Asidufoam MSDS

MATERIAL SAFETY DATA SHEET
Prepared: 09 January 2009
Section 1 Product and Company Identification

Product(s):
Asidufoam Foaming Bathroom Cleaner
Formula:
Part Number(s):
B337
33732, 33701, 33705, 33755
Company Name & Address:

805 E. Old 56 Hwy.
Olathe, KS 66061
800-443-9536 (8 a.m. 5 p.m. Weekdays, CDT)
Emergency Numbers:
IN CASE OF EMERGENCY, CALL Infotrac @ 1-800-535-5053, 24 hrs.

INTERNATIONAL EMERGENCY NUMBER 352-323-3500
Poison Control Center: 1-800-222-1222
Material Safety Data Sheets:
www.dymon.com
Section 2 Hazards Identification

WARNING. Causes eye and skin irritation. Harmful if inhaled. May be harmful if swallowed. May be absorbed through intact
skin.
Potential Health Effects
EYES:
Causes eye irritation.
SKIN:
Causes skin irritation.
INHALATION:
Harmful if inhaled.
INGESTION:
May be harmful if swallowed.
Signs/symptoms of exposure: redness, tearing or burning in eyes. Drying, redness or cracking of skin. Nose, throat, and airway
irritation. Stomach or intestinal upset including diarrhea and vomiting if swallowed. Medical conditions generally aggravated by
exposure: pre-existing skin, blood, liver or kidney conditions may be adversely affected. Follow good chemical hygiene
practices to avoid these hazards.
HMIS Rating
Health 2
Flammability 0
Reactivity 0
Personal Protection B
Section 3 Composition/Information on Ingredients

Ingredient
CAS Number
Percent Range
Water
7732-18-5
60 100
Cocamidopropyl Betaine
61789-40-0
37
Butoxydiglycol
112-34-5
15
Citric Acid
77-92-9
0.5 1.5
Lauramide Oxide
1643-20-5
0.5 1.5
Sulfamic Acid
5329-14-6
0.5 1.5
2-Butoxyethanol
111-76-2
0.5 1.5
Any substance listed as hazardous by the states of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or
Texas is described above if known present in regulated concentrations.
Section 4 First Aid Measures

EYES:
SKIN:
INHALATION:
Flush eyes with large amounts of water for at least 15 minutes while holding eyelids open. Seek medical
attention immediately.
Immediately flush with water for 15 minutes. Remove contaminated clothing and shoes. If irritation arises
and persists seek medical attention.
Move to fresh air. If breathing has stopped, qualified personnel should administer artificial respiration.
Page 1 of 3
Formula: B337
Page 2 of 3
INGESTION:
Do not induce vomiting, rinse out mouth with water. Call a physician or poison control center immediately.
Never give anything by mouth to an unconscious person.
Section 5 Fire Fighting Measures

Flashpoint (PMCC):
Extinguising Media:
Special Fire Fighting Procedures:
Hazardous Products of Combustion:
None
Not usually needed as product does not readily support combustion. Use
media appropriate for fires fuel source.
Keep containers cool and vapors down with water spray. Prevent runoff from
entering sewers and public waterways. Wear self-containted breathing
apparatus (SCBA) in chemical fires.
Oxides of carbon, sulfur dioxide, sulfur trioxide, ammonia and various organic
oxidation products.
Section 6 Accidental Release Measures

Small spill:
Large spill:
Caution slip hazard. Wipe up small releases with a dry absorbent cloth or other absorbent material.
Ventilate area and block traffic. Absorb liquid with vermiculite, absorbent cloth, or other absorbent material.
Prevent material from entering sewers and drains. Transfer contaminated material into suitable container for
proper disposal. Clean any slippery residues with suitable soap or detergent.
Section 7 Handling and Storage

Handling:
Storage:
Do not swallow. Do not get into eyes. Wash thoroughly after handling. Avoid contact with skin and clothing.
Avoid inhaling mists or vapors. Use only with adequate ventilation. Follow good chemical hygiene practices
when handling this material. Use from original container only and follow label directions carefully.
Keep out of reach of children. Do not contaminate water, food or feed by use or storage. Keep container
tightly sealed when not in use.
Section 8 Exposure Controls/Personal Protection

Engineering controls:
Exposure limits:
Eye protection:
Skin protection:
Respiratory protection:
Ventilation not usually necessary but should be provided in the event of overexposure.
Butoxydiglycol (CAS # 112-34-5) 50 ppm OSHA PEL (Skin designation); 25 ppm OSHA VPEL
(Skin designation); 20 ppm ACGIH; 35 ppm Dow Industrial Hygiene Guide
2-Butoxyethanol (CAS # 111-76-2) 50 ppm OSHA PEL; 25 ppm OSHA VPEL; 20 ppm ACGIH
Yes, wear approved safety glasses or goggles if direct contact is possible.
Yes, wear impervious gloves if direct contact is possible.
Not usually necessary. If vapors are present or irritation is experienced, use NIOSH/MSHA
approved respirator.
Section 9 Physical and Chemical Properties

Appearance and Odor: Light yellow liquid with a pine odor.
pH: 1.3
Boiling Point: 212 F
Vapor Density: >1
Solubility in Water: Complete
Volatile Organic Compounds (VOCs): 1.00 % by weight
Specific Gravity: 1.011

Viscosity: 2.5 cP
Section 10 Stability and Reactivity

Hazardous Polymerization:
Hazardous Decomposition or Byproducts:
Chemical Stability:
Incompatible Materials:
This product will not undergo hazardous polymerization.

Carbon monoxide, carbon dioxide, oxides of sulfur, ammonia and various
organic oxidation products.
Stable
Strong oxidizers and reducers, alkalis, reactive metals, and materials reactive
with hydroxyl compounds.
Section 11 Toxicological Information

Lauramide Oxide, CAS #1643-20-5
Oral LD50 >500-5000 mg/kg rat
Page 3 of 3
Formula: B337
Section 12 Ecological Information

No data.
Section 13 Disposal Considerations

Dispose of in accordance with all applicable local, state, and federal regulations.
Waste information: If this product becomes a waste, it would be a hazardous waste (D002) as defined by RCRA (40CFR261).
However the waste should be properly evaluated in case of modification prior to disposal.
Section 14 Transport Information

The following transportation information is based on Department of Transportation Regulations found in 49 CFR. If shipping this
product by air please refer to International Air Transport Association (IATA) Danger Goods Regulations. If shipping this product
by ocean please refer to International Maritime Dangerous Goods Regulations (IMDG). To find how to ship this product please
refer to the UN# listed below.
UN #
DOT Information
Quarts/Gallons
Bulk Material
None
UN 1760
Proper Shipping
Description
Hazard
Class
Consumer Commodity
ORM-D
Corrosive liquids, n.o.s., (Sulfamic acid, Citric acid)
8
Packing
Group
None
III
Marine Pollutants: None
Section 15 Regulatory Information

US Federal Regulations
Toxic Substances Control Act (TSCA): All ingredients are on the TSCA inventory or exempt from listing.
CERCLA RQ
None
SARA 313 Components
Butoxydiglycol (CAS #112-34-5) 2%
2-Butoxyethanol (CAS #111-762) 1%
State and Local Regulations
California Proposition 65
None
Section 16 Other Information

WARNING! The use of this product is beyond the control of the manufacturer; therefore, no guarantee, expressed or implied, is
made as to the effects of such or the results to be obtained if not used in accordance with directions or established safe practice.
The user must assume all responsibility, including injury or damage, resulting from its misuse as such, or in combination with
other materials. The manufacturer warrants only that this product meets the manufacturer's specifications for such product.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, AS TO DESCRIPTION, QUALITY,
MERCHANTABILITY. FITNESS FOR ANY PARTICULAR PURPOSE, PRODUCTIVENESS OR ANY OTHER MATTER, OF
THIS PRODUCT. THE MANUFACTURER SHALL BE IN NO WAY RESPONSIBLE FOR THE IMPROPER USE OF THIS
PRODUCT. The sole and exclusive remedy against the manufacturer for breach of warranty shall be reimbursement of the
purchase price of the product in the event that a defective condition of the product shall be found to exist. NO OTHER REMEDY
(INCLUDING BUT NOT LIMITED TO INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR INJURY TO PERSON OR
PROPERTY OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL LOSS) SHALL BE AVAILABLE.

Asidufoam MSDS

Uploaded by

Copyright:

Available Formats

Asidufoam MSDS

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Asidufoam MSDS

Uploaded by

Copyright:

Available Formats

MATERIAL SAFETY DATA SHEET

Prepared: 09 January 2009

Section 1 Product and Company Identification

Company Name & Address:

IN CASE OF EMERGENCY, CALL Infotrac @ 1-800-535-5053, 24 hrs.

Material Safety Data Sheets:

Section 2 Hazards Identification

Section 3 Composition/Information on Ingredients

Section 4 First Aid Measures

Section 5 Fire Fighting Measures

Section 6 Accidental Release Measures

Section 7 Handling and Storage

Section 8 Exposure Controls/Personal Protection

Section 9 Physical and Chemical Properties

Specific Gravity: 1.011

Section 10 Stability and Reactivity

This product will not undergo hazardous polymerization.

Section 11 Toxicological Information

Section 12 Ecological Information

Section 13 Disposal Considerations

Section 14 Transport Information

Marine Pollutants: None

Section 15 Regulatory Information

Section 16 Other Information

You might also like