Concure 90 PDF

Concure 90*
constructive solutions
High quality, resin based, concrete curing compound

Uses
Description
Provides a high efficiency, spray-applied curing compound,

to retain water within concrete for effective curing. It is suitable
for all common forms of concreting, and is of particular benefit
for large concrete areas, including :
Concure 90 concrete curing compound is resin based and is

supplied in various pigmented grades.
! Car park decks and ramps.

! Airport runways and hardstanding areas.
! Concrete tanks and reservoirs.
! Warehouses and unloading bays.
! Bridges
! Piers, jetties and harbours.
Advantages
! Improved curing of concrete enhances cement hydration
and provides a more durable concrete.
! Control of moisture loss improves surface quality,
reducing permeability, producing a hard wearing, dust
free surface and minimising potential for surface cracking
and shrinkage.
! Cost effective - Light reflective grades minimise solar
temperature gain.
! Economic - Spray application reduces labour costs and
eliminates the need for alternative curing systems.
Standards compliance
All grades of Concure 90 give 90% or greater curing efficiency
when tested to BS 7542 and comply with BS8110 Part 1,
clause 6.6.3(c), ASTM C309 and AASHTO M148. Concure 90
Aluminised, complies with DTp specification for Highway
Works, Cl. 1027.
Specification
Concure 90*
The high efficiency, curing compound shall be Concure 90, a

low viscosity, resin emulsion supplied by Fosroc. The curing
compound shall have a curing efficiency of at least 90% in
accordance with BS7542; shall comply with BS 8110; Part 1,
clause 6.6.3(c), ASTM C309 and AASHTO M148.
Clear - straw liquid, drying to a clear film

Green - As clear grade but with green fugitive
White - Silver liquid drying to a silver film
When first applied to a fresh cementitious surface the product
forms a continous, non-penetrating coating. This coating
dries to form a continuous film which provides a barrier to
moisture loss ensuring more efficient cement hydration,
improved durability and reduced shrinkage.
The white and aluminised grades contain pigments based
on tiatnium di-oxide and aluminimum flake respectively to
meet specifications requiring such pigmentation for reduction
of solar temperature gain.
Properties
Form
Curing efficiency
:
:
Liquid - white or clear

90% (BS 7542)
Instructions for use

Pre-application
Concure 90 pigmented grades should be gently stirred
immediately before use, to ensure even dispersal of the
pigment.
Application should not begin until the concrete is free from
surface water, and should not commence at all if bleed water
is apparent on the concrete surface.
Application
Concure 90 should be applied by spray, with the spray nozzle
being held approximately 450mm from the concrete surface.
Application should pass back and forth to ensure complete
coverage, and pump pressure maintained to give an even,
fine spray.
After spraying, no further application of water or other material
is necessary to ensure continued curing. The concrete surface
should not be disturbed until it has sufficient strength to bear
surface loads.The applied film should not be trafficked until
fully dry, and care should be taken to ensure that the film is
not broken.
Concure 90*
Concure 90 may also be applied to newly hardened concrete
immediately after demoulding, which should be damp, not
dry. Surfaces which are dry will lead to problematic absorption
of the membrane, preventing proper film formation and
causing removal difficulties at a later date.
Estimating
Supply
Concure 90
Fosroc Solvent 102
:
:
200 litre packs

5 litre packs
Coverage
Equipment
Cleaning
Coverage figures quoted for Concure 90 are indicative; and

based upon application to fresh or damp concrete at the
appropriate time. Care should be taken to ensure that the
concrete is indeed ready to accept the curing membrane.
Spray equipment should be cleaned immediately after use by

flushing through with water. Any residual traces of resin which
are left in the nozzle may be cleaned with Fosroc Solvent 102*.
Application rates outside the range given below may be used

if necessary, but it is recommended to first contact your local
Fosroc office.
Motorised or knapsack spray equipment, which produces a

fine spray, is recommended for use with Concure 90.
Overcoating and removal
Concure 90
Concure 90 must be removed from concrete substrates before

subsequent coating works commence, to promote proper bond
between the concrete and the applied coating. Although the
membrane will be slowly removed by normal trafficking and
UV exposure, this is likely to be inconsistent. To ensure
complete removal use high pressure steam or water blasting,
or light sand blasting.
Limitations
-
Concure 90 should only be re-circulated using a low shear

diaphragm pump.
Concure 90 should not be applied onto dry surfaces, which

may lead to absorption and staining which will be difficult
to remove at a later date.
Any concrete surfaces which receive treatment with

Concure 90 should not be disturbed until the concrete has
gained sufficient strength to bear surface loading.
3.5 to 5.0 m2/litre
Storage
When stored in warehouse conditions below 35C, Concure 90
has a minimum shelf life of 12 months for the clear version,
and 6 months for the pigmented.
Freezing and exposure to heat and/or direct sunlight should
be avoided.
Containers should be kept sealed and airtight to prevent any
reduction in shelf life.
Technical support
Fosroc offers a comprehensive technical support service to
specifiers, end users and contractors. It is also able to offer
on-site technical assistance, an AutoCAD facility and dedicated
specification assistance in locations all over the world.
Concure 90 - Page 2 of 4
Concure 90*
Precautions
Health and safety
Concure 90 does not fall into the hazardous classifications of
current regulations. However, it should not be swallowed or
allowed to come into contact with skin or eyes, in either spray
or bulk form.
Suitable protective gloves and goggles should be worn at all
times.
Splashes on the skin should be removed with water. In case of
contact with eyes, rinse immediately with plenty of water and
seek medical advice. If swallowed seek medical attention
immediately - do not induce vomiting.
For further information, please consult the Material Safety Data
Sheet for this product.
Fire
Concure 90 is non-flammable.
Cleaning and disposal
Spillages of Concure 90 should be absorbed onto sand, earth
or vermiculite and transferred to suitable containers. Remnants
should be hosed down with large quantities of water.
The disposal of excess or waste material should be carried
out in accordance with local legislation, under the guidance of
the local waste regulatory authority.
Concure 90 - Page 3 of 4
Concure 90*
Additional Information
Fosroc manufactures a wide range of complementary
products which include :
! waterproofing membranes & waterstops
! joint sealants & filler boards
! cementitious & epoxy grouts
! specialised flooring materials
Fosroc additionally offers a comprehensive package of
products specifically designed for the repair and
refurbishment of damaged concrete. Fosrocs Systematic
Approach to concrete repair features the following :
! hand-placed repair mortars
! spray grade repair mortars
! fluid micro-concretes
! chemically resistant epoxy mortars
! anti-carbonation/anti-chloride protective coatings
! chemical and abrasion resistant coatings
For further information on any of the above, please consult
your local Fosroc office - as below.
* Denotes the trademark of Fosroc International Limited
See separate data sheet
Important note
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard
Conditions for the Supply of Goods and Service. All Fosroc datasheets are updated on a regular basis. It is the users
responsibility to obtain the recent version. Refer to www.fosroc.com.
Al Gurg Fosroc
LLC
Post Box 657, Dubai
United Arab Emirates
www.fosroc.com
Head Office
telephone: (+9714) 2039699
fax: (+9714) 2859649
email: agf@fosroc.com
Regional offices
Abu Dhabi, Al Gurg Fosroc
Bahrain, YBA Kanoo
telephone: 673 1779

telephone: 17735454
fax: 673 1449

fax: 17732828
email: abudhabi@fosroc.com
email: bahrain@fosroc.com
Kuwait, Boodai
Oman, Al Amana
Qatar, Tadmur
telephone: 4817618
telephone: 24815080
telephone: 4500607
fax: 4832124
fax: 24817554
fax: 4500543
email: kuwait@fosroc.com
email: oman@fosroc.com
email: qatar@fosroc.com
UAE/0532/04/A

Concure 90 PDF

Uploaded by

Copyright:

Available Formats

Concure 90 PDF

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Concure 90 PDF

Uploaded by

Copyright:

Available Formats

Concure 90*

High quality, resin based, concrete curing compound

Provides a high efficiency, spray-applied curing compound,

Concure 90 concrete curing compound is resin based and is

! Car park decks and ramps.

The high efficiency, curing compound shall be Concure 90, a

Clear - straw liquid, drying to a clear film

Liquid - white or clear

Instructions for use

200 litre packs

Coverage figures quoted for Concure 90 are indicative; and

Spray equipment should be cleaned immediately after use by

Application rates outside the range given below may be used

Motorised or knapsack spray equipment, which produces a

Overcoating and removal

Concure 90 must be removed from concrete substrates before

Concure 90 should only be re-circulated using a low shear

Concure 90 should not be applied onto dry surfaces, which

Any concrete surfaces which receive treatment with

3.5 to 5.0 m2/litre

* Denotes the trademark of Fosroc International Limited

See separate data sheet

fax: (+9714) 2859649

telephone: 673 1779

fax: 673 1449

You might also like