Propeller Shaft
Propeller Shaft
Propeller Shaft
PROPELLER SHAFT
PROPELLER SHAFT
PR2
PROPELLER SHAFT
Precaution
PRECAUTION
Be careful not to grip the propeller shaft tube too tightly in
the vise as this will cause deformation.
TROUBLESHOOTING
Problem
Possible cause
Remedy
Page
Noise
PR4
PR4
PR9
Vibration
Replace shafts
Balance propeller shafts
Replace front flange
Replace rear flange
Replace cross groove joint
Replace bushing
PR4
PR7
PR6
PR8
PR4
PR3
PROPELLER SHAFT
Propeller Shaft
PROPELLER SHAFT
COMPONENTS
PR4
PROPELLER SHAFT
Propeller Shaft
PR5
PROPELLER SHAFT
Propeller Shaft
PR6
PROPELLER SHAFT
Propeller Shaft
(b) Using SST to hold the front flange, remove the nut
and plate washer.
SST 0933000021
PR7
PROPELLER SHAFT
Propeller Shaft
(b) Using SST to hold the flange, remove the nut and plate
washer.
SST 0933000021
PR8
PROPELLER SHAFT
Propeller Shaft
PR9
PROPELLER SHAFT
Propeller Shaft
(e) Using SST, extension bar and press, remove the cross
groove joint.
SST 0952721011
(f) Remove the joint end cover gasket.
PR10
PROPELLER SHAFT
Propeller Shaft
(b) Clamp the bearing outer race in a vise and tap off the
shaft with a hammer.
HINT: Remove the bearing on the opposite side in the
same procedure.
(e) Clamp the bearing outer race in a vise and tap off the
yoke with a hammer.
HINT: Remove the bearing on the opposite side in the
same procedure.
PR11
PROPELLER SHAFT
Propeller Shaft
Thickness
mm (in.)
PR12
PROPELLER SHAFT
Propeller Shaft
(d) Using SST to hold the flange, press the bearing into
position by tightening down a new nut and washer.
SST 0933000021
Torque: 181 Nm (1,850 kgfcm, 134 ftlbf)
PR13
PROPELLER SHAFT
Propeller Shaft
PR14
PROPELLER SHAFT
Propeller Shaft
(b) Apply the adhesive tape from the top of shaft to the
spline to prevent damaging the boot.
(c) Install the universal joint cover with boot to the shaft.
(b) Using a hammer and brass bar, tap the cross groove
joint.
HINT: Be sure to put the brass bar on the inner race.
(c) Using snap ring pliers, install the new snap ring.
PR15
PROPELLER SHAFT
Propeller Shaft
(d) Pass the bolt through to align the both bolt holes, then
using a press and steel plate, press the universal joint
cover with boot.
PR16
PROPELLER SHAFT
Propeller Shaft
PR17
PROPELLER SHAFT
Propeller Shaft