Marking Scheme
Marking Scheme
Marking Scheme
X m ap eP
s er om .c
MARK SCHEME for the October/November 2009 question paper for the guidance of teachers
5054 PHYSICS
5054/02 Paper 2 (Theory), maximum raw mark 75
This mark scheme is published as an aid to teachers and candidates, to indicate the requirements of the examination. It shows the basis on which Examiners were instructed to award marks. It does not indicate the details of the discussions that took place at an Examiners meeting before marking began, which would have considered the acceptability of alternative answers. Mark schemes must be read in conjunction with the question papers and the report on the examination.
CIE will not enter into discussions or correspondence in connection with these mark schemes.
CIE is publishing the mark schemes for the October/November 2009 question papers for most IGCSE, GCE Advanced Level and Advanced Subsidiary Level syllabuses and some Ordinary Level syllabuses.
Page 2 1
Syllabus 5054
Paper 02 B1
(ii) density of liquid/(sea-)water or gravitational field strength/acceleration of freefall (not gravity) B1 (b) (i) 3.6/3.60 105 Pa (ii) P1 V1 = P2 V2 or 1.05 105 6000 = 3.60 105 V2 1700 or 1750 or 1800 cm3 2 (a) (WD =)Fx or 1680 50 84 000 J (b) friction/drag/resistance of water/air work done against friction/resistance/drag or energy lost due to friction/resistance/ drag or energy lost as heat/internal/thermal 3 (a) (i) (he) loses ve charge electrons lost (to surface) (ii) (becomes) negative/gains electrons (b) (i) (he) discharges/(re)gains electrons/ve charge (not current flow) (ii) (Q = )It or 1.6 0.15 or 0.0016 0.00015 2.4 10n 2.4 10-7 C 4 (a) (i) one ray from M correctly reflected checked by eye two rays from M correctly reflected checked by eye and traced back to image (ii) image point clearly marked at intersection/correct place checked by eye (b) 0.34 m cao 5 (a) (i) C in correct position i.e. gap 4, 18 or 32 { allow arrows/ R in correct position i.e. gap 11 or 25 { brackets < /2 OR two correct positions but R and C reversed 1/2 (ii) 6.2 6.6 cm (iii) (v =)f or 5.1/5100 6.4/0.064 (using candidates 5 (a) (ii)) 3.16 3.37 10n 316 337 m/s B1 C1 A1 C1 A1 B1 B1 C1 A1 B1 B1 C1 C1 A1 C1 A1 B1 B1 B1 B1 B1 C1 C1 A1 [4] [4] [5]
[7]
UCLES 2009
Page 3
Syllabus 5054
Paper 02 B1 B1
(b) (longitudinal wave:) vibration/oscillation direction parallel to/in same direction as wave/energy travel direction (not L & R) transverse wave: directions perpendicular or can be polarized (not up & down) (a) (i) (I = )P/V or P = VI or 650/230 2.8 or 2.83 A (ii) 3, 4, 5, 6 or 7 A only (b) (i) casing becomes live/at high voltage current through user/user electrocuted/user shocked (ii) fuse blows/melts/breaks fuse in live wire/(microwave) disconnected/circuit broken/no current 7 (a) 1.(0) m (b) (i) (for an object in) equilibrium/balance W1x = W2y (clear) or anticlockwise moment/torque/turning force = clockwise moment/torque/turning force (ii) 18 000 1. 0 = T 0.5 36 000 N 8 (a) (i) 3 cao (ii) 208 cao (iii) 11 cao (b) (i) 17 cao (ii) 20 cao
[8]
[Total: 45]
UCLES 2009
Page 4
Syllabus 5054
Paper 02
(a) (i) 100 22 or 78 (Q =)mcT or 35 4200 78 1.1/1.1466/1.15 107 J (ii) (t =)E/P or P = E/t or 1.15 107/2600 4.4/4.41/4.42 103 s (iii) heat escapes/lost (to kitchen) or heat to heat the boiler/heater or not all heat ends up in water or heat to cause evaporation or used as latent heat (not heat wasted) (b) (i) hot/warm water expands (not molecules expand) density (of hot/warm water) decreases hot/warm water rises convection current/circulation or cold water sinks mixes water (max 4)
C1 C1 A1 C1 A1
B1 B1 B1 B1 B1 B1
[6]
(ii) metal/steel is (good) conductor/poor insulator or plastic is poor conductor/ insulator B1 more heat transferred through steel/less through plastic or heat transferred more quickly through steel/less quickly through plastic B1 (c) (i) evaporation OR condensation boiling needs heat/ condensation releases heat boiling: liquid to gas/ condensation: gas to liquid B1
[6]
(ii) any two points only occurs at surface occurs at any temperature produces cooling no bubbles B2
B1 B1 [3]
[Total: 15] 10 (a) (i) (W =)mg or 0.5 3.7 1.8/1.85/1.9 N (ii) 3.7 m/s2 not N/kg (iii) (KE =) mv2 0.50 3.22 2.6 or 2.56 J C1 A1 B1 C1 C1 A1
[6]
(b) (i) A compares/measures (unknown and known) masses/amount of matter B1 B measures/is dependent on weight/force of gravity (and hence mass obtained) B1 Mars weights/forces of gravity are less than/different from (Earth) B1 (ii) A or lever arm balance or balance with discs B1 [4]
UCLES 2009
Syllabus 5054
Paper 02 B1
(ii) Either: record value of water in measuring cylinder (not beaker) insert rock record new value subtract (to obtain volume) or measure rise) m/volume or m/subtraction (max 4)
Or: water/liquid in displacement/eureka can full to overflowing immerse rock (new) overflow in measuring cylinder (not beaker is volume) m/volume or m/subtraction (max 4)
B4
[5]
[Total: 15] 11 (a) (i) (I = )V/R or V = IR (in (i)/(ii)) or 9.0/20 (in (i)) or 0.45 16 (in (ii)) 0.45 A (ii) 7.2 V (max 3 for (i) and (ii) together) C1 may be awarded for either A mark (b) (i) R T and line of positive slope throughout straight line, positive intercept on R-axis and slope/0 on kelvin scale (ii) voltmeter reading falls current (supplied by battery) falls or X takes greater proportion of p.d. or 16 takes smaller proportion of p.d. (iii) 0 and to//8/9/10/whole number not greater than 20 V (usual unit penalty)
C1 A1 A1 [3]
B1 B1 B1 B1 B1 B1 [6]
EITHER: (c) (i) use small, metal conductor as probe/sensor or calibrate V reading (with known T) the voltmeter reading is used to find T
B1 B1
(ii) any two from: high temperatures /remote reading/robust/quick acting/direct input to computer/low heat capacity B2 (iii) equal changes in one/T do not produce a equal changes in the other/V or graph with axes labelled not straight or not proportional to not a straight line or not same change or change in V is not uniform 1/2 B2 [6]
UCLES 2009
Syllabus 5054
Paper 02
[Total: 15]
UCLES 2009