enemy
T-Shaped
Linear Ambush-Rear Protection
Linear Ambush
Area Ambush
Organisation of an Ambush Party
All ambush parties are sub-divided to form their
own groups with their own commanders. The
type of group required and strength required will
depend upon the enemy and terrain. At troop
level you may have in the ambush party of a
linear ambush:
1. A Killing Group
2. A Cut Off/Stop Group
3. A rear protection party
Killing Group
Task
To cover the chosen ambush site and to spring the
ambush.
Size
Up to three fire teams. More may be used depending on
the requirements of other groups.
Composition
The ambush commander and a high proportion of
automatic weapons. LSWs should fire from a defilade
position rather than straight across the killing area.
Cut off Groups
Tasks
To give early warning of enemy approach.
To stop enemy escaping the killing area.
To give flank protection to the killing group.
Size
Fire team size is ideal.
Composition
It should be commanded by an NCO ideally. If it has a view
of the killing ground that LSWs may be sited here as a
defilade position.
Rear Protection/Cover Group
Tasks
To give protection to the rear and flanks of the killing group.
To act as an immediate reserve if required.
To supply light as dictated by the commander.
Size
From four to seven men dependant on the Troop strength
Composition
The Tp/Sgt should command this group. He is in charge of
the 51mm mortar for illumination and hand held flares.
The Five Phases
The ambush is a fighting patrol, so battle
procedure is similar to any normal fighting
patrol.
In the execution paragraph of NATO orders for
ambushes there are five phases. These are:
3. Action in the FRV (initial recce)
4. Occupation
5. Routine (if required)
6. Action on enemy
7. Withdrawal
Action in the FRV (Initial Recce)
The recce group consists of the Tp Cdr, the radio operator,
the commanders of all the groups and the sentries of the
cut offs, who will remain in place throughout the recce
and occupation.
The troop commander should site each group in detail
starting with the killing group. Considerations are
position of killing area, sighting of killing positions, site in
pairs, siting of flares/lights, alternate positions for night or
poor vis.
The considerations for cut off groups and flank protection is
similar. For the rear protection group particular attention
must be paid to 51mm mortar and hand held illuminants.
The routes between groups must be cleared and comms
cord laid between cut off groups and killing group.
Occupation
The troop commander returns to the FRV to brief people of any
changes to the plan.
The order of march should be rear protection, cut offs, then killing
group. Whoever is commanding the rear cut off should know the
layout of the ambush very well.
Before further work it is very advisable to lie silently for a few minutes
to see if you can see or hear enemy activity.
Next you must lay out claymores, lights, flares and comms cord if not
yet done.
Once the commander is happy that the work is done he may signal
“ambush set”. This could be as simple as the commander moving
from group to group passing on the news. On this command men
are to cease activity, move their safety catches to fire and settle
down.
Action on Enemy
The enemy’s approach should have been seen by the cut off group so that
the ambush will be completely ready for their arrival in the killing area.
The approach of the enemy may be made aware to the killing group be
comms cord, radio or line. But be aware that all these methods may
also alert the enemy.
The ambush can be sprung by a controlled burst by a commanders
automatic weapon, or pyro, flare etc, make sure you know all the pros
and cons before you decide on anything.
If the ambush is to be sprung at night consider light carefully. Flares may
blow smoke over the target area and obscure it, also do not forget the
illumination from illuminating 51mm mortar rounds.
Signals must be known by all and delivered clearly. So there are no
miscalculations.
If searchers are to be used it must be rehearsed and planned carefully.
They will exit from the least vulnerable point and travel in pairs. They
must be loud when searching and maintain communication.
Consider actions on for all eventualities, e.g. enemy in killing area without
warning, enemy springs ambush on you, comes from flanks etc
Withdrawal
There are several different types of withdrawal:
• Ambush not sprung
• Enemy not following up
• Enemy following up
Ambush Not Sprung
You will withdraw without springing the ambush
either by time expiry or by radio message.
The sequence of withdrawal will be opposite to the
occupation sequence. Care must be taken to
withdraw all stores etc and cover up all signs of
occupation.
Enemy Not Following Up
If the ambush has been sprung and the enemy is
destroyed the withdrawal needs to be slick and
quick. There should be chance to gather up all
stores before moving off.
Enemy Following Up
If the enemy is vigorous in his anti-ambush drills or much
stronger than anticipated then the withdrawal must be
well controlled and very aggressive.
The ambush must use everything at its disposal to slow
the enemy before breaking contact. This may entail
groups using fire and movement, the firing of any
remaining claymores or flares to add to the confusion.
The use of mortars and artillery to hit the enemy is
advisable.
The action in the FRV should be a quick head check
before moving off. It may be desirable to put in a snap
or immediate ambush to catch any enemy following up.
Causes of failure
There are many causes of failure. These can
include:
• Noise
• Poor camouflage, careful approach
• Movement
• Plenty more
Noise
• Cocking Weapons
• Movement of Safety Catches
• Careless use of radios
• Human noises, coughing, talking, urination etc
• Mess tins, waterbottles filling etc
Poor Camouflage/Approach
• Using tracks for the approach
• Crossing tracks within the ambush area
• Too much cutting of foliage to obtain fields of
fire
• General poor camouflage, think of the basics
• Lots of the causes of failure for an ambush also
apply to the approach
Movement
• By individuals
• Relief parties
• Energetic tugging on the comms cord
Others
• Bad sitting of commanders
• The enemy arriving unexpectedly
• Signal for opening fire unclear causing a slow
start to the ambush
• Premature fire
• Tendency to select the same target
• Tendency to aim high
• Misfires and stoppages on key weapons
• Poor fire control
Other Types of Ambush
• Anti armour. Normally of section strength,
obviously tasked to take out armoured
vehicles and tanks
• A-Type Ambushes. These are explosive
ambushes that are triggered by command or
mechanical means. Normally deployed in the
jungle or other remote locations.
ANY QUESTIONS?
A
GURKHA
AMBUSH
IN
BORNEO
A
GURKHA
AMBUSH
IN
BORNEO
1400 hrs
Sketch of Ambush Site
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Rubber & Wounded Enemy
Batul Intang Secondary Other Enemy
Jungle
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N --- Track
0 20 40m
Sungei Tampan
Border
1735 hrs
Sketch of Ambush Site
Rear
Protection
Pl HQ
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Batul Intang Other Enemy
Killing Area Limits
KILLING AREA
Limit of observation
Enemy Mor Bombs
N --- Track
0 20 40m
Sungei Tampan
Border
1810 hrs
Sketch of Ambush Site
Rear
Protection
Pl Base
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N --- Track
0 20 40m
Sungei Tampan
1812 hrs
Sketch of Ambush Site
Rear
Protection
Pl Base
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N
--- Track
0 20 40m
Sungei Tampan
1812 hrs
Sketch of Ambush Site
Rear
Protection
Pl Base
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N
--- Track
0 20 40m
Sungei Tampan
1815 hrs
Sketch of Ambush Site
Rear
Protection
Pl Base
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N
--- Track
0 20 40m
Sungei Tampan
1825 hrs
Sketch of Ambush Site
Rear
Protection
Pl Base
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N
--- Track
0 20 40m
Sungei Tampan
1830 hrs
Sketch of Ambush Site
Pl Base
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N
--- Track
0 20 40m
Sungei Tampan
1900 hrs
Sketch of Ambush Site
Pl Base
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N
--- Track
0 20 40m
Sungei Tampan
Border
2300 hrs
Sketch of Ambush Site
New Position
LEGEND
Gurkha Position
Redeployment
LMG
Killed Enemy
Wounded Enemy
Batul Intang Other Enemy
Killing Area Limits
Limit of observation
Enemy Mor Bombs
N --- Track
0 20 40m
Sungei Tampan
Border
Lessons Learnt
This was a difficult ambush to set up, though none are easy. As a
member of a team and a group you must always try to use all your
tactical knowledge and skills. A lot of the drills used here were not
by the book, though the ambush eventually ended well. They came
out of this with several lessons learnt:
• Time spent on reconnaissance (3 hours) is never wasted.
• The positioning of the rear protection group to cover the most
exposed arc
• The ambush was sprung with maximum enemy in the killing area
• The platoon remained in position after the ambush to achieve
“second shots” and waited until the morning to search the bodies,
though this cannot always be recommended.
• The use of pre-recorded artillery DF
• The high standard of shooting, despite poor weather and the jungle
itself all 11 men in the killing area were killed and more who tried to
attack from the left flank.
ANY QUESTIONS?
SUMMARY