TC Midget: Classic Car Series: 05
TC Midget: Classic Car Series: 05
MG
TC Midget
Assembly
Instructions
Mountain fold
Valley fold
Cut a notch
along this line.
Cut a notch
along the line.
Dotted line
Dashed and
dotted line
Solid line
Scissors mark
Fold so that the printed pattern faces outside. Dots indicate parts to be glued;
dotted lines indicate approximate area for
application of glue.
Glue parts with the same number together.
Glue areas within the same part together.
Glue to the reverse side of the specified part.
Fold so that the printed pattern faces inside.
Cut along the center of the line.
Red dot
Green dot
Blue dot Cut these areas out.
Glue, scissors and other tools may be dangerous
to young children so be sure to keep them out of
the reach of young children.
Assembly Instructions : Six US letter sheets (No.1 to No. 6)
Build this model with careful reference to the Assembly Instructions.
Tools Assembly tip
Key to symbols
Write the number of each part on the reverse side of the part in pencil upon
cutting it out, to be sure you can tell which part is which later.
Before gluing, crease the paper along mountain and valley fold lines. Trace
along the folds with a ruler and an exhausted ballpoint pen (out of ink) to get a
sharper fold.
Make sure rounded sections are nice and stiff.
Scissors
Ruler, Set square
Glue (Wood glue or craft glue recommend)
Exhausted ballpoint pen (out of ink)
Toothpicks (for use in applying glue)
Tweezers (useful for handling small parts)
Pencil
View of completed model * This model was designed for Papercraft and may differ from the original in some respects.
MG TC Midget
Assembly
Instructions
Carefully shape curves.
Carefully shape curves.
Carefully shape curves.
Shaded areas in diagrams indicate reverse side of parts.
Affix with glue.
Affix with glue.
Affix with glue.
MG TC Midget
Assembly
Instructions
Match the shape and glue together.
Shaded areas in diagrams indicate reverse
side of parts.
MG TC Midget
Assembly
Instructions
*Note different numbers for left and right parts.
*Diagram is R.
*Note different numbers for left and right parts.
*Diagram is R.
Carefully shape curves.
Carefully shape curves.
*Right side
*Left side
Shaded areas in diagrams indicate reverse side of parts.
MG TC Midget
Assembly
Instructions
Shaded areas in diagrams indicate reverse side of parts.
Affix with glue.
Affix with glue.
Affix with glue.
MG TC Midget
Assembly
Instructions
Glue in order, - .
Affix with glue.
The shapes of the pasting margins of the left
and right are different. Use the differences to
decide the assembling locations.
Top
Top
Confirm top/bottom before gluing.
Confirm top/bottom before
gluing.
Carefully shape curves.
Shaded areas in diagrams indicate reverse side of parts.
Affix all four tires, adjusting to be sure
they touch the ground.
Joint should be positioned at the top.
Joint should be positioned at the top.
Arrow indicates 'up'.
Affix outer surface of tire like a bowl,
then wait until glue is dry before gently
pulling the tire into shape.
Pink flap indicates outer side.